ページ1に含まれる内容の要旨
Read all instructions BEFORE assembly and USE of product.
KEEP INSTRUCTIONS FOR FUTURE USE.
Model #7581
Sit N Stand Plus
with Car Seat Snap N Go Attachment System
US PATENT #5,664,795
Instruction Manual
Convenience through innovation and thoughtful design 06.06
ページ2に含まれる内容の要旨
WARNINGS WARNING: Please follow all of these instructions to ensure the safety of your child. Keep these instructions for future reference. WARNING: Failure to follow these instructions could result in serious injury or death. Avoid serious injury from falling or sliding out. Always use the safety belts and insure that the children are properly positioned according to these instructions. WARNING: Never leave children unattended. * The maximum weight that can be carried in the Parent Tray i
ページ3に含まれる内容の要旨
PARTS Parent Tray Front Wheels Child Tray Snap N Go Attachment Rear Wheels Foot Rest Bar Stroller Front/Rear Canopies ASSEMBLING TO ENSURE SAFE OPERATION OF YOUR STROLLER, PLEASE FOLLOW THESE INSTRUCTIONS CAREFULLY. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE ASSEMBLY 1. Remove stroller from box. The front wheels, rear wheels, child tray, and canopies need to be installed prior to use. Fig. 1. 2. To attach the front wheels, unfold stroller as described in the section following. See
ページ4に含まれる内容の要旨
6. To attach the front child tray, push the tray onto the front frame tube, lining up the tray between the protruding rivets. Push backward on the latch until snapped into place. The protruding rivets on the outside of Fig. 5. the frame tube should be between the tray latch. Check that the tray is securely latched in place. Please see figure 5 and 6. 7. To remove front child tray, pull outward on the latches and pull outward Rivet on the tray . Please see figure 7. Please
ページ5に含まれる内容の要旨
WARNING: Avoid serious injury from falling or sliding out. Always use the seat belt. TO SECURE CHILD Fig. 10. T O SECURE FRONT/REAR SITTING CHILDREN 1 The shoulder straps of the 5-point harness has 2 attachment positions. Select the loop position that places the shoulder strap level with, or below the top of the child’s shoulder and feed the shoulder harness under the correct loop. Please see figure 10. Shoulder Strap 2. Carefully place the child in the stroller seat and bring the saf
ページ6に含まれる内容の要旨
TO RECLINE SEATS SEATBACK POSITIONING 1. The front seat has a two position recline. To recline the seat, rotate the recline bar and press backward on the seat back. Please see figure 13. T o place the seat in the upright position, press upward on the seat back while rotating the recline bar. 2. The upright position should be used only for a child that is at least 6 Fig. 13. months old. Note: Seat does not fully recline. 3. To recline the rear seat locate the plastic adjust
ページ7に含まれる内容の要旨
BRAKES WARNING: Always set brakes when the stroller is not being pushed so that the Fig. 17. stroller will not roll away. Never leave stroller unattended on a hill or incline as the stroller may slide down the hill. 1. To engage brakes, apply light downward pressure to the brake lever located Fig. 18. on each rear wheel. The stroller may require slight forward or rearward movement in order to line up the teeth on the brake with each wheel brake cluster . See figure 17. Check
ページ8に含まれる内容の要旨
TO UNFOLD STROLLER Do Not allow children near stroller while unfolding. 1. Release the folding latch, which is located on the right side. See figure 22. 2. Lift up on the stroller handle with both hands until the stroller frame is erect and locked in the open position. The stroller has spring-loaded latches on both sides of the frame. Test that both latches are fully engaged prior to placing your child in the stroller. WARNING: Avoid serious injury from
