ページ1に含まれる内容の要旨
™
Tour Series TNT Combo
™
Tour Series TKO Combo
Bass Amplifiers
Operating
Manual
www.peavey.com
ページ2に含まれる内容の要旨
Intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Intended to alert the user of the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. CAUTION: Risk of electrical shock — DO NOT OPEN! CAUTION: To reduce the risk of electric shock, do not remove cover. No user serviceable parts insi
ページ3に含まれる内容の要旨
ページ4に含まれる内容の要旨
ページ5に含まれる内容の要旨
ページ6に含まれる内容の要旨
ページ7に含まれる内容の要旨
ENGLISH Tour™ Series TNT & TKO Combos Bass Amplifiers Welcome to Peavey® bass amplification! Peavey bass guitar amplifiers are legendary for their state of the art features, class-leading power, superb tone, and unmatched reliability. Your new Tour series TKO or TNT is no exception. Peavey’s award-winning Tour series amplifiers provide the backbone for countless touring acts worldwide. Peavey TKO and TNT combos have set the standard for bass combo performance over three decades. Your Tou
ページ8に含まれる内容の要旨
TNT Front Panel 1 2 7 8 9 11 13 14 15 3 4 5 6 10 12 16 INPUT 1 may occur to both units. 2 This switch is included so you can choose the appropriate setting for your instrument. Passive pickups have a lower output, so the gain structure of the amplifier is modified to accommodate the different pickup configurations. PRE GAIN 3 This knob controls input level of the instrument. BRIGHT SWITCH 4 This button provides a 10 dB boost to frequencies above 1KHz. To activate, depress th
ページ9に含まれる内容の要旨
TNT Rear Panel 22 23 24 17 18 19 20 21 12 This button turns the compressor on or off. VOLUME 13 This knob controls the overall volume of the amplifier. DDT™ (Distortion Detection Technique) 14 This button prevents power amplifier clipping that can sound bad and damage speakers. The “IN” or enabled for optimum system performance. 15 HEADHPHONE OUTPUT 16 DDT INDICATOR LIGHT for the LED to flash. However, if the LED is constantly illuminated, the gain level ne
ページ10に含まれる内容の要旨
19 TWEETER SWITCH be switched to the OFF position. EXTERNAL SPEAKER OUTPUT 20 Speakon™ type powered output for powering a passive enclosure. FOOTSWITCH JACK 21 - The crunch and compressor buttons MUST be pushed in to operate with the footswitch. EFFECTS LOOP 22 The Send Jack provides a pre amp output that may be used to drive slave amplifiers and external effects processors. The Return Jack provides a power amp input for the last effect in the chain. NOTE: When using t
ページ11に含まれる内容の要旨
Front Panel 8 1 2 3 4 5 6 7 9 10 11 12 13 INPUT 1 may occur to both units. 2 This switch is included so you can choose the appropriate setting for your instrument. Passive pickups have a lower output, so the gain structure of the amplifier is modified to accommodate the different pickup configurations. 3 PRE GAIN This knob controls input level of the instrument. 4 BRIGHT SWITCH This button provides a 10 dB boost to frequencies above 1KHz. To activate, depress the switch to i
ページ12に含まれる内容の要旨
Rear Panel 18 14 15 16 17 19 DDT™ (Distortion Detection Technique) 11 This button prevents power amplifier clipping that can sound bad and damage speakers. The “IN” or enabled for optimum system performance. 12 HEADHPHONE OUTPUT 13 DDT INDICATOR LIGHT for the LED to flash. However, if the LED is constantly illuminated, the gain level needs to be adjusted to prevent possible equipment damage. When the DDT is defeated, the LED becomes a clip indicator. 14 POW
ページ13に含まれる内容の要旨
16 EXTERNAL SPEAKER OUTPUT EFFECTS LOOP 17 The Send Jack provides a pre amp output that may be used to drive slave amplifiers and external effects processors. The Return Jack provides a power amp input for the last effect in the chain. NOTE: When using the unit as a slave power amplifier, the Return Jack should be used as the input. 18 GROUND LIFT position), Ground Lift is engaged. DIRECT INTERFACE (DI) 19 This is a built-in, balanced Direct Interface is used to send a buffer
ページ14に含まれる内容の要旨
™ Tour Series Specifications Tour Series TNT Combo Mains Voltage: Power Output: Input Sensitivity (High Gain): Nominal Input: 616 mVRMS Minimum Input: 34.1 mVRMS Maximum Input: 2.3 VRMS Noise: (maximum signal at input before clipping) > 100 dB below full power @ 8 Ω Input Sensitivity (Low Gain): typically -105 dB Nominal Input: 1.0 VRMS Power Consumption: Minimum Input: 59.3 m VRMS Preamplifier Specifications Maximum Input: 7.2 VRMS 600 W Sett
ページ15に含まれる内容の要旨
™ Tour Series Specifications Tour Series TKO Combo Specifications Not Available At Time Of Press Features and specifications subject to change without notice. All specifications tested with mains voltage maintained at nominal level. 15
ページ16に含まれる内容の要旨
Tour Series TNT 115 Combo Block Diagram 16 A B C D TNT FUNCTIONAL BLOCK DIAGRAM 1 1 CRUNCH CIRCUIT HI PASS HI PASS BRIGHT LO PASS SHELVING EQ PRE GAIN CONTOUR COMPRESSOR FX SEND INPUT EQ 2 Graphic EQ 2 NOTCH LO HI PAD FX RETURN BALANCED DI POST GAIN 2 1 STEREO HEADPHONE JACK 4 3 3 3 GROUND LIFT HEADPHONE AMPLIFIER POWER AMPLIFIER EXT. SPEAKER OUT Peavey Electronics Corp. 4 4 P. O. Box 2898 INTERNAL SPEAKER Meridian, MS 39301 TNT_BLOCK Title: Sheet Title: B Sheet22 of Date: 4-6-2009_10:28 A B C
ページ17に含まれる内容の要旨
Tour Series TKO 115 Combo Block Diagram 17 A B C D 1 1 TKO FUNCTIONAL BLOCK DIAGRAM HI PASS BRIGHT PRE GAIN CONTOUR FX SEND INPUT EQ 2 Graphic EQ 2 NOTCH LO HI PAD FX RETURN BALANCED DI POST GAIN 2 1 STEREO HEADPHONE JACK 4 3 3 3 GROUND LIFT HEADPHONE AMPLIFIER POWER AMPLIFIER EXT. SPEAKER OUT Peavey Electronics Corp. 4 4 P. O. Box 2898 INTERNAL SPEAKER Meridian, MS 39301 Title: TKO_BLOCK Sheet Title: Sheet12 of Date: 2-4-2009_16:05 B A B C D
ページ18に含まれる内容の要旨
NOTES
ページ19に含まれる内容の要旨
ページ20に含まれる内容の要旨
Features and specifications subject to change without notice. ©2010 80305661 Printed in China
