ページ1に含まれる内容の要旨
EPN3600 IP PTZ Speed Dome
User’s Manual
Copyright © EverFocus Electronics Corp,
Release: July 2009
ページ2に含まれる内容の要旨
EPN3600 Product Name: EPN Series EverFocus Network Speed Dome FCC Notice "Declaration of Conformity Information" This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential Installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with t
ページ3に含まれる内容の要旨
EPN3600 About this document All the safety and operating instructions should be read and followed before the unit is operated. This manual should be retained for future reference. The information in this manual was current when published. The manufacturer reserves the right to revise and improve its products. All specifications are therefore subject to change without notice. Safety Notice -These limits are designed to provide reasonable protection. This equipment generates, uses and
ページ4に含まれる内容の要旨
EPN3600 body. Use a dry cloth to clean the appliance when it is dirty. When the dirt is hard to remove, use a mild detergent and wipe gently. Do not operate the appliance beyond its specified temperature, humidity or power source ratings. Do not use the appliance in an extreme environment where high temperature or high humidity exists. Use the appliance at temperature within 0℃ ~ +40℃ / 32 ~ 104 and a humidity below 90%. The input power source for this appliance is 12 VDC & PoE.
ページ5に含まれる内容の要旨
EPN3600 TABLE OF CONTENTS 1. INTRODUCTION.................................................................................................7 1.1. FEATURE .....................................................................................................7 1.2 ACCESSING THE CAMERA MENU ..............................................................9 2. SETTING ............................................................................................................16 2.1 SYSTEM INFO.....
ページ6に含まれる内容の要旨
EPN3600 2.4.2.3.2 OSD/AREAS ..............................................................................56 2.4.2.3.2.1 Areas ........................................................................................57 2.4.2.3.2.2 Directions.................................................................................59 2.4.2.3.2.3 Display .....................................................................................60 2.4.2.3.3 PRIVATE ZONES .....................................
ページ7に含まれる内容の要旨
EPN3600 1. INTRODUCTION The innovative EPN Series from EverFocus is a high performance multi stream H.264 IP speed dome featuring intelligent auto tracking functions. EPN is built-in H.264/MPEG-4/MJPEG digital signal output at 4CIF image size with up to 30fps and H.264/MPEG-4/MJPEG multi stream output for simultaneous live monitoring and high resolution recording. EPN also supports smart auto tracking functions such as exclusive masking, pan/tilt limits, tracking on patrol and flexibl
ページ8に含まれる内容の要旨
EPN3600 Excellent position accuracy to ±0.1 degree From super low [0.01°/sec] to high fast [360°/sec] pan/tilt speed IP66 rated housing for any-weather outdoor use Maximum 192 preset positions available Support directional virtual compass for easy operation. Users can select any reference direction as North Point. Programmable auto pan / 16 tours / 4 patterns 4 priority alarm inputs & 2 alarm outputs Smart alarm reaction & resume after alarm Enhanced auto-resume & power-up f
ページ9に含まれる内容の要旨
EPN3600 1.2 ACCESSING THE CAMERA MENU Step 1.Start an Internet Explorer browser. Step 2. Enter the IP address or host name of the camera in the Location/Address field of your Internet Explorer browser. (Please refer to EPN2700/3100/3600 Installation Guide for how to find the IP address) Step 3. Input “Username” and “Password”. Default Username is “user1” and default password is “11111111”. Step 4. Click “Login” button. Step 5. You might be required to download Active X, which is requ
ページ10に含まれる内容の要旨
EPN3600 2 ○ Press button to display the "Live" page. Double click on the image to show a full screen display, double click again or press ESC to return normal display. 3 ○ Press button to enter Setting page. In Setting page, there are 8 sections: [System Info], [User Config], [Network], [Video], [Audio], [User], [Event] and [System]. Please refer to “2 SETTING” for further information. 4 ○ Press button to close EPN2700/3100/3600 network page. 5 ○ Video Stream Select
ページ11に含まれる内容の要旨
