American Dynamics KT-400 Expansion Module KT-MOD-INP16 user manual

Summary of the content on the page No. 1

KT-MOD-INP16
KT-400 Expansion Module 16-Zone Input with SPI Cable Install Sheet


1. Introduction
3.2. Mounting
The KT-MOD-INP16 is an input module that adds up to 16 zones
The KT-MOD-INP16 can be installed inside a compatible cabinet
to the KT-400 controller. The module supports daisy chaining;
(KT-MOD-CAB or KT-400) or mounted in a dry and secure
you can interconnect up to 15 KT-MOD-INP16 modules for a total
location at less than 1 m (3 ft) from the KT-400.
of 240 external inputs per

Summary of the content on the page No. 2

KT-MOD-INP16 KT-400 Expansion Module 16-Zone Input with SPI Cable Install Sheet 4. Configurations with Jumpers There are 3 jumpers available to configure the KT-MOD-INP16. The jumper settings apply to ALL 16 inputs at the same time. Note: Jumper JP4 is for future use. DRY (without end-of-line resistor): In a simple NC dry contact configuration, the secure state is given when a short is detected. The voltage becomes lower than the Level 1 threshold value (1.1V). The alarm s

Summary of the content on the page No. 3

KT-MOD-INP16 KT-400 Expansion Module 16-Zone Input with SPI Cable Install Sheet FCC & IC COMPLIANCE STATEMENT CAUTION: Changes or modifications not expressly approved by Kantech could void your authority to use this equipment. This equipment generates and uses radio frequency energy and if not installed and used properly, in strict accordance with the manufacturer’s instructions, may cause interference to radio and television reception. It has been type tested and found to comply with the l