Bosch Appliances MIC400 user manual

Summary of the content on the page No. 1

MIC400 Quick Start Guide



CAUTION: TO REDUCE THE RISK OF ELECTRICAL SHOCK,

DISCONNECT POWER SUPPLY BEFORE OPENING THE POWER
SUPPLY UNIT.
POWER DISCONNECT: POWER SUPPLY UNITS HAVE POWER
SUPPLIED WHENEVER THE POWER CORD IS INSERTED INTO THE

POWER SOURCE






WARNING: INSTALLATION SHOULD BE CARRIED OUT BY QUALIFIED

PERSONNEL ONLY IN ACCORDANCE WITH THE APPLICABLE LOCAL
CODES.
BOSCH SECURITY SYSTEM ACCEPTS NO LIABILITY FOR ANY
DAMAGES OR LOSSES CAUSED DUE T

Summary of the content on the page No. 2

Do not manually back drive the pan or tilt axis by hand. Back driving may strip teeth off the internal gears and in so doing will void the warranty. M8 Stainless steel nuts, bolts and washers should be used to secure the base to the mounting surface. Suitable sealant or a gasket should be used between the camera base and the mounting surface. Ensure that the 12 pin connector is located into the camera base plug and that the lock ring is tightened. Ensure that the base compartment

Summary of the content on the page No. 3

Black Tamper Switch HD3-10 Tamp Sw Orange Wash HD3-11 Wash Grey 0v Tamper Switch. HD6-1 Brown 0v Wash HD6-2 IR lamp, Heater or Speaker Option Grey IR Lamp + or Speaker + HD6-1 IR + or Heater + Brown IR Lamp- or Speaker - HD6-2 IR - or Heater - External Connections to the Power Supply Unit MAINS TELEMETRY Live HD1-1 Signal Function Telemetry Signal Name HD4 or HD5 Neutral HD1-2 RS485 + to camera RXB Pin 1 Earth HD1-3 RS485 – to camera RXA Pi