ページ1に含まれる内容の要旨
Parallel
SCSI/ HP-PB 28655A HP
SCSI HP-PB 28642A HP
ページ2に含まれる内容の要旨
El091 5960-3126 HP HP
ページ3に含まれる内容の要旨
of to not of for a for or for or or of infommticm, of or of inform&m to 1, 1991 for If to to A a A a not a or a I a from to cord, or cord cord or -1. 95678 CA Roseville, Division, Networks Roseville Company Hewlett-Packard service-trained autborizcd by only performed be must repair maintenance. adjustment. servicing, Any servkblg: restored. been has ground the until power the dionuect impaired, been has Protection the that likely is il Whenever set. power supplied power t
ページ4に含まれる内容の要旨
HP28642A HP-PB SCSI 28655A HP-PB SCSI/Parallel HP S&vice and Installation
ページ5に含まれる内容の要旨
28642A and 28655A Glance off. SW1 2 systems. XL MPE on supported not port, Parallel - K on. normally (green), LED Power Term J- fuse. power Termination I- switches, four of pack Switch - H connector. backplane HP-PB - G U52. location socket PROM, F- (SIPS). packages in-line single resistors, termination bus SCSI - E signals. single-ended connector, high-density SO-pin port, SCSI - D normally (yellow), LED Fail Self-Test - C screw. (captive) Retaining - B lever. Extractor A- a at H
ページ6に含まれる内容の要旨
l l n n n n (5061-6565) signals SCSI single-ended hood, Loopback (5062-3336) divider slot HP-PB blade flat 3/164nch or T-10 Torx Screwdriver, Supplied Not Accessories and Tools (5960-3126) Manual Service and Znstallation This m (51804010) meter 2 cable, port Parallel m (5062-3383) meter 1 cable, port SCSI m (1252-3920) terminator external bus SCSI n (2865560001) card adapter SCWparaIlel HP28655A systems. XL MPE on use for supported not is port parallel The *Note: (5960-3126) Man
ページ7に含まれる内容の要旨
Book n We 4 installation. the complete to manuals periphera1 and system computer your have you that assume only. card adapter the of installation to limited is manual This information. service general or procedures test for chapter this to refer card, your with problems have you If specifications. technical as well as information service contains 2 Chapter product. this install to follow should you that steps the detail, in describes, It instructions. installation provides 1 Chapter f
ページ8に含まれる内容の要旨
Contents Off 5 ................................... VerifyOperation 8. l-28 ................................. Systems XL MPE 1-27 HP-UXSystems .................................. 1-27 System Operating the Up Set 7. ............................ l-27 Computer the to Then Peripherals, to On Power Turn 6. l-26 .............. Computer Your Reassemble ........................... l-23 Applicable if Device, Parallel Your Connect 1-23 .................. ........................ Example
ページ9に含まれる内容の要旨
6 Index Glossary Specifications Technical 2-15 ................................. Guidelines Reshipment 2-14 ................................. Fuse Power Termination 2-12 ............................ SIPS Termination and PROM 2-11 ........................ Components Card of Removal/Replacement 2-11 .................. Card the of Removal/Replacement 2-10 ....................... Instructions Removal/Replacement 2-9 .......................... Checklist Troubleshooting 2-7 ....
ページ10に含まれる内容の要旨
Installing 28642A/28655A Adapter HP the 1
ページ11に含まれる内容の要旨
lnstalllng 28642A/28655A Adapter Off not Adapter the Installing 1-2 Adapter SCSI/Parallel the of Use Typical l-l. Figure XL) MPE witi supported is Backpla HP-PB with Computer PA-RISC HP drives) disk as (such Devices SCSI Operation. Verify 8. System. Operating the Up Set 7. Computer. the to Then Peripherals, to On Power Turn 6. Device(s). Peripheral Your Connect 5. Card. the Connect and Install 4. Configuration. Hardware Card’s the Check 3. Computer. the Switch and System the Dow
ページ12に含まれる内容の要旨
Prepare Adapter Card Observe n We n l l l l l-3 Adapter the Installing systems. XL MPE on supported not is port parallel The XXX. HP with supplied not is cable port Parallel 5960-3126 manual Service and Znsfaliution meter’ 2 cable, port Parallel m 5180-0010 meter 1 cable, port SCSI 5062-3383 1252-3920 terminator SCSI External 28655-60001 card adapter SCSI/parallel product: the with supplied items a11 identify and Unpack Contents Product Verify charge. static any equalize. to
ページ13に含まれる内容の要旨
n l Accessories n Adapter the Installing 1-4 below. described cables, SCSI m below. described (5062-3336), divider Slot blade. flat 3/164nch or T-10 Torx Screwdriver, D installation: card for needed be may items following The cage. card I/O the access to needed accessories or tools special any for model computer particular your for manuals installation hardware the Check Needed and Tools Gather obtain. to diflicult more be will information this installed, is card the Once reference.
