ページ1に含まれる内容の要旨
FM/AM RECEIVER
R-SE9T
CD PLAYER
DP-SE9
CASSETTE TAPE DECK
X-SE9
INSTRUCTION MANUAL
KENWOOD CORPORATION
COMPACT
DIGITAL AUDIO
DT
B60-3715-00 JA (T) AP WS AP
98/12 11 10 9 8 7 6 5 4 3 2 1 97/12 11 10 9 8 7 6 5
ページ2に含まれる内容の要旨
2 Before applying power Before applying power Caution : Read this page carefully to ensure safe operation. R-SE9T/DP-SE9/X-SE9 (En) Units are designed for operation as follows. Europe and U.K. ................................................. AC 230 V only U.S.A. and Canada ............................................ AC 120 V only For the United Kingdom Factory fitted moulded mains plug The marking of products using lasers (Except for some areas) 1.The mains plug contains a fuse. For replaceme
ページ3に含まれる内容の要旨
Preparation section Basic section Application section Knowledge sections Caution : Read the pages marked carefully to ensure safe operation. 3 Before applying power R-SE9T/DP-SE9/X-SE9 (En) Contents Preparation section Application section Before applying power ................................................. 2 Playback of CD ............................................................. 31 Safety precautions .............................................................. 2 Listening in the desir
ページ4に含まれる内容の要旨
Caution : Read this page carefully to ensure safe 4 Before applying power operation. R-SE9T/DP-SE9/X-SE9 (En) IMPORTANT SAFEGUARDS Please read all of the safety and operating instructions before operating this appliance. Adhere to all warnings on the appliance and in the instruction manual. Follow all the safety and operating instructions. These safety and operating instructions should be retained for future reference. 1. Power sources – The appliance should be connected 7. Heat – The appliance
ページ5に含まれる内容の要旨
Preparation section Basic section Application section Knowledge sections Caution : Read this page carefully to ensure safe 5 Before applying power operation. R-SE9T/DP-SE9/X-SE9 (En) 15. Damage requiring service – The appliance should 18. Power lines – An outside antenna system should not be serviced by qualified service personnel when: be located in the vicinity of overhead power lines or A. The power-supply cord or the plug has been other electric light or power circuits, or where it can fall
ページ6に含まれる内容の要旨
6 Before applying power R-SE9T/DP-SE9/X-SE9 (En) The High grade Micro Component Series Thank you for purchasing the High grade Micro component series. This system is available in various configuration according to your preferences. The system configuration is up to you, but as the following convenient system operations can be executed by connecting the various units to the system control, the respective units should be pur- chased as required. Remote Control The remote control supplied with the
ページ7に含まれる内容の要旨
Preparation section Basic section Application section Knowledge sections 7 Before applying power R-SE9T/DP-SE9/X-SE9 (En) Special features 7 Amplifier unit that accomplishes high grade sound quality and low distortion ¦ New “TRAITRA” transistor The newly developed “TRAITRA” transistor with extremely superior temperature characteristics is used in this amplifier’s amplification circuit. Through the use of this transistor, distortion generated because of temperature change is kept to a minimum res
ページ8に含まれる内容の要旨
8 System connection System Composition and Installation R-SE9T/DP-SE9/X-SE9 (En) The High grade Micro component series permits various combinations according to the purchased components. As the installation differs according to the components you purchase, please install cor- rectly under reference to the illustrations. Basic System (R-SE9T, DP-SE9) Seen from the front Installation method R-SE9T DP-SE9 Basic System + Cassette Deck (R-SE9T, DP-SE9, X-SE9) Seen from the front Installation method R
ページ9に含まれる内容の要旨
Preparation section Basic section Application section Knowledge sections 9 System connection System connection R-SE9T/DP-SE9/X-SE9 (En) 1. Antenna connection Connect the antenna as shown in the figure. Do not plug the power cord into a wall AC outlet until the connection has been completed. 12 3 Connection of the Accessory Antenna FM indoor antenna AM loop antenna The accessory antenna is for temporary indoor use only. The supplied antenna is for indoor use. Place it as far as For stable signal
ページ10に含まれる内容の要旨
10 System connection R-SE9T/DP-SE9/X-SE9 (En) Malfunction of microcomputer 2. Connection of audio cord If operation is not possible or erro- Here, connection of separately sold components neous display appears even though also will be explained under consideration of all connections have been made system connection. Please install correctly properly, reset the microcomputer re- according to the purchased components and ferring to “In case of difficulty”. connect the required cords. W Audio cord
ページ11に含まれる内容の要旨
Preparation section Basic section Application section Knowledge sections 11 System connection R-SE9T/DP-SE9/X-SE9 (En) Caution regarding placement To maintain proper ventilation, be sure to leave a space around the unit (from the largest outer dimen- sions including projections) equal to, or greater than, Caution for Connection shown below. When connections are to be made, make sure that the power plug is not plugged into a wall AC outlet. top panel : 50cm Connect the equipment as shown in the f
ページ12に含まれる内容の要旨
12 System connection R-SE9T/DP-SE9/X-SE9 (En) 3. Connection of speakers Connect the speakers as shown in the figure. Do not plug the power cord into a wall AC outlet until the connection has been completed. 1 Cord preparation. Speaker (right) Speaker (left) (6-16Ω) (6-16Ω) 2 Loosen. á» »á SPEAKERS ( 6 - 16 ) 3 Insert. R L 4 Secure. R-SE9T SPEAKERS Connection of banana plugs ( 6 - 16 ) GND AM ANTENNA FM75 + TAPE MD REC REC SYSTEM CONTROL TAPE MD PLAY PLAY R L - 1 Secure. CD AUX SUPER IN IN
ページ13に含まれる内容の要旨
Preparation section Basic section Application section Knowledge sections 13 System connection R-SE9T/DP-SE9/X-SE9 (En) 4. Connection of system control cord Connect the system control cords and the power cords as shown in the figure. System control cord (Supplied with R-SE9T) R-SE9T DP-SE9 SPEAKERS ( 6 - 16 ) ANTENNA GND FM75 AM SYSTEM CONTROL + TAPE MD REC REC SYSTEM CONTROL MD TAPE To wall PLAY PLAY DIGITAL R L - OUTPUT OPTICAL To wall AC outlet AC outlet CD AUX R L SUPER IN IN LINE OUTPUT L
ページ14に含まれる内容の要旨
14 Controls and indicators Controls and indicators R-SE9T/DP-SE9/X-SE9 (En) Main Unit TUNED indicator RDS display Stereo reception indicator AUTO indicator Sleep timer indicator MUTE indicator N.B. indicator MUTE AUTO ST. TUNED RDS EON PTY TP TA NEWS INFO N.B. SLEEP A.P.S. O.T.T. kHz MEMO. O.T.T. indicator ******;** MHz PROG. Memory indicator Timer Program indicator Display A.P.S. indicator Frequency level display and Character information display 6 Receiver R-SE9T 7 stereo integrated amplif
ページ15に含まれる内容の要旨
Preparation section Basic section Application section Knowledge sections 15 Controls and indicators R-SE9T/DP-SE9/X-SE9 (En) Receiver R-SE9T 1 N.B. key (t 8 EX. BASS indicator e When the power is ON : Used for bass compensation. This lights at the time of EX. BASS mode. When the power is OFF : Used for timer setting. 9 EX. BASS key (e 2 “enter” key ¦r When the power is ON : Switches EX. BASS mode Used for time setting, timer setting, presetting RDS ON/OFF. stations, storing radio stations etc. W
ページ16に含まれる内容の要旨
16 Controls and indicators R-SE9T/DP-SE9/X-SE9 (En) Remote control Unit [RC-SE9(E)] When the system control cord is connected, this remote control can be used to operate the entire system. The keys on the remote control unit with the same names as on the main unit have the same function as the keys on the main unit. 6 BAND key ¤ This is used to switch the tuner reception bands. 0 7 Keys related to RDS á 23 TAPE SLEEP RDS'DISPLAY key ! The display contents are switched during reception 1Á 7 DISP
ページ17に含まれる内容の要旨
Preparation section Basic section Application section Knowledge sections 17 Operation of remote control unit Operation of remote control unit R-SE9T/DP-SE9/X-SE9 (En) Loading batteries 2 Insert batteries. 3 Close the cover. 1 Remove the cover. Ö Insert two R6 (“AA”-size) batteries following the polarity indications. Operating range (approx.) Operation Remote After plugging the power cord of this unit, press sensor the on/standby key of the remote control unit to turn the power of the system ON.
ページ18に含まれる内容の要旨
18 Hearing sound Hearing sound R-SE9T/DP-SE9/X-SE9 (En) Basic use Bass compensation 2 2 Listening through headphones 1 1 3 3 Muting the sound temporarily Press the “on/standby” key of 1. Switching the power ON (OFF). the receiver. When the “on/standby” key is Ö The entire system can be switched ON and OFF. The on/standby pressed while the power is ON, key on the remote control has the the power will be switched same function. OFF. 1 1 Ö The display part becomes dark on/standby when the power is
ページ19に含まれる内容の要旨
Preparation section Basic section Application section Knowledge sections 19 Hearing sound R-SE9T/DP-SE9/X-SE9 (En) Muting the sound temporarily (Remote control unit only) Listening through headphones MUTE Blinks R-SE9T 1 Insert the headphone plug into the phones jack. phones MUTE Remote control unit Ö Press again to resume the original volume. Ö This is also cancelled when the volume is adjusted. Bass compensation (N.B.: Natural Bass circuit) N.B. R-SE9T Lights Ö Headphones with a stereo mini pl
ページ20に含まれる内容の要旨
20 Hearing sound R-SE9T/DP-SE9/X-SE9 (En) Playback of CD 1 1 2 2 To fast forward and backward Playback from Skipping tracks desired track To stop PLAYBACK 0 1. Load a disc. The label must be on top. 1 Open the tray. 2 Place a disc. 1 1 1 1 3 Close the tray. The tray opens when the key is pressed and closes when the key is pressed again. 2. Start playback. 6 When the power is ON and a disc has been set in ad- 2 2 vance to the CD player, playback will start just by set- ting the input selection to