EPN3600 where the image file is saved can be specified in “Setting -> User’s Config”. Please refer to “2.2 USER CONFIG” for further information. Note: Record segment is limited to 1 min. If you need to do long time recording, please set schedule recording. For schedule recording info, please see “2.7 EVENT”. 8 ○ Snapshot Click Snapshot button to save a snapshot of the video image currently being displayed. The location where the snapshot data is saved can be specified in “Settin
ページ12に含まれる内容の要旨
EPN3600 Figure 1-2 PTZ Control Window : Zoom in : Zoom out : Focus far Focus near : Iris + : Iris – Arrow buttons: Click on an arrow button to navigate in that direction. : stop current action. : User can select PTZ speed from High, Standard, Low and Minimum. 12
ページ13に含まれる内容の要旨
EPN3600 Preset button: Click this button first, and input a preset position number by clicking number key and then click “Go” button to move the camera to a preset location. Note: To use this function, user need to set preset location in advance. Please refer to 2.4.2.1.1 Set Preset” for setting details. Auto Pan button: Click this button first and input a preset auto pan No. by clicking number key (1 for AB Pan, 2 for Endless Pan) and then click “Go” button to run a preset auto
ページ14に含まれる内容の要旨
EPN3600 button to run a preset tour with auto-tracking function ON. Number button, Go button and Clear button: - Click desire number button and it will show in the gray text area at left-down corner. - Click “Clear” button to clear the text area. - Click “Go” button to run a selected function. 12 ○ PTZ Control – Navigation Mode Select this to browse in direction user pointing at. 13 ○ PTZ Control – Click-n-Go Mode Select this and system will center the pointing location
ページ15に含まれる内容の要旨
EPN3600 17 ○ Manual Control – Reset Alarm Press “Reset Alarm” button to reset alarm output remotely. 18 ○ Status Display Show the name of the camera whose settings currently being configured, current date/time and current frame rate. 19 ○ Event signals Tracking Alarm Motion When an alarm or motion event is triggered, a signal icon will flash to alert user. The first icon is for alarm event and rest of the 5 icons are for motion event. The motion event icons which differe
ページ16に含まれる内容の要旨
EPN3600 2. SETTING Click Setting button (see red marker in Figure 2-1) to enter the setting menu (see Figure 2-2). There are 9 sections in setup menu: [System Info], [User Config], [Network], [Video], [Audio], [User], [Event], [System] and [EKB200]. Figure 2-1 Camera Menu- Setting 2.1 SYSTEM INFO System information and system log check of the setup menu can be performed on this page. The “System Info” page has 2 tabs: [Information] tab and the [Log] tab. See Figure 2-2. 2.1.
ページ17に含まれる内容の要旨
EPN3600 Figure 2-2 System Info - Information 2.1.2 Log Figure 2-3 System Info -Log System Log: Date/Time: display date and time of the log. Log message: contain all information and event message, including login, 17
ページ18に含まれる内容の要旨
EPN3600 user’s IP, reboot, firmware upgrade, load factory default, configuration reset and event detected. System will keep the newest 256 records. Click button to export system log into a “.txt” file and select the location where the exported log file will be saved to. 2.2 USER CONFIG Figure 2-4 User Config User can set configuration of live view here. Each login user can make his/her own settings for the following items: Text Setting Check boxes of Machine name,
ページ19に含まれる内容の要旨
EPN3600 Position: Select the position where the text will be displayed from Upper Left / Lower Right / Lower Left. Click Apply to apply the setting changes or Reset to reset without saving the change. Date/Time Format Used in Text Select Date/Time Format from the following options: Time Format: 24 Hours or 12 Hours. Click Apply to apply the setting changes or Reset to reset without saving the change. Recording/Snapshot Export Setting Enable Event Recording to PC:
ページ20に含まれる内容の要旨
EPN3600 the change. Language Setting Language: Select the language to be displayed in web page. Default language is English. To add a new language not listed in the original configuration, click the Browse button to locate the new language file (.evb) and then click the Load button. Note: Upload a new language file will cause system reboot automatically. Please reconnect IP speed dome after reboot. Click Apply to apply the setting changes or Reset to reset without saving the c
