ページ1に含まれる内容の要旨
KDC-C519FM(M) Cover 02.9.24 10:03 AM Page 1
CD AUTOCHANGER / CONTROLLER / FM MODULATOR SYSTEM
KDC-C519FM
INSTRUCTION MANUAL
COMPACT
DIGITAL AUDIO
©B64-2352-00/00 (MW)
ページ2に含まれる内容の要旨
KDC-C519FM(M)/U.S 02.9.24 10:01 AM Page 2 Contents Before use Safety Precautions ........................................................................3 Handling Compact Discs...............................................................5 Loading Compact Discs ................................................................6 Buttons Display Unit...................................................................................7 Remote ......................................................
ページ3に含まれる内容の要旨
KDC-C519FM(M)/U.S 02.9.24 10:01 AM Page 3 Safety Precautions • When replacing a fuse, only use a new one Cleaning the Unit 2WARNING with the prescribed rating. Using a fuse with If the front panel gets dirty, turn off the the wrong rating may cause your unit to Take the following precautions to prevent power and wipe the panel with a dry silicon malfunction. on hot places such as above the cloth or soft cloth. fire and avoid personal injury: dashboard. •When extending the ignition wire, batte
ページ4に含まれる内容の要旨
KDC-C519FM(M)/U.S 02.9.24 10:01 AM Page 4 Safety Precautions 2CAUTION Do not set the remote on hot places such as above the dashboard. Loading and Replacing the Batteries: Use two "AAA" batteries. Slide the cover while pressing downwards to remove it as illustrated. Insert the batteries with the + and – poles aligned properly, following the illustration inside the case. 2WARNING Store unused batteries out of the reach of children. Contact a doctor immediately if the battery is accidentally sw
ページ5に含まれる内容の要旨
KDC-C519FM(M)/U.S 02.9.24 10:01 AM Page 5 Handling Compact Discs Playing a CD that is dirty, scratched or • Remove CDs from the unit when not listening to Do Not Load CD Accessories them for a while, and put them back in their warped can cause the sound to skip and Do not use commercially available CD accessories cases. Do not pile up CDs that are removed from the unit to operate incorrectly, resulting in that can be loaded into the CD slot, such as their cases or prop them against something
ページ6に含まれる内容の要旨
' ' ' ' ' KDC-C519FM(M)/U.S 02.9.24 10:01 AM Page 6 Loading Compact Discs 1 3 5 "KENWOOD" Projection Close the CD changer door. NOTE Make sure the disc magazine is the Use the CD changer with its door closed right way up with the Kenwood logo to prevent the entry of dust into the on the top.Pull the tray out by the Open the CD changer door. changer. projection. 2 4 6 Magazine ejection Place the disc on the tray with the label facing upwards. Insert the tray into the disc magazine until it loc
ページ7に含まれる内容の要旨
KDC-C519FM(M)/U.S 02.9.24 10:01 AM Page 7 Operations Buttons Display Unit Set the car radio FM station to 88.3 MHz. See Page 11 for more information on changing the transmission frequency. REP Playing CDs CD AUTO CHANGER CONTROLLER TRACK TRACK RDM Playing CDs : DISC FREQ Press the PWR (POWER...Remote) button. LEVEL 3/8 M.RDM D.REP D.SCN MHz The power goes ON and the CD play start. When the unit ' receives any signal from the remote controller, the TRACK DISC mark lights up. PWR 4¢ - + Disc
ページ8に含まれる内容の要旨
KDC-C519FM(M)/U.S 02.9.24 10:01 AM Page 8 Operations Fast Forwarding and Reversing Disc Play Disc Search Search forward or backward through the discs in a disc Fast Forwarding Disc Play : changer. Hold down on the ¢ button. Release your finger to play the disc at that point. Making a Reverse Disc Search : Press the – button to display the desired disc number. Reversing Disc Play : Each time the button is pressed, the displayed disc number Hold down on the 4 button. decreases by one. Release
ページ9に含まれる内容の要旨
KDC-C519FM(M)/U.S 02.9.24 10:01 AM Page 9 Direct Disc Search Function of remote Disc Repeat Function of remote Using the remote, directly input the disc number that you want Repeat playing the disc currently being listened to. to listen to. To repeat disc : 1 Press the D.REPEAT button. Using the number buttons on the remote, input the number of the disc that you want to listen to. The D.REP indicator will appear on the display and the Disc repeat function will turn on. The selected disc num
ページ10に含まれる内容の要旨
KDC-C519FM(M)/U.S 02.9.24 10:01 AM Page 10 Operations Random Play 2 To change the track being heard, press the T. UP button. Play all the tracks on the current disc in random order. Another disc/track will be selected and played. NOTE 1 Press the RDM button to switch the random play function on • Magazine random play is canceled when you stop playing a and off. disc. The RDM indicator lights up when the random play function is • The time needed for random selection depends on the turned on. n
ページ11に含まれる内容の要旨
¢ KDC-C519FM(M)/U.S 02.9.24 10:01 AM Page 11 Changing the transmission frequency NOTE Some car radios cannot receive a 87.7 MHz frequency. 1 To set the frequency change mode To cancel : Press the REP button for at least three seconds. The FREQ Press the REP button on the display unit for at least three indicator will light up and the currently set frequency will be seconds. displayed. The FREQ indicator will go off and the frequency change will take effect. FREQ The frequency change mode is a
ページ12に含まれる内容の要旨
KDC-C519FM(M)/U.S 02.9.24 10:01 AM Page 12 Operations NOTE Modulation level / Dynamic control Dynamic control The unit comes with the prevention of distortion function to 1 To set the control mode reduce sound distortion. Press the RDM button on the display unit for at least three If the sound is distorted severely, press the + button on the seconds. display unit and then set the function to "2" (ON). If the The LEVEL indicator will light up and the currently set prevention of distortion fu
ページ13に含まれる内容の要旨
KDC-C519FM(M)/U.S 02.9.24 10:01 AM Page 13 Installation Procedure Accessories External view 1. To prevent a short circuit, remove the key from the ignition and ......... Number of items disconnect the - battery. 2. Make the proper input and output wire connections for each unit. 1 3. Connect the wiring harness wires in the following order: ground, 5 .........1 battery, ignition. .........1 4. Install the unit in your car. 5. Reconnect the - battery. 2 6 6. Press the reset button. .........4 .