ページ14に含まれる内容の要旨
1-5 Adapter the Installing connectors. bail-lock female-to-male low-density, 50-pin, 92222C 92222B Peripheral ends. both on bail-lock 92222A to Peripheral with connectors male low-density, 50-pin, bail-lock. with connector male low-density 50-pin and adapter), host (to thumbscrews with connector male high-density, SO-pin, (meters) Description Lengths Cables SCSI l-l. Table OMice. Support and Sales HP nearest the consult or guides, configuration system your to refer information, re
ページ15に含まれる内容の要旨
Shut System and Computer off. Adapter the Installing l-6 corruption, data or damage hardware in result may or hazard, personnel a create may power remove and system the down shut properly to failure manuals, system computer your in noted otherwise Unless WARNING source. power the from cord power the Unplug is computer host the to power that Ensure 2. data. of loss or corruption avoid to procedures shutdown proper for manuals system computer your 1. Consult down. shut is system operat
ページ16に含まれる内容の要旨
Check Card’s Configuration n 1-7 Adapter the Installing Resistors Termination and Switches I-3. Figure bus. SCSI the of end one terminating for packs resistor contains card the addition, In 7. is address bus SCSI = and enabled, is parity-checking in: rcsllting open”, switches “all are settings switch default The card. the of address bus SCSI the and capability parity-checking the setting for switches contains adapter SCSI/parallel The installed. properly are packs resistor that Verify
ページ17に含まれる内容の要旨
4 7 3,2,1, Adapter the Installing l-8 Settings Switch Default l-4. Figure Open) is (Switches = Default Address, Bus SCSI Open) is [Switch Enabled = Default Parity-Checking, parity-checking. deactivate will position “closed” The position. “open” the in 4 switch with is, that enabled”, “parity-checking is setting factory the 1-4, figure in shown As purpose. this for needed be may card adapter SCSI additional An device. that for bus SCSI separate a add must you bus, the on devices oth
ページ18に含まれる内容の要旨
l-9 Adapter the Installing “open” = 1 “closed” = 0 (Defauh) 7 1 1 1 6 0 1 1 1 5 1 0 4 0 0 1 0 3 1 1 2 0 1 0 1 1 0 0 0 0 0 0 3 1 2 Address 1 Bus SCSI Switch PositIons Switch Address SCSI 1-2. Table address. different a have bus the on devices all sure Be addresses. possible other for positions switch shows l-2 Table address. bus SCSI adapter’s the for choice best the is “7” applications, most For l-4. figure in shown as position) “open” the in is, that “l”, to set each are 1
ページ19に含まれる内容の要旨
Adapter the installing l-10 Orientation Pack Resistor Proper l-5. Figure Resistors, Termination 1-5. figure in shown as oriented be should and end one on dot a with marked are packs resistor The orientation. proper the with installed are packs resistor two the that verify Visuaily installed. be must packs resistor two Note The bus. SCSI a of end the on only use for supported is port SCSI The bus. SCSI the of end one for terminator a as act packs resistor These card. the on sockets in m
ページ20に含まれる内容の要旨
and Connect Card l 1 l-l Adapter the installing connections. improper prevent to designed are connectors HP-PB The cardcage. the into card If0 an of orientation Proper m access. gain to manuals reference hardware or installation computer your to refer accessible, readily not are slots I/O computer’s your If slots. the expose to panels or covers various remove to need may You slots. card l/O computer’s your to access gain to How model: computer particular your for information following t
