Summary of the content on the page No. 1
Instruction Manual
DVD-R155
www.samsung.com
AK68-01317A-01
0 01317A-01-R155-XAA-ENG.indb 1 1317A-01-R155-XAA-ENG.indb 1 2 2007-01-25 오후 4:31:43 007-01-25 오후 4:31:43
Summary of the content on the page No. 2
Getting Started If this equipment does cause harmful interference to radio or Warning television reception, which can be determined by turning the TO REDUCE THE RISK OF ELECTRIC SHOCK, equipment off and on, the user is encouraged to try to correct DO NOT REMOVE THE COVER(OR BACK). the interference by one or more of the following measures: NO USER-SERVICEABLE PARTS ARE INSIDE. REFER • Reposition or relocate the receiving antenna. SERVICING TO QUALIFIED SERVICE PERSONNEL. • Increase the separ
Summary of the content on the page No. 3
Getting Started • Exterior interference such as lightning and static Precaution electricity can affect normal operation of this recorder. If this occurs, turn the recorder off and on again with the POWER button, or disconnect and then reconnect the ▌Important Safety Instructions AC power cord to the AC power outlet. Read these operating instructions carefully before using The recorder will operate normally. the unit. Follow all the safety instructions listed below. • Be sure to remove the
Summary of the content on the page No. 4
Using CD-R/-RW ▌Disc Storage • Use a 700MB(80 minutes) CD-R/-RW disc. If possible, Be careful not to damage the disc because the data on do not use a 800MB(90 minutes) or above disc, as the these discs are highly vulnerable to the environment. disc may not play back. • Do not keep under direct sunlight. • If the CD-R/-RW disc was not recorded as a closed • Keep in a cool ventilated area. session, you may experience a delay in the early • Store vertically. playback time, and all recorded
Summary of the content on the page No. 5
Getting Started • DVD-RW (Video mode) Do not use the following discs! - This is a format that is used for recording data on a • LD, CD-G, CD-I, CD-ROM and DVD-ROM discs should DVD-RW or DVD-R disc. The disc can be played by an not be used in this product. existing DVD player once it has been fi nalized. • Some commercial discs and DVD discs purchased - If a disc that has been recorded in Video Mode by a outside your region may not be playable with this different manufacturer's recorder
Summary of the content on the page No. 6
Contents Getting Started System Setup ■ Warning ................................................................... 2 ■ Initial Setup ..............................................................25 OSD Language Setup .............................................25 ■ Precaution ............................................................... 3 Important Safety Instructions ..................................3 ■ Using the Setup Menu .............................................25 Handling Cautio
Summary of the content on the page No. 7
Getting Started Playback Additional Information ■ Region code (DVD-Video only) ...............................45 ■ Troubleshooting ....................................................... 68 ■ Logos of Discs that can be played ..........................45 ■ Error Message Solutions .........................................70 ■ Disc types that can be played .................................45 ■ Specifi cations ..........................................................72 Discs That Cannot be Playe
Summary of the content on the page No. 8
A variety of functions with an easy-to-use user interface General Features The integrated menu system and the messaging function allows you to perform desired operations both easily and The DVD-R155 allows you to record and play high quality conveniently. With a DVD-RAM or DVD-RW (VR mode) digital video on DVD-RAM/DVD-RW/DVD-R discs. disc, you can edit recorded images, create a playlist, and edit videos in a specifi c sequence according to your requirements. High quality digital audio and v
Summary of the content on the page No. 9
Getting Started Before Reading the Instruction How to use the DVD Recorder Manual ▌Step 1 : Select the disc type Make sure to check the following before reading the user’s manual. This unit can record on the following types of discs. If you want to repeatedly record on the same disc or you Icons that will be used in manual want to edit the disc after recording, select a rewritable DVD-RW or DVD-RAM type disc. Icon Term Defi nition If you want to save the recording without making any This inv
Summary of the content on the page No. 10
▌Step 4 : Playing Unpacking To start playback select the title you want to play from the Title list. ▌Accessories A DVD consists of sections called titles, and sub sections called chapters. Check for the supplied accessories below. During recording, a title is created between two points where you start and stop recording. Chapters will be created automatically when you fi nalize recording on DVD-R/DVD-RW discs in Video mode. ▌Step 5 : Editing a recorded disc Editing a DVD disc is easier tha
Summary of the content on the page No. 11
