ページ1に含まれる内容の要旨
CR9900
3 Band Dual Alarm
Clock Radio
15 0 170 210 240 260
PM
540 600 800 1000 1300 1600
2
1
88 92 96 10 0 10 4 10 6 10 8
R a dio 2 L ocal R a dio 1 L ocal
R a dio 3 IL R IL R IL R
R a dio 4
Au to
B ird s O cean S tream C him es R adio
D immer
Slo w Fa st
C R 9900
S leep A larm /O ff Tim e
Set
D u al A larm C loc k R a dio
Please read this manual before use
CR9900 Instruction Book.pm6 1 24/10/99, 13:44
ROBERTS
Sound for Generations
ページ2に含まれる内容の要旨
12 3 4 5 Controls 15 0 170 210 240 260 PM 15 540 600 800 1000 1300 1600 2 1 14 88 92 96 10 0 10 4 10 6 10 8 R a dio 2 L ocal R a dio 1 L ocal R a dio 3 IL R IL R IL R R a dio 4 13 Au to B ird s O cean S tream C him es R adio D immer 12 Slo w Fa st C R 9900 S leep A larm /O ff Tim e Set 11 D u al A larm C loc k R a dio 10 9 8 7 6 1. Alarm sound switch (on rear) 5. LED dial pointer 9. Sleep button 13. Auto dimmer 6. Fast forward button 10. Slow reverse button 2. Clock display 14. Al
ページ3に含まれる内容の要旨
Controls Low High 1+ 2 2 1 O ff N atural R a dio O n 16 17 18 FM MW LW Tuning Min Vo lum e M ax 19 20 21 22 16. Display brightness switch 19. Volume control 20. Waveband selector 17. Alarm selector switch 18. Function switch 21. Tuning control 22. Battery compartment (on underside) If you need any further advice, please call our Technical Helpline on :- 2 020 8758 0338 (Mon-Fri) CR9900 Instruction Book.pm6 3 24/10/99, 13:44
ページ4に含まれる内容の要旨
Switching on and setting the time ON Before using your clock radio you must first set the correct time. 1. Place the unit on a flat surface. Plug the mains lead into a wall socket and switch on. FM MW LW Tun in g Min Volum e M ax 2. The clock display will flash 12:00. PM 1 2 Alarm /O ff Tim e 3. Press and hold down the Time Set button. Set 4. Whilst holding down the Time Set button press the fast forward (Fast), Slow F ast or slow reverse (Slow) buttons to set the time. Release the buttons when
ページ5に含まれる内容の要旨
Listening to the Radio 1. Turn on the radio by sliding the Function switch to the 'On' position. 150 170 21 0 24 0 26 0 Off N atural R adio On The LED dial pointer will light up indicating that the radio is switched 54 0 60 0 80 0 10 0 0 13 0 0 16 0 0 on. 88 92 96 10 0 10 4 10 6 10 8 Ra d io 2 L oca l Ra d io 1 L oca l Ra d io 3 IL R IL R IL R Ra d io 4 FM MW LW 2. Select the required waveband using the Waveband selector switch. 3. Tune in to the desired station by rotating the Tuning control.
ページ6に含まれる内容の要旨
Setting alarm times The alarms can be set to wake you by either sounds natural or the radio. 1 1+ 2 2 Your alarm clock radio has 2 separate alarms which can be set to activate at different times. Setting alarm 1 1. Slide the Alarm function switch to the ' ' position. 1 Alarm /O ff Tim e 2. Press and hold down the Alarm set button. Set Slow F ast 3. Whilst holding down the Alarm Set button press the fast forward (Fast), or slow reverse (Slow) buttons to set the required alarm time. Release the
ページ7に含まれる内容の要旨
3. Whilst holding down the Alarm Set button press the fast forward Slow F ast (Fast) or slow reverse (Slow) buttons to set the required alarm time. Release the buttons when the correct alarm time is reached. The clock uses a 12 hour display with a PM indicator. Ensure that the correct 12 hour cycle is selected. Checking the Alarm Times 1+ 2 2 1 1. To check alarm 1 time, set the Alarm function switch to the ' ' 1 position. Alarm /O ff Tim e 2. Press the Alarm Set button to display the alarm 1 t
ページ8に含まれる内容の要旨
Setting the alarms to wake to sounds natural 1+ 2 2 1 O ff Natura l R ad io On Your clock radio can be set so as to wake you to any one of the following natural alarm sounds :- Birds, Ocean, Stream, Chimes. The alarm sounds gradually increase in volume reaching maximum level after 10-15 seconds. 1. Set the alarm time as previously described. Set the Function switch to the 'Natural' position. Set the Alarm selector switch to the ' ', S oun ds N a tu ra l 1 ' ' or ' ' position. The corresponding
ページ9に含まれる内容の要旨
Snooze control The radio or sounds natural alarm can be silenced for 7 minutes by pressing the Snooze button. This sequence can be repeated whilst the alarm is sounding. S leep Alarm /O ff Tim e Sleep timer Se t The radio can be set to turn off after a preset time has elapsed. Press and hold down the Sleep button until the desired time is reached (maximum 59 minutes in 1 minute steps). The radio will switch off after the sleep time has elapsed. To cancel the sleep function before the preset time
ページ10に含まれる内容の要旨
General Fuse Do not allow this unit to be exposed to water or steam. It is recommended This apparatus must be protected by a 3A fuse (BS1362) in a 13A plug that the FM band be used wherever possible as better results in terms of (BS1363). If another type of plug is used a 5A fuse should be fitted in the quality and freedom from interference will usually be obtained than on the plug, adaptor or distribution board. MW or LW bands. IF IN DOUBT - CONSULT A QUALIFIED ELECTRICIAN. Mains supply Back-up
ページ11に含まれる内容の要旨
Specifications Circuit Features Power Requirements Loudspeaker 8 ohms Mains AC 230 volts, 50Hz only Output power 350mW Back-up Battery IEC size 6LR61 (6F22, PP3) Aerial System FM Wire Aerial Frequency Coverage FM 87.5 - 108MHz MW Built-in Ferrite aerial MW 525 - 1610kHz LW 150 - 260kHz LW Built-in Ferrite aerial ROBERTS RADIO LIMITED PO BOX 130 MEXBOROUGH SOUTH YORKSHIRE S64 8YT The Company reserves the right to amend the specification without notice. If you need any further advice, please call
ページ12に含まれる内容の要旨
Guarantee This instrument is guaranteed for twelve months from the date of delivery to the original owner against failure due to faulty workmanship or component breakdown, subject to the procedure stated below. Should any component or part fail during this guarantee period it will be repaired or replaced free of charge. The guarantee does not cover: 1. Damage resulting from incorrect use. 2. Consequential damage. 3. Receivers with removed or defaced serial numbers. Procedure: Any claim under thi
