ページ1に含まれる内容の要旨
Operation/Reference Guide
®
Modero CV7
G4 Touch Panels
NXD-CV7 and NXT-CV7
7” Modero Widescreen Video Touch Panels
Last Revised: 10/1/2008
Modero Touch Panels
ページ2に含まれる内容の要旨
AMX Limited Warranty and Disclaimer AMX warrants its products to be free of defects in material and workmanship under normal use for three (3) years from the date of purchase from AMX, with the following exceptions: • Electroluminescent and LCD Control Panels are warranted for three (3) years, except for the display and touch overlay components that are warranted for a period of one (1) year. � Disk drive mechanisms, pan/tilt heads, power supplies, and MX Series products are warranted for a pe
ページ3に含まれる内容の要旨
FCC Information This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received; including interference that may cause undesired operation. Federal Communications Commission (FCC) Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are de
ページ4に含まれる内容の要旨
ページ5に含まれる内容の要旨
Table of Contents Table of Contents Introduction ........................................................................................................1 CV7 Specifications .................................................................................................... 3 CV7 Panels - Connector Layout................................................................................. 6 CV7 Touch Panel Accessories .............................................................................7 NXA
ページ6に含まれる内容の要旨
Table of Contents Recalibrating the batteries............................................................................................ 32 Installation ........................................................................................................33 Unpacking the Panel ............................................................................................... 33 Installing the Internal Components ......................................................................... 33 Installi
ページ7に含まれる内容の要旨
Table of Contents Configuring the Modero’s wireless card for secured access to a WAP200G................. 65 Configuring multiple wireless Moderos to communicate to a target WAP200G........... 69 Configuring a Wired Ethernet Connection.............................................................. 69 Step1: Configure the Panel’s Wired IP Settings...................................................... 69 IP Settings section - Configuring a DHCP Address over Ethernet.................................
ページ8に含まれる内容の要旨
Table of Contents Password Setup Page.................................................................................................. 108 Calibration Page.......................................................................................................... 109 Wireless Settings Page................................................................................................ 109 Wireless Settings Page - Security Options - Overview ................................................ 115 Wire
ページ9に含まれる内容の要旨
Table of Contents Input mask output examples....................................................................................... 194 URL Resources ...................................................................................................... 195 Special escape sequences ........................................................................................... 195 Appendix B - Wireless Technology .................................................................197 Overview of Wireless
ページ10に含まれる内容の要旨
Table of Contents vi 7" Modero Widescreen Touch Panels
ページ11に含まれる内容の要旨
Introduction Introduction ® The NXT/D-CV7 7" Modero Widescreen Color Video Touch Panels (FIG. 1) are the industry’s first widescreen mini-touch panels and are available only through AMX. NXD-CV7 (front view) NXT-CV7 (front view) (FG2258-02) (FG2258-01) FIG. 1 Sample 7" Video Touch Panels These Color Video (CV) panels display NTSC/PAL/SECAM video formats within variable sized ® windows. They include a built-in microphone, speakers, audio/headphone connector, and six NetLinx programmable
ページ12に含まれる内容の要旨
