ページ1に含まれる内容の要旨
3D0050600A
CC-222
CD Recorder/Cassette Deck
OWNER’S MANUAL
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS
Ü
INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert
the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure
ÿ
that may be of sufficient magnitude to constitute a risk of electric shock to persons.
ページ2に含まれる内容の要旨
Important Safety Precautions For U.S.A IMPORTANT (for U.K. Customers) TO THE USER DO NOT cut off the mains plug from this equipment. This equipment has been tested and found to If the plug fitted is not suitable for the power points in your home or comply with the limits for a Class A digital device, the cable is too short to reach a power point, then obtain an pursuant to Part 15 of the FCC Rules. These appropriate safety approved extension lead or consult your dealer. limits are designed to p
ページ3に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS CAUTION: "Note to CATV system installer: …Read all of these Instructions. This reminder is provided to call the CATV system installer’s attention to …Save these Instructions for later use. Section 820-40 of the NEC which provides guidelines for proper grounding …Follow all Warnings and Instructions marked on the audio and, in particular, specifies that the cable ground shall be connected to the equipment. grounding system of the building, as close to the point of ca
ページ4に含まれる内容の要旨
SAFETY INFORMATION This product has been designed and manufactured according to FDA regulations "title 21, CFR, chapter 1, subchapter J, based on the Radiation Control for Health and Safety Act of 1968", and is classified as a class 1 laser product. There is no hazardous invisi- ble laser radiation during operation because invisible laser radiation emitted inside of this product is completely confined in the protective housings. The label required in this regulation is shown in 1. CAUTION - DO N
ページ5に含まれる内容の要旨
Table of Contents Playback modes ..........................................21 1 – Introduction Programmed order playback ............................... 21 Supplied accessories ................................................6 Repeat play .................................................22 Some notes and precautions .......................6 Setting the A and B repeat points ....................... 22 Rack-mounting the unit ..........................................7 Intro check .................
ページ6に含まれる内容の要旨
1 – Introduction The CC-222 provides you with an advanced system sources which are at frequencies other than the CD for the recording and playback of digital compact standard sampling frequency of 44.1 kHz. discs and analog cassettes, providing easy duplica- Disc track divisions can be entered manually, or can tion facilities in both directions, and combining the produced automatically as a response to the input most advanced technology in both fields. signal level. Additional audio units, b
ページ7に含まれる内容の要旨
1 – Introduction—Some notes and precautions Rack-mounting the unit Use the rack-mounting kit to mount the unit in a stan- See “Environmental considerations” on page 7 below dard 19-inch equipment rack, as shown below. for details of ventilation, etc. Remove the feet of the unit before mounting it. Environmental considerations The CC-222 may be used in most areas, but to main- Make sure that the unit is mounted in a level position tain top performance, and prolong operating life, for correct op
ページ8に含まれる内容の要旨
1 – Introduction—Finalizing For the automatic tape selection function to work Note that Type I (normal), Type II (high-position/ properly, metal and high position (cobalt) tapes must chrome) and Type IV (metal) tapes can be played have the appropriate identification holes. back. Recording is possible with Type I (normal) and Type II (high-position/chrome) tapes. About CD-R and CD-RW discs The CC-222 uses CD-R and CD-RW media, and can recorded can be erased before the disc has been also use CD
ページ9に含まれる内容の要旨
1 – Introduction—Finalizing Handling of compact discs Observe the following: stains will have absolutely no effect on reproduc- tion quality. Always place compact discs in the tray with their label facing upward (compact discs can only be played on one side). To remove a disc from its storage case, press down on the center of the case, and lift the disc out, hold- ing it carefully by the edges. Never use such chemicals as record sprays, anti- static sprays or fluid, benzine or thinner t
ページ10に含まれる内容の要旨
1 – Introduction—About this manual NOTE Never use a disc that has had a stabilizer mounted to it. The residual adhesive may cause the disc to stick to the mechanism of the CC-222. If it sticks to the mechanism, you will need a technician to get it out. Recommended media An up-to-date list of manufacturers who produce media suitable for use in the CC-222 can be obtained from your TASCAM dealer. Use of the remote control unit When using the remote control unit, make sure: Always make sure t
ページ11に含まれる内容の要旨
2 – Features and controls This is not a comprehensive explanation of the mean- D RTZ key Returns the tape to the zero position. ing and functions of all of the controls. These are E INPUT 2 SEL key Repeated presses of this described more comprehensively in other parts of the key cycle between the different sources available for manual, but this section provides a brief reminder of the cassette recorder: LINE2, and DISC. the functions provided by these controls. F DUB 1 TAPE>CD-RW key Starts
ページ12に含まれる内容の要旨
2 – Features and controls—Rear panel features tional playback and recording (Ä or Ê), or (ä) M OPEN/CLOSE key Opens and closes the continuous playback only (not recording). disc tray. N DISPLAY key Changes the time display for X Dolby NR (OFF/ON) switch Use this the disc recording and playback. switch to turn the Dolby noise reduction off and on for the cassette deck. O FINALIZE key Used when finalizing record- Y CD-TAPE CONT PLAY switch Use this able discs. to turn continuous playback (alt
ページ13に含まれる内容の要旨
2 – Features and controls—Remote control features LINE OUTPUTS 2 output both the signals from the g DIGITAL COAXIAL (INPUT and disc recorder and the cassette deck. However, if both OUTPUT) jacks These RCA jacks accept are playing, the cassette deck takes priority (the disc (INPUT) and transmit (OUTPUT) SPDIF digital recorder will not be heard). audio data to and from the disc recorder. j RIAA PHONO INPUT (L, R) and GND Digital audio data received can be at any sampling frequency between
ページ14に含まれる内容の要旨
2 – Features and controls—Remote control features E FADER key Used to perform automated M SEARCH keys Used for “fast forward” and fade-in and fade-out when recording to disc. The “fast reverse” through a disc. time is set using menu items. N SKIP keys Perform the same functions as F PLAY MODE key Allows the selection of turning the MULTI DIAL S (selecting tracks and either normal, single, programmed or random play- selecting menu parameter values). back. O REC key Performs the same function a
ページ15に含まれる内容の要旨
3 – Cassette operations NOTE Avoid touching the tape. Fingerprints attract dust and dirt. 2 Press the EJECT key to open the cassette compartment door. 3 Load the cassette tape with its open edge fac- ing down. 4 Gently close the compartment door. NOTE *Notes: The cassette holder cannot be opened during recording or playback. Note the following when loading tapes: If the power has been switched off during play or 1 Use your finger or a pencil to turn the cas- recording, ejecting the cassette
ページ16に含まれる内容の要旨
3 – Cassette operations—Recording operations Recording operations 4 Set the Dolby NR system on or off. NOTE CAUTION Recording pre-recorded tapes, records, or other pub- 5 Press the RECORD key. The deck enters lished or broadcast material may infringe copyright laws. record pause mode (the display indicators Check before recording. light). 1 With the power on, set the REV MODE 6 Play back the source, and adjust the record- switch. ing level with the INPUT level control so that If you want to
ページ17に含まれる内容の要旨
3 – Cassette operations—Recording tapes from the PHONO deck The dubbing stops when playback reaches the end of mode, but the CD does not play back), again to allow the CD, or when the tape reaches the end of its run for leader tape at the start of the cassette. (one side in the case of single-sided (u) reverse The dubbing process can also be stopped manually mode, both sides in the j reverse mode), which- with the STOP key of the cassette deck or the CD ever comes first. deck. All other tran
ページ18に含まれる内容の要旨
3 – Cassette operations—Other recording features tape is not loaded or the tape is write-protected (the Press STOP (cassette deck) to stop the phono to tape function is disabled with no recordable recording. The STOP key is the only key tape inserted), or the tape is not either stopped or in which is enabled during phono recording. record ready mode. After the phono recording has finished, the Only recording as described above is possible from the original tape signal source is restored.
ページ19に含まれる内容の要旨
3 – Cassette operations—Other tape functions and features Fast forward and rewind The REW and FFWD keys (and their remote control keys when pressed when the unit is stopped or equivalents) act as ordinary fast forward and rewind paused. Search keys When the unit is playing back, the wind keys men- When the item is reached, playback starts. When the tioned above act as Computer-controlled Program end of the tape is reached, the transport stops. Search (CPS) keys, moving to the next (or previous
ページ20に含まれる内容の要旨
4 – CD player The CC-222 can be used to play back CDs (including discs and CD-RW discs that have been recorded on CD-R and CD-RW discs that have been recorded and the unit. finalized on other types of recorder), as well as CD-R Simple playback operations 1 Press the OPEN/CLOSE key to open the disc CD A commercial pre-recorded CD or a finalized CD-R tray. CD-R, NO TOC A CD-R which has yet to be finalized 2 Discs should be inserted in the tray with the CD-RW, NO TOC A CD-RW which has yet to b
