Crimestopper Security Products SV-6600 I/R user manual

Summary of the content on the page No. 1

Model SV-6600 I/R Reverse Camera



SAFETY PRECAUTIONS
z Make sure to read the “Installation Manual” for safety precautions before installing
unit or accessories.
z Please make sure the vehicle is well parked in a safe place. Make sure that the engine
and the power are switched off.
z Avoid installation outdoors during rain or thunder storms.
z The instructions presented in this manual are based on the passenger seat at the right of
the driver’s seat. In an opposite

Summary of the content on the page No. 2

Compilation and Publication Notice Under the supervision of PEC, this manual has been compiled and published, covering the latest description and specification. The contents of this manual and the specifications of this product are subject to change without notice. PEC reserves the right to make changes without notice in the specification and material contained herein and shall not be responsible for any damages (including consequential) caused by reliance on the materials presente

Summary of the content on the page No. 3

INSTALLATION Step 1: Testing the Camera (Bench Testing) 1. Prepare two sets of DC 11-13V batteries for running a bench test to make sure the camera functions are working properly (before you actually install the camera into your vehicle). 2. Refer to the wiring diagram (4.1-3) the camera and the monitor each have to have their own power source, DO NOT connect with the same battery. 3. When connecting the 20’ cable, make sure all connectors have been solidly co

Summary of the content on the page No. 4

Step 3: Camera Installation 1. Determine the proper location on your vehicle to install the camera. 2. Make sure the area surface is clear, clean and flat. 3. Install the mounting bracket. (Refer to Diagram 3.1-1) 4. Assemble the camera inside of the mounting bracket (Refer to Diagram 3.1-2) 5. Adjust the viewing direction and angles to attain the best viewing (Refer to Diagram 3.1-3) Diagram 3.1-1 Diagram 3.1-2 Diagram 3.1-3 ④ Step 4: Wire Connection 1. Conne

Summary of the content on the page No. 5

Video output to monitor I/R Camera Black, Ground Red, power input 12V (+) from reverse light 12 PIN (M) 4 PIN (M) 4 PIN (F) 12 PIN (F) Diagram 4.1-3 2. In most cases and as a time saver, connect the camera power wire at the rear of vehicle behind the reverse lights. The red power wire line goes to the reverse light + 12 V and the black wire to ground. 3. Please carefully choose a path to route and hide the camera cable. Drilling a cable hole if necessary.

Summary of the content on the page No. 6

Technical Specifications The following table defines the technical specifications for the SV-6600 I/R Camera. NTSC: 512(H)*492(V) ; PAL:512(H)*582(V) Sensor 1/4 inch -type CCD Sensor Signal processor Digital signal processor (D.S.P) Resolution >250,000 pixels Digitalis 10 bit A/D Converter Sync. System Internal Resolution More than 330 TV line Minimum illumination 1.0 LUX / F2.8 S/N ratio More than 48dB Gamma correction 0.45 Gain control AGC Wh