ページ1に含まれる内容の要旨
Please read all instructions BEFORE assembly and USE of product.
KEEP INSTRUCTIONS FOR FUTURE REFERENCE.
Model # 1305TW
Infant car seats not included
®
Double Snap N Go
Instruction Manual
Convenience through innovation and thoughtful design
04.07
Copyright © 2006 - 2007, Baby Trend Inc., All Rights Reserved.
ページ2に含まれる内容の要旨
® ® Double Snap N Go Double Snap N Go WARNING: Please follow all of these instructions to ensure the safety of your children. Keep these instructions for future reference. WARNING: Failure to follow these instructions could result in serious injury or death. Avoid serious injury from falling or sliding out. Always use the infant car seat harness and insure that the child and infant car seat are properly positioned according to these instructions. WARNING: Never leave child unattended. WARNING:
ページ3に含まれる内容の要旨
PARTS Rear Axle Front Wheels (x2) Flat Bar 1” Bar (x 2) Stroller ASSEMBLING TO ENSURE SAFE OPERATION OF YOUR STROLLER, PLEASE FOLLOW THESE INSTRUCTIONS CAREFULLY AND RETAIN THEM FOR FUTURE REFERENCE. ASSEMBLY: 1. Remove stroller from box. NOTE: The front wheels, rear wheels, parent tray, and support bars specific to your infant car seats need to be installed prior to use. 2. To attach the front wheels, unfold stroller and lean backwards so that it rests on the handle and rear frame tubes with t
ページ4に含まれる内容の要旨
W A R N I N G : DO NOT place hot liquids in the parent tray. Hot liquids can burn your child. Do not place more than 3 pounds in the tray as it may cause a hazardous unstable condition to exist. W A R N I N G : ALWAYS USE the Infant Car Seat harness to avoid serious injury from falling or sliding out. BRAKES: W A R N I N G : ALWAYS SET brakes when Fig. 4 the stroller is not being pushed so that the stroller will not roll away. Never leave stroller unattended on a hill or incline as
ページ5に含まれる内容の要旨
TO UNFOLD STROLLER: DO NOT allow children near stroller while unfolding. 1. Release the folding latch located on the right side. 2. Lift up on the stroller handle with both hands making sure the stroller frame is erect and locks in the open position. (Fig. 7) The stroller has spring-loaded latches on both sides of the frame. Test that both latches are fully engaged prior to placing your child in the stroller. Fig. 7 3. Extend the front frame by rotating it forward. (Fig. 8b). Slide the two
ページ6に含まれる内容の要旨
SNAP BAR POSITON CHART Flat Bar (x 1) 1” Bar (x 2) Flip Bars E D C B A E D C B A Fig. 12 CAR SEAT FRONT BAR LOCATION REAR BAR LOCATION BABY TREND 1” Bar Downwards Hole “B” Top Flip Bars BRITAX 1” Bar Downwards Hole “C” 1” Bar Upwards Hole “E” EVENFLO 1” Bar Upwards Hole “B” Top Flip Bars GRACO 1” Bar Downwards Hole “C” 1” Bar Upwards Hole “E” PEG PEREGO 1” Bar Downwards Hole “A” Flat Bar Hole “D” S T O P If you experience any difficulty with the use of our produ
