Siemens PAPBHの取扱説明書

ページ1に含まれる内容の要旨

Bulletin No. PAPBH-X
Drawing No. LP0525
Effective 6/01
Tel +1 (717) 767-6511
Fax +1 (717) 764-0839
www.redlion-controls.com
MODEL PAPBH - PARADIGM PROFIBUS HOST ADAPTER
!
2 RS232 PORTS (FOR HMI AND PC)
!
PROVIDES ACCESS TO PROFIBUS NETWORK THRU DB9
CONNECTOR
!
EASILY CONFIGURED USING EDICT97
!
BASE OR DIN RAIL (OPTIONAL) MOUNTING
!
STATUS LEDs
!
FIELDBUS TYPE : PROFIBUS-DP EN 50 170, IMPLEMENTED
USING SIEMENS SPC3 ASIC
!
AUTOMATIC BAUD RATE DETECTION IN THE RANGE
9.6 KBAUD – 12 MBAUD
!
STATI

ページ2に含まれる内容の要旨

6. CERTIFICATIONS AND COMPLIANCES: WIRING AND CONNECTIONS SAFETY POWER SUPPLY REQUIREMENTS IEC 1010-1, EN 61010-1: Safety requirements for electrical equipment for The Operator Interface requires an 11 to 30 VDC power supply rated at measurement, control, and laboratory use, Part 1. 2.25 W unless otherwise stated on the label. ELECTROMAGNETIC COMPATIBILITY ! The terminal may take as little as 100 mA in certain circumstances, so be Immunity to EN 50082-2 sure that the chosen power supply can ope

ページ3に含まれる内容の要旨

INSTALLATION ENVIRONMENT The unit should be installed in a location that does not exceed the maximum MOUNTING operating temperature and provides good air circulation. Placing the unit near The PAPBH can be base mounted or installed using the optional DIN rail devices that generate excessive heat should be avoided. mounting kit. DIN RAIL MOUNTING PANEL MOUNTING APPLICATION This drawing shows a typical PROFIBUS Application. 3

ページ4に含まれる内容の要旨

PROFIBUS NETWORK DRIVER APPLICATION NOTE Introduction The PAPBH is a gateway that allows a Paradigm Operator Interface access to a PROFIBUS-DP Network. The Host Adapter is connected to the Operator Interface programming port allowing data transfer with Internal Communications Blocks. The PAPBH is auto-configuring for all PROFIBUS properties such as baud rate, but needs a Station Address configured by the Operator Interface. These are set up using the PROFIBUS Network Driver described here. Confi