ページ1に含まれる内容の要旨
HP 400 Workstation
Maintenance and Service Guide
ページ2に含まれる内容の要旨
Copyright Information Warranty Trademark Credits © Copyright 2009 Hewlett-Packard Hewlett-Packard Company shall not be liable Microsoft, Windows, and XP are U.S. Development Company, L.P. for technical or editorial errors or omissions registered trademarks of Microsoft contained herein or for incidental or Corporation in the U.S. and other countries. consequential damages in connection with Intel is a trademark of Intel Corporation in the the furnishing, performance, or use of this U.S. and othe
ページ3に含まれる内容の要旨
About this guide This guide provides service and maintenance information for the HP 400 Workstation. It includes these topics: Guide topics Product overview on page 1 Setting up the operating system on page 16 Restoring the operating system on page 22 System management on page 28 Replacing components on page 58 Diagnostics and troubleshooting on page 108 Configuring RAID devices on page 145 Configuring password security and resetting CMOS on page 154 Connector pins on page 159 System board desig
ページ4に含まれる内容の要旨
iv About this guide ENWW
ページ5に含まれる内容の要旨
Table of contents 1 Product overview Product features ................................................................................................................................... 1 System board architecture ................................................................................................... 1 Processor technology .......................................................................................... 2 Memory technology ...................................................
ページ6に含まれる内容の要旨
Installing and customizing Red Hat-enabled workstations ................................................ 19 Verifying hardware compatibility ....................................................................... 19 Setting up Novell SLED ...................................................................................................................... 19 Updating the workstation ..................................................................................................................
ページ7に含まれる内容の要旨
Subscriber's Choice ........................................................................................................... 44 ROM Flash ......................................................................................................................... 45 Remote ROM Flash .......................................................................................... 45 HPQFlash .......................................................................................................... 45 Fail
ページ8に含まれる内容の要旨
Cables and connectors ..................................................................................... 63 Hard disk drives ................................................................................................ 64 Lithium coin cell battery ..................................................................................... 64 Customer self-repair ........................................................................................................................... 64 Removing
ページ9に含まれる内容の要旨
BIOS errors and warnings ................................................................................. 86 Removing a DIMM ............................................................................................ 87 Installing a DIMM .............................................................................................. 88 Expansion card slot identification ...................................................................................... 90 Slot identification and description .
ページ10に含まれる内容の要旨
Customer Advisories, Customer and Security Bulletins, and Customer Notices ............................................................................................................ 115 Product Change Notifications .......................................................................... 115 Helpful hints ..................................................................................................................... 115 At startup .........................................................
ページ11に含まれる内容の要旨
SAS RAID 1E configuration ............................................................................................. 153 8 Configuring password security and resetting CMOS Preparing to configure passwords .................................................................................................... 155 Resetting the password jumper ........................................................................................................ 156 Clearing and Resetting the CMOS ...............
ページ12に含まれる内容の要旨
xii ENWW
ページ13に含まれる内容の要旨
1 Product overview This chapter presents an overview of the hardware components of the workstation. It includes these topics: Topics Product features on page 1 Workstation specifications on page 7 Product features The following sections describe the workstation system board architecture and components, and includes these topics: Topics System board architecture on page 1 Workstation components on page 4 System board architecture This section describes the workstation system architecture. ENWW Pr
ページ14に含まれる内容の要旨
The following figure shows the typical workstation system board block diagram. Figure 1-1 System board block diagram NOTE: The x1, x4, x8, and x16 designators describe the number of electrical PCIe lanes routed to an expansion slot. For example, x16(8) means that the expansion slot is mechanically a x16 length connector, with eight PCIe lanes connected. Processor technology This workstation uses the Intel® X58 Express chipset to support the latest Quad Core Intel® Xeon™ processor W3500 Series,
ページ15に含まれる内容の要旨
Expansion card slots The workstation implements one Intel X58 I/O chip to provide a total of six high-performance graphics and I/O slots. In addition to the two full x16 PCIe Gen2 slots, two additional PCIe x8 (4) slots (x8 mechanically, x4 electrically) provide extra I/O bandwidth for high speed I/O cards. Open ended PCIe x8 connectors allow the user to install x16 physical size cards in the x8 (4) slots. Serial Attached SCSI (SAS) drives are supported via a plug-in card. Additional features Re
ページ16に含まれる内容の要旨
Workstation components This section describes workstation components, including front and rear panel components. For complete and current information on supported accessories and components for the workstation, see http://partsurfer.hp.com. Chassis components The following image shows the components of a typical workstation configuration. Drive configurations can vary. Figure 1-2 Workstation components Table 1-1 Workstation component descriptions Item Description Item Description 1 Power suppl
ページ17に含まれる内容の要旨
Front panel components The following figure shows the front panel of a typical workstation configuration. Figure 1-3 Front panel Table 1-2 Front panel connectors Item Symbol Description Item Symbol Description 1 Optical drive manual eject 6 Headphone connector 2 Optical drive eject button 7 Microphone connector 3 Power button 8 1394a connector (optional and plugged unless configured) 4 Hard drive activity light 9 Optical drive activity light 5 USB 2.0 ports (2) 10 Optical drive ENWW Product fe
ページ18に含まれる内容の要旨
Rear panel components The following figure shows the rear panel of a typical workstation configuration. Figure 1-4 Rear panel NOTE: The rear panel connectors are labeled with industry-standard icons and colors to assist in connecting peripheral devices. Table 1-3 Rear panel connectors Item Symbol Description Item Symbol Description 1 Power supply Built-In Self Test (BIST) 8 Padlock loop LED 2 Universal chassis clamp opening 9 Graphics card connector 3 PS/2 mouse connector (green) 10 Audio line
ページ19に含まれる内容の要旨
Workstation specifications This section provides workstation chassis, power supply, and environmental specifications. Physical characteristics The following table lists the workstation physical characteristics. Weight (Typical configuration) 13.5-19.6 kg (29.8-43.2 lb.) Chassis Dimensions Height: 45.0 cm (17.7 in.) Width: 17.0 cm (6.7 in.) Depth: 44.5 cm (17.5 in.) Power supply description The workstation includes a 475-W 85% efficient power supply to provide power for the workstation. The power
ページ20に含まれる内容の要旨
Power supply currents Table 1-5 Maximum current per rail Voltage rail 475W maximum continuous current +12 V-CPU 17.5A +12 V-B 17.5A +12 V-D 18.0A V12N 0.30A +5 V-SB 2.25A 3.3V 15.0A 5.1V 21.0A CAUTION: Do not exceed 475 watts of total continuous output power. Maximum combined power on 3.3V and 5.1V is 110W. Maximum combined current on +12V(CPU,B,D) is 38A. 8 Chapter 1 Product overview ENWW
