Summary of the content on the page No. 1
PLANET ENW-9503/9504 PCI Fast Ethernet Adapter
User's Manual
Thank you for purchasing our product!
This guide contains information to install and configure the 10/100 Fast Ethernet PCI
Adapter for proper operation. The 10/100 Fast Ethernet PCI Adapter is a 32-bit
10/100 Mbps Ethernet network interface card for PCI local bus-compliant PCs. It
supports bus mastering architecture and auto-negotiation which make it possible to
use one common RJ-45 port and standard twisted-pair cabling fo
Summary of the content on the page No. 2
Hardware Description The ENW-9504 10/100 Fast Ethernet PCI Adapter has a RJ-45 connector and one LED indicator. LED Indicator The adapter provides LED indicator for monitoring network conditions. This section describes the function of LED. LED Color Status Description Off This card is not connect to the network. On This card is connect to the network. LNK/ACT Green Indicate data is transferring and receiving via the Blink port. Off This card is work with half-d
Summary of the content on the page No. 3
3. Connect your adapter to the network. Connect the adapter to the network using twisted-pair cabling with an RJ-45 connector. 4. Power on the PC. After hardware installation has been completed, power on the computer. 5. Change your computer's BIOS setup to enable Bus Master mode and select an IRQ setting. The setup procedure and the terminology used when referring to Bus Master mode and IRQ parameters may vary with your computer's BIOS. Some BIOS have Bus Master mode enabled for
Summary of the content on the page No. 4
Operating Environment Power Consumption : 100BASE-TX +5V/360mA (maximum) 10BASE-T +5V/350mA (maximum) Temperature : 0C to 55C/32F to 131F Humidity : 10% to 90% (Non-condensing) Size : 123mm x 65mm Hardware Certification Certification : CE Mark Emissions
Summary of the content on the page No. 5
Windows NT 4.0 NDIS 5.0 Drivers Windows 98, 98SE Windows 2000 Windows XP The publisher assumes no responsibility for errors that may appear in this document. Nor does it make any commitment to update the information it contains. All brand and product names mentioned are trademarks or registered trademarks of their respective companies. *This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may
Summary of the content on the page No. 6
You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment. SAFETY INSTRUCTIONS 1. Please read these safety instructions carefully. 2. Please keep this User's Manual for later reference. 3. Please disconnect this equipment from AC outlet before cleaning. Don't use liquid or sprayed detergent for cleaning. Use moisture sheet or cloth for cleaning. 4. For pluggable equipment, the so
Summary of the content on the page No. 7
e. The equipment has dropped and damaged. f. If the equipment has obvious sign of breakage. 15. DO NOT LEAVE THIS EQUIPMENT IN AN ENVIRONMENT UNCONDITIONED: STORAGE TEMPERATURE ABOVE60(140),IT MAY DAMAGE THE EQUIPMENT. 16. The sound pressure level at the operators position according to IEC 704-1: 1982 is equal or less then 70dB(A).