ページ1に含まれる内容の要旨
Owner’s Manual
Model
G70
IMPORTANT SAFETY INFORMATION: Always read this manual first
before attempting to install or use this heater. For your safety, always
comply with all warnings and safety instructions contained in this manual
to prevent personal injury or property damage.
7211460100R00
ページ2に含まれる内容の要旨
Table of Contents Welcome & Congratulations ................3 IMPoR tant InstRuCtIons . . . . . . . . . . . . . . .4 Heater Installation ........................7 operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9 Maintenance and Cleaning . . . . . . . . . . . . . . . .10 Warranty ...............................10 Always use a qualified technician ! NOTE: Procedures and or service agency to repair techniques that are this heater. considered import
ページ3に含まれる内容の要旨
Welcome & Congratulations thank you and congratulations for choosing to purchase an electric heater from new air, the world leader in electric heaters. Please carefully read and save these instructions. CAUTION: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible electric shock, fire hazard and will void the warranty. Please record your model and serial numbers below for future reference: model and
ページ4に含まれる内容の要旨
IMPORTANT INSTRUCTIONS ① Read all instructions before ⑥ Do not use outdoors. using this appliance. ⑦ the heater is not intended for ② the heater is hot when in use. use in bathrooms, laundry areas t o avoid burns, do not let bare and similar indoor locations. skin touch hot surfaces. the trim never locate heater where it may around the heater outlet becomes fall into a bathtub or other water hot during heater operation. container. Keep combustible materials, such ⑧ Do not
ページ5に含まれる内容の要旨
IMPORTANT INSTRUCTIONS soft surfaces, like a bed, where the red light rurns on, immediately openings may become blocked. turn heater off and inspect for any objects on or adjacent ⑬ All electrical heaters have hot to the heater that may cause and arching or sparking parts high temperatures. Do not inside. Do not use in areas where oPERatE WHEn RED LIGHt Is gasoline, paint, or flammable on. liquids are used or stored or where the unit will be exposed to ⑰ Always use a certified fl
ページ6に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS grounding Instructions Figure 1: Plug and outlet this heater is for use on 240 configuration for 240 Volts. the cord has a plug as Volt, 20 amp circuit shown on Figure 1. no adapter should be used with this unit. the type outlet is a 240 Volt grounding Ground outlet. When properly installed, it provides a ground connection through the cord to the heater to protect the operation from electric shock. outlet Plug 6
ページ7に含まれる内容の要旨
Heater Installation HEATER LOCATION AND CLEARANCES the heater is intended for use located on a hard floor, table top, desk or on shelf, and the like, or suspended on a wall or ceiling by means of provided hanger bracket. When suspended from wall or ceiling heater should be located the use of the hanger bracket along outside walls to provide allows the unit to be rotated perimeter air circulation. approx 45 degrees in each the discharge air should wipe the direction from centre, w
ページ8に含まれる内容の要旨
Heater Installation 2. Insert carriage bolt into Figure 3 Hanger square opening of heater bracket handle. 3. slide spacer over the carriage t -Handle bolt shaft and insert in hanger bracket opening and Lock washer hold them in position. 4. slide lock washer and thread spacer on t -Handle onto carriage Carrage bolt, turn to tighten. Bolt air in air out Hanger Bracket Mounting Options 8
ページ9に含まれる内容の要旨
Operation Setting the Thermostat ! NOTE: Heater is equipped with a fan delay to dissipate 1. Before connecting or residual heat from the element. disconnecting plug, turn Heater fan will run for a brief knob fully counterclockwise. period after heater has reached (Figure 4) room temperature. 2. Heater is equipped with Figure 4 a thermostat. t o adjust temperature to your individual requirements, turn thermostat control knob clockwise all the way to turn heater on, the yello
ページ10に含まれる内容の要旨
Maintenance and Cleaning maintenance or cleaning. WARNINg: Disconnect power before attempting any t o clean the exterior surface, maintenance or cleaning to use a solution of water and mild reduce the risk of fire, electric detergent, apply with damp shock or damage to persons. sponge. Wipe dry with a dry cloth. DO NOT plug heater into CAUTION: allow at least outlet until it has dried thoroughly. 30 minutes for the heater to cool before attempting any Warranty newair Elect