Introduction Key features common to both panels include: CV7 panels are based on the latest display technology and support AMX's 4th generation (G4) graphics which provide higher brightness, richer colors, and deeper contrast. The new G4 graphics technology is supported by the latest AMX TPDesign4 Touch Panel Design program (version 2.6 or higher). CV7 panels display eye-catching images and full-motion video on a large 16:9 image format, while providing a wide 100-degree top-to-bottom vie
ページ13に含まれる内容の要旨
Introduction CV7 Specifications The following table outlines the specifications for the 7" Widescreen Modero panels. Specifications for 7" Widescreen Video Touch Panels Dimensions (HWD): � NXA-RK7: metal rack-mount with black matte finish: (4 RU - rack units high) 6.97" x 19.0" x 0.50" (17.70 cm x 48.26 cm x 1.27 cm) � NXT-CV7 (Fully raised): 6.86" x 7.96" x 6.93" (17.40 cm x 20.20 cm x 17.60 cm) � NXT-CV7 (Fully lowered): 3.70" x 7.96" x 6.93" (9.40 cm x 20.20 cm x 17.60 cm) � NXD-CV7 (wit
ページ14に含まれる内容の要旨
Introduction Specifications for 7" Widescreen Video Touch Panels (Cont.) Front Panel Components: Light sensor: � Photosensitive light detector for automatic adjustment of the panel brightness (a dim room results in a dimmer LCD display, and a bright room results in a brighter LCD display). Note: The light sensor can be adjusted via the Sensor Setup page (page 105). Motion sensor (PIR): � Proximity Infrared Detector to wake the panel when the panel is approached. � Activation range: + 45° (left
ページ15に含まれる内容の要旨
Introduction Specifications for 7" Widescreen Video Touch Panels (Cont.) Rear Panel Components (Side panel location on NXD-Wall Mount panels) (Cont.): Audio/Video connector: � RJ-45 connector for communication of differential audio/video signals to/from the touch panel (panel type dependant). This connector receives Composite video, Stereo (left/right) audio, and microphone audio. � Video is received via the NXA-AVB/ETHERNET Breakout Box. Configuring video windows for playback is done usin
ページ16に含まれる内容の要旨
Introduction Specifications for 7" Widescreen Video Touch Panels (Cont.) Other AMX Equipment �NXT-BP (FG2255-10) (Cont.): - Battery pack for Table Top panels. � NXT-CHG Kit (FG2250-50K) - Battery charger and two NXT-BP batteries � Upgrade Compact Flash (factory programmed with firmware): NXA-CV7CF128M - 128 MB Compact Flash card (FG2116-60) NXA-CV7CF256M - 256 MB Compact Flash card (FG2116-61) NXA-CV7CF512M - 512 MB Compact Flash card (FG2116-62) NXA-CV7CF1G - 1 GB Compact Flash card (FG2116-6
ページ17に含まれる内容の要旨
CV7 Touch Panel Accessories CV7 Touch Panel Accessories The following section outlines and describes both the included accessories and other AMX equipment available for these touch panels. NXA-AVB/ETHERNET Breakout Box (FG2254-10) The NXA-AVB/ETHERNET Breakout Box (FIG. 4) is included as part of the CV7 Kit configuration (panel and box) but can be purchased as a separate accessory. This box facilitates the installation and distribution of video, data, and audio to Modero touch panels located
ページ18に含まれる内容の要旨
CV7 Touch Panel Accessories NXA-AVB/ETHERNET Specifications (Cont.) Rear Components: � 6-pin 3.5 mm Phoenix connector for in-bound (left/right channel) audio � 4-pin 3.5 mm Phoenix connector for out-bound (from microphone) audio � BNC connector (female) for Composite or Chroma (for video-capable panels only) � BNC connector (female) for luminance (for video-capable panels only) � RJ-45 connector for Ethernet input from the control system � 2-pin 3.5 mm Phoenix connector for in-bound power Incl
ページ19に含まれる内容の要旨
NXA-AVB/ETHERNET Breakout Box CV7 Touch Panel Accessories The breakout box unit can be mounted on either a horizontal flat surface or into an equipment rack (by removing the front screws and attaching it to an optional AC-RK). The power supply being used on the NXA-AVB/ETHERNET is dependant on the power requirements of the target touch panel. Use a standard CAT5 Ethernet cable to provide both communication and 10/100 network connectivity between the panel, NXA-AVB/ETHERNET, NetLinx Master, an
ページ20に含まれる内容の要旨
CV7 Touch Panel Accessories �PWR: 2-pin mini-Phoenix connector that connects to a 12 VDC-compliant power supply. This port can be used to provide power to a Modero panel by sending it through the NXA-AVB/ETHERNET (rear power connector through to the front power connector). Wiring the NXA-AVB/ETHERNET for Unbalanced Audio Most domestic audio equipment has unbalanced audio inputs and outputs. This means that the audio output (left, right, or mono) appears on a single wire, and is referenced to
