Summary of the content on the page No. 1
Installation Guide
MMD85
8.5" OVERHEAD LCD
VIDEO MONITOR
WITH DVD PLAYER
Installation Guide
1
Summary of the content on the page No. 2
Important Notice An LCD panel and/or video monitor may be installed in a motor vehicle and visible to the driver if the LCD panel or video monitor is used for vehicle information, system control, rear or side observation or navigation. If the LCD panel or video monitor is used for television reception, video or DVD play, the LCD panel or video monitor must be installed so that these features will only function when the vehicle is in “park” or when the vehicle’s parking brake is applied. An LCD p
Summary of the content on the page No. 3
Installation Guide MATERIALS INCLUDED IN THIS PACKAGE: 1) MMD85 Video Monitor with DVD player (P/N136D3586) (1 pc) 2) A/V Adapter Cable (112B3227) (1 pc) 3) 2 Pin Power Wire Harness with choke (P/N112B3370) (1 pc) 4) Hardware Package:- ♦ #8 x 3/4” Self Drilling Screws (4 pcs) ♦ #8 Washers (4 pcs) 5) Dome light Harness (112B3110) (1 pc) 6) Remote Control (136B3591) (1pc) 1. 2. 3. CHOKE 6. 13 2 4 5 6 79 8 0 4. 3 5 ENTER 5. TOOLS REQUIRED: #2 Phillips Screwdriver #1 Phillips Screwdriver Utility or
Summary of the content on the page No. 4
VEHICLE PREPARATION: 1) Locate an accessory power source (+12v when key is in the ACC. and run positions, and 0v when key is off). Also find a location that will provide a good grounding point. Generally, this wire can be found at the ignition switch or fuse-box. 2) The mounting method and location will vary from vehicle to vehicle, so this manual will only focus on the installation of the video monitor and related accessories. 3) Generally, the best location for the video monitor is where the
Summary of the content on the page No. 5
Installation Guide MOUNTING THE VIDEO UNIT Roof Roof support Headliner 5"x9"x3/4" Plywood Block or Optional VOHBKT (4) #8