ページ1に含まれる内容の要旨
BAL Ex-GSM 01_US_Umschl #6 29.11.2005 11:59 Uhr Seite 2
Safety instructions
Ex-GSM 01
ecom instruments GmbH
Industriestr.2
97959 Assamstadt
Germany
Tel.: +49 (0) 62 94 / 42 24-0
Fax: +49 (0) 62 94 / 42 24-90
E-Mail: sales@ecom-ex.com
0163AL01A01 11/05 Subject to change without notice!
ページ2に含まれる内容の要旨
1 Application 2 2 Safety instructions 2 3 Errors and load restrictions 2 4 Safety regulations 3 5 Ex-data 3 6 Accessories 3 7 Technical Data 3 8 Operating instructions 4 8.1 Safety in traffic 4 8.2 Operating environment 4 8.3 Electronic equipment 4 8.3.1 Cardiac pacemaker 5 8.3.2 Hearing aid 5 8.3.3 Other medical equipment 5 8.3.4 Places with appropriate signs 5 8.4 Transport 6 8.4.1 Motor vehicles 6 8.4.2 Aircrafts 6 8.5 Emergency calls 6 9 Certification Information (SAR) 7 10 Commissioning 9 1
ページ3に含まれる内容の要旨
Note: The current safety instructions, and the Ex-certificate are available for download from the relevant product page under www.ecom-ex.com; alternatively they can be requested directly from the manufacturer. 1 Application The Ex-GSM 01 is a portable Non-Incendive cell phone for industrial use in explosion-hazardous areas of Class I, DIV 2, Groups A, B, C and D according to FM standards. 2 Safety instructions These safety instructions contain information and safety regulations that must be fol
ページ4に含まれる内容の要旨
4 Safety regulations Any person using the unit must observe the standard safety regulations and read the certificate to prevent incorrect operation or abuse of the unit. The following additional safety regulations must also be observed: - The unit must not be opened within the Ex-area. - The battery must only be changed outside the Ex-zone. - Additional or spare batteries must not be carried in the Ex-area. - The battery must only be charged outside of the Ex-area with the appropriate/original c
ページ5に含まれる内容の要旨
Size: 4.1 in x 1.8 in x .9 in (10.6 cm x 4.7 cm x 2.4 cm) Weight: 3.5 ounces (101 grams) 8 Operating instructions Before using the equipment for the first time, please read the safety and ope- rating instructions very thoroughly. Remember there is no vibra call in your modified ex-cell phone, please ignore all instructions in the original operating manual which describe the use and function of the vibra call. Further, the inte- grated camera is deactivated due to ex-relevant reasons. 8.1 Safety
ページ6に含まれる内容の要旨
8.3.1 Cardiac pacemaker The following instructions apply to persons fitted with a cardiac pacemaker: • When the mobile phone unit is switched-on, ensure that a minimum distance of 20 cm between the mobile- phone unit and the Pacemaker is maintained. • In order to help guarantee this distance, it is recommended that the mobile phone unit is not kept in a breast pocket. • To minimise interference we recommend that the ear furthest away from the Pacemaker is used when using the mobile phone unit.
ページ7に含まれる内容の要旨
8.4 Transport 8.4.1 Motor vehicles In certain circumstances, RF signals can interfere with the correct functioning of incorrectly installed or inadequately screened systems in your motor vehi- cle (e.g. electronically controlled fuel injection, electronic ABS - (Antilock Brake Systems), electronic speed controllers or airbag systems). You can obtain information about your vehicle from the manufacturer or his representa- tive. To be on the safe side and avoid malfunctioning, you should have your
ページ8に含まれる内容の要旨
Procedure in the event of an emergency call: 1. Switch the telephone on if it is not already switched on. Check whether the signal strength is adequate. In certain networks it may be necessary to plug a valid SIM card into the telephone. 2. Press the red off / END key as many times as is necessary (e.g. to end call or quit a menu etc.) to erase the display and prepare the mobile telephone for making a call. 3. Enter the emergency number (e.g. 911, 112 or some other official emer gency numbe
ページ9に含まれる内容の要旨
the FCC is 1.6 W/kg*. Tests for SAR are conducted using standard operating positions accepted by the FCC with the phone transmitting at its highest certi- fied power level in all tested frequency bands. Although the SAR is determined at the highest certified power level, the actual SAR of the phone while opera- ting can be well below the maximum value. This is because the phone is designed to operate at multiple power levels so as to use only the power required to reach the network. In general,
ページ10に含まれる内容の要旨
standard incorporates a substantial margin of safety to give additional protec- tion for the public and to account for any variations in measurements. SAR values may vary depending on national reporting requirements and the net- work band. For SAR information in other regions please look under the pro- duct information at www.nokia.com. 10 Commissioning How to connect the Ex-GSM 01 cell phone with the power outlet outside the hazardous areas see following diagram. Control drawing number: 0163EX0
ページ11に含まれる内容の要旨
1 – With the back of the phone facing you, press the indentations on both sides of the lower shell. 2 – Slide the bottom of the shell off to remove it. 3 – Grasp the removal flap, and gently pull it up. 4 – Lift the battery from the compartment. 5 – Slide the cover of the SIM card holder toward the bottom end of the phone until it unlocks. 6 – Swing the cover of the SIM card holder open. 7 – Insert the SIM card into the holder. Ensure that the beveled corner of the SIM card is on the
ページ12に含まれる内容の要旨
12 – Place the phone into the lower shell, sliding the shell forward until it locks into place. 10.1.2 Charging the battery Warning: Use only batteries, chargers, and enhancements approved by Nokia for use with this particular model. The use of any other types may invalidate any approval or warranty, and may be dangerous. The Ex-GSM 01 mobile phone must only be charged outside of the Ex-hazar- dous areas and only with an approved battery charger type. Check the model number of any charger befor
ページ13に含まれる内容の要旨
Hold the phone as you would any other telephone with the antenna pointed up and over your shoulder. To switch the phone on or off, press and hold the power key. If the phone displays Insert SIM card, even though the SIM card is properly inserted or SIM card not supported, contact your service provider. If the phone asks for a PIN code or security code, enter the code, and press OK. 10.1.4 Keys and connectors 1 — Flashlight. To activate the flashlight, press and hold in standby mode. 2 — Power
ページ14に含まれる内容の要旨
9 — End key , to end a call, or to exit functions. 10 — Keys - , to enter numbers and characters. Keys and are used for various purposes in different functions. 1 – Charger connector 2 – Pop-Port™ connector used, for example, for headsets and the data cable (please refer to the control drawing number: 0163EX04A for allowed con- nections to Ex-GSM 01). 3 – Camera lens (deactivated) 4 – Infrared (IR) port 10.1.5 Changing the shell and key mat Note: Do not open the device inside Ex-hazardous areas
ページ15に含まれる内容の要旨
5 – Slide the upper shell onto the phone. 6 – Slide the lower shell onto the phone until it clicks into place, meeting the upper shell. 10.1.6 Attaching the carrying strap to the phone 1 – Connect the elastic band to the holster. 2 – Connect the pins on the end of the hol- ster to the holes in the lower end of the phone. 3 – Connect the pin on the other end of the holster to the hole in the top end of the phone. 4 – Wrap the elastic band, for example, around your wrist and connect the band
ページ16に含まれる内容の要旨
1 -Shows the name of the network or the operator logo to indicate the cellu- lar network in which the phone is currently being used. 2 -Shows the signal strength of the cellular network at your current location. The higher the bar, the stronger the signal. 3 -Shows the battery charge level. The higher the bar, the more power in the battery. 4 -The left selection key in standby mode is Go to. You can use the key as a shortcut to your favorite functions. To view the list of functions that you h
ページ17に含まれる内容の要旨
The stopwatch is running. The GPRS connection mode Always online is selected and the (E)GPRS service is available. The indicator for GPRS and EGPRS is the same. An (E)GPRS connection is established. The (E)GPRS connection is suspended (on hold), for example, if there is an active call during an (E)GPRS dial-up connection. When the infrared connection is activated, the indicator is shown conti- nuously. If you have two phone lines, the second phone line is indicated. All incoming calls are dive
ページ18に含まれる内容の要旨
• To lock the keypad in standby mode, press Menu and within 1.5 seconds. • To unlock the keypad, press Unlock and within 1.5 seconds. • To answer a call when the keyguard is on, press . During a call, the phone can be operated normally. When you end or reject a call, the keypad automatically locks again. You can set whether the keyguard locks automati- cally or requires a code to unlock. 10.3 Telephone functions The Ex-GSM 01 includes functions which are very useful in everyday life, e.g
ページ19に含まれる内容の要旨
Enhanced GPRS (EGPRS), uses enhanced data rates for global evolution (EDGE), a radio interface modulation technique, to increase the data rates of GPRS. The functions of your phone that may use (E)GPRS are messaging, browsing pages, e-mail, remote synchronization, application downloading, and the PC dialup (for example, Internet and e-mail). Before you can use (E)GPRS technology: • you must apply for the (E)GPRS service. Information on the availability and pricing conditions of using (E)GPRS ca
ページ20に含まれる内容の要旨
group of people having compatible devices. When your call is connected, the person or group you are calling does not have to answer the phone. Besides the GPRS counters, the phone registers only one-to-one calls in the recent call list in Call log. The participants should confirm the reception of any communi- cations where appropriate as there is no other confirmation whether the reci- pient(s) have heard the call. To check availability and costs, and to subscribe to the service, contact your ne