Getting Started To determine whether your television is compatible, follow the instructions below. 1. Switch your television on. 2. Point the remote control towards the television. 3. Press and hold the POWER button and enter the two-figure code simultaneously corresponding to the brand of your television by pressing the appropriate number buttons. Brand BUTTON BRAND BUTTON AIWA 82 SABA 57, 72, 73, 74, 75 ANAM 10, 11, 12, 13, 14, 15, 16, 17, 18 SALORA 74 BANG & 57 SAMSUNG 01,02,03,04,05,06,07
Summary of the content on the page No. 12
▌Tour of the Remote Control You can control part of another manufacturer’s TV functions with this remote control. • Buttons that can be controlled on your TV : POWER, INPUT SEL., TV VOL (+/-), TV CH ( / ), TV MUTE, 0~9, TV 100+. 9. STOP Button 17 Press to stop a disc or to stop the recording. 10. TV VOL Buttons 1 18 2 Volume adjustment. 3 19 11. MENU Button Brings up the DVD recorder’s setup menu. 20 12. ENTER/DIRECTION Buttons 4 (UP/DOWN and LEFT/RIGHT Buttons) This button functions as
Summary of the content on the page No. 13
Getting Started Description ▌Front Panel 1. POWER Button 8. INPUT SEL. Button Turns the recorder on and off. Selects line input signal in external mode. (AV1, AV2, or DV) 2. AV 2 IN Connects external equipment. 9. REC MODE Button Uses this to set the desired Recording time and 3. DV-IN picture quality. (XP/SP/LP/EP) Connects external digital equipment with a DV jack. (such as a camcorder) 10. REC Button Starts recording. 4. DISC TRAY Opens to accept a disc. 11. STOP Button Stops di
Summary of the content on the page No. 14
▌Rear Panel 1. DIGITAL AUDIO OUT(OPTICAL) 6. COMPONENT VIDEO OUT (excellent video Connects to an amplifi er having a digital optical quality) audio input jack. Connects to equipment having Component video input jacks. 2. DIGITAL AUDIO OUT (COAXIAL) Connects to an amplifi er having a digital coaxial 7. AV 1 AUDIO IN audio input jack. Connects the output of external equipment using audio cables 3. AV AUDIO OUT Connects to the audio input of external 8. AV 1 VIDEO IN equipment
Summary of the content on the page No. 15
Connecting & Setting Up Connecting & Setting Up Step 1 : Connecting HDMI/DVI to a TV If your TV has a HDMI/DVI input, connect an HDMI/DVI cable to your TV. You will enjoy the best quality image and sound. ▌Connecting to a TV with an HDMI Jack Using an HDMI- HDMI cable (not included) connect the HDMI OUT jack on the rear of the DVD Recorder to the HDMI IN jack of your TV. Press the input selector on your TV remote control until the HDMI signal from the DVD Recorder appears on your TV screen. ■
Summary of the content on the page No. 16
▌Connecting to a TV with a DVI Jack Using an HDMI-DVI cable (not included), connect the HDMI OUT terminal on the rear of the DVD Recorder to the DVI IN terminal of your TV. An HDMI to DVI connection requires a separate audio connection. Using the audio cables, connect the AUDIO (red and white) OUT terminals on the rear of the DVD Recorder to the AUDIO (red and white) IN terminals of your TV. Turn on the DVD Recorder and TV. Press the input selector on your TV remote control until the DVI sign
Summary of the content on the page No. 17
Connecting & Setting Up Step 2 : Connecting the Video Cable There are several ways to connect your DVD Recorder. Select one of the video connections on the following pages. You must use one of the following audio/video connections on this unit. ▌ Connecting to Component Video Input Jacks (Y,P ,P ) B R 1. Connect the Component video cables(not supplied) ■ Compared to standard interlaced video, between the COMPONENT OUT(Y,PB,PR) jacks on the progressive scan doubles the amount of video DVD
Summary of the content on the page No. 18
▌ Connecting to an S-Video Input Jack Connect an S-Video cable(not supplied) between the S-VIDEO OUT jack on DVD Recorder and S-VIDEO IN jack on your TV (or AV amplifi er). • You will enjoy high quality images. S-Video separates the picture element into black and white (Y) and color ■ S-Video or Component video outputs are available (C) signals to present clearer images than regular video only if your TV supports S-Video input or Component input mode. This connection outputs the 480i resol
Summary of the content on the page No. 19
Connecting & Setting Up ▌ Connecting to a Video Input Jack Connect a video(yellow) cable between the VIDEO(yellow) OUT jack on DVD Recorder and VIDEO(yellow) IN jack on the TV (or AV amplifi er). • You will enjoy normal quality images. This connection outputs the 480i resolution to your TV. • Connect the audio cables(white and red) between the AUDIO OUT jacks on the DVD Recorder and AUDIO IN jacks on your TV(or AV amplifi er). (See pages 20~22) English - 19 0 01317A-01-R155-XAA-ENG.indb 19
Summary of the content on the page No. 20
Step 3 : Connecting the Audio Cable Select one of the Audio connections on the following pages. ▌ Connecting to your TV This connection will use your TV’s speakers. English - 20 01317A-01-R155-XAA-ENG.indb 20 01317A-01-R155-XAA-ENG.indb 20 2 2007-01-25 오후 4:33:02 007-01-25 오후 4:33:02 Connecting & Setting Up