ページ14に含まれる内容の要旨
KDC-C519FM(M)/U.S 02.9.24 10:01 AM Page 14 Installation Procedure Connecting Wires to Terminals ■ Angle adjustment switches Display unit REP CD AUTO CHANGER CONTROLLER The angle adjustment switches on the both saides of the unit TRACK TRACK RDM DISC DISC FREQ FREQ Control output LEVEL LEVEL M.RDM M.RDM D.REP D.REP D. D.SCN SCN MHz MHz 3/8 ' are to be set according to the angle of installation of the CD TRACK DISC PWR 4¢ - + auto changer. Set both of the two switches to the same position. If t
ページ15に含まれる内容の要旨
45 0 90 0 45 90 KDC-C519FM(M)/U.S 02.9.24 10:01 AM Page 15 Installation ■ Horizontal installation ■ In case of hanging in the trunk Use the holes marked (¶) to install the unit. Use the holes marked (¶) to install the unit. Side view 2 Side view 0 ø4 45 0 45 90 90 1 0 45 0 45 90 90 3 3 1 2 ø4 ■ Vertical installation ■ Installation of FM modulator unit Use the holes marked (¶) to install the unit. 2CAUTION 6 Take sufficient care so that the wires are not Side view caught under the seat. 2 If t
ページ16に含まれる内容の要旨
KDC-C519FM(M)/U.S 02.9.24 10:01 AM Page 16 Installation ■ Installation of Display unit • Installation without using the trim mount plate 7 Display unit Attach one velcro to the slanted-line of the the display units as shown above, and attach the other velcro to the parts where you wish to attach the display units. Then, put velcros together and install the display units. 5 • Installation using the trim mount plate 7 REP CD AUTO CHANGER CONTROLLER TRACK RDM FREQ LEVEL 3/8 ' RDM REP MHz TRACK D
ページ17に含まれる内容の要旨
KDC-C519FM(M)/U.S 02.9.24 10:01 AM Page 17 Troubleshooting guide What might seem to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems. PROBLEM POSSIBLE CAUSE SOLUTION The power is not turned on. The wiring harness fuse blows. Check wires for shorts, then replace the fuse with one of with the same rating (shown on the case). No sound or sound is low. The volume level is minimum
ページ18に含まれる内容の要旨
KDC-C519FM(M)/U.S 02.9.24 10:01 AM Page 18 Troubleshooting guide PROBLEM POSSIBLE CAUSE SOLUTION Sound skips due to vibration. Keep it away from the CD auto-changer. Something is touching the CD auto-changer. The disc is dirty or damaged. If sound skips at the same part, the disc is faulty. Check and, if possible, clean the disc. See "Cleaning CDs" (Page 5). The unit is mounted at a slant. Mount the unit so that is level. Changer unit is mounted in an unstable place. Mount the unit in a sta
ページ19に含まれる内容の要旨
KDC-C519FM(M)/U.S 02.9.24 10:01 AM Page 19 The following messages are displayed when certain problems are occurring in your system. Take the recommended actions. 01 E: No disc magazine has been loaded in the changer. The disc magazine is not completely loaded. ] Load the disc magazine properly. 02 E: No disc has been loaded in the disc magazine.. ] Load a disc into the disc magazine. 04 E: No disc has been loaded in the disc magazine. ] Load a disc into the disc magazine The CD is quite dirt
ページ20に含まれる内容の要旨
KDC-C519FM(M)/U.S 02.9.24 10:01 AM Page 20 Specifications Specifications subject to change without notice. Disc section Laser Diode.....................................................GaAlAs (λ=780 nm) Digital Filter (D/A)......................................8 Times Over Sampling D/A Converter.........................................................................1 bit Spindle speed ...............................................500 ~ 200 rpm (CLV) Wow & Flutter.............................
