Demco - Dethmers Manufacturing Company10931 user manual

Summary of the content on the page No. 1

4-03
TP20157,Rev.0
ASSEMBLY
OPERATION
2003 Hyundai Accent
REPLACEMENT PARTS
BOLT TORQUE SPECIFICATIONS READ complete manual CAREFULLY
BEFORE attempting operation.
STANDARD BOLTS:
METRIC BOLTS:
Size Grade Torque Size Torque
5/16" 5 20 ft/lbs. 8mm 22 ft/lbs.
3/8" 5 35 ft/lbs. 10mm 42 ft/lbs.
7/16" 5 56 ft/lbs. 12mm 70 ft/lbs.
1/2" 5 85 ft/lbs. 14mm 95 ft/lbs.
Pin height - 13-1/2
Centers - 23-3/8

2
2
3
3
2
5
3
5
5
6
4
3
3
1
3
1
1
4
9517157 PARTS LIST
REF. PART
NO. NO. QTY. DESCRIPTION
1. 10931 3

Summary of the content on the page No. 2

WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS CAN RESULT IN LOSS OF TOWING VEHICLE CONTROL, SEPARATION OF THE TOW BAR FROM THE TOWING VEHICLE, SEPARATION OF THE TOWED VEHICLE FROM THE TOW BAR, CAUSING SEVERE PERSONAL INJURY, DEATH, OR PROPERTY DAMAGE. IMPORTANT INSTALLATION ITEMS DEMCO products and accessories are intended to be

 installed by professional installers with experience, proper Safety is of utmost importance at all times. There are several items that equipment and the abilit

Summary of the content on the page No. 3

7. Remove two plastic push fasteners from bottom of 3. Remove one nut and one bolt from fasia to fender on facia. each side. 4. Remove two plastic push fasteners from back of facia 8. Remove two plastic push fasteners from each side grill area. underneath facia to inner wheel well extension. 5. Remove two plastic push fasteners from underneath headlight (top of facia) on each side. 9. Pull inner wheel well extension away from fender to gain access to remove one screw, facia to fender, on each si

Summary of the content on the page No. 4

11. Remove three bolts from windshield washer tank, unplug wiring and hose, and set tank aside or tie off. 14. Drill two 5/16
holes, one through each center base R plate tabs. With blue on each 3/8
self-tapping bolts, install through drilled holes. 15. Reinstall windshield washer tank. 12. Remove tie down brackets from each side, three bolts from each side, these will not be reused. 10-1/2” 12-1/4” 16. Cut outside grill bar on facia by measuring from the center bar as shown in picture. NOTE: