Chief Manufacturing PCM Series user manual

Summary of the content on the page No. 1

INSTALLATION INSTRUCTIONS
Instrucciones de instalación Istruzioni di installazione
Installationsanleitung Installatie-instructies
Instruções de Instalação Instructions d´installation
Plasma Ceiling Mount
Spanish Product Description
German Product Description
Portuguese Product Description
Italian Product Description
Dutch Product Description
French Product Description
PCM SERIES

Summary of the content on the page No. 2

PCM SERIES Installation Instructions DISCLAIMER WARNING: Failure to read, thoroughly understand, and Milestone AV Technologies, Inc., and its affiliated corporations follow all instructions can result in serious personal injury, and subsidiaries (collectively, "Milestone"), intend to make this damage to equipment, or voiding of factory warranty! It is the manual accurate and complete. However, Milestone makes no installer’s responsibility to make sure all components are claim that the

Summary of the content on the page No. 3

Installation Instructions PCM SERIES TOOLS REQUIRED FOR INSTALLATION AND PARTS 3/16" (provided) A (1) B (1) I/M C (1) D (6) x1 DIMENSIONS Figure 1 3

Summary of the content on the page No. 4

PCM SERIES Installation Instructions Mount Assembly and Installation Display Installation 1. Fold tube out until tube mounting bracket rests against faceplate mounting bracket. (See Figure 2) If the mounting pattern of the display being installed is a VESA 2. Secure tube to faceplate mounting bracket using 3/16" hex standard 200 x 200 pattern the mounting buttons can be wrench (C) and two 5/16-18 x 1/2" button head cap screws installed directly to the back of the display. If the display ha

Summary of the content on the page No. 5

Installation Instructions PCM SERIES Display Roll Adjustment To adjust display roll: 1. Loosen 3/8-16 Nylock nut. (See Figure 7) To use as a 2. Adjust faceplate to desired position. (See Figure 7) more permanent 3. Tighten 3/8-16 Nylock nut. (See Figure 7) lock, remove pin 1 and nuts and move to lower holes 2 1 A padlock or bolt may be placed through latch holes Figure 5 2 3 Adjustments The PCM is designed to accommodate 5" of display height adjustment, 4º right and left display roll adjust

Summary of the content on the page No. 6

PCM SERIES Installation Instructions 6

Summary of the content on the page No. 7

Installation Instructions PCM SERIES 7

Summary of the content on the page No. 8

PCM SERIES Installation Instructions Chief® and ClickConnect™ are trademarks of Milestone AV Technologies, Inc. All rights reserved. USA/International A 8401 Eagle Creek Parkway, Savage, MN 55378 P 800.582.6480 / 952.894.6280 F 877.894.6918 / 952.894.6918 Europe A Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands Chief Manufacturing, a division of P +31 (0)40 2668620 Milestone AV Technologies F +31 (0)40 2668615 Asia Pacific A Room 24F, Block D, Lily YinDu International Building LuoGang, BuJi T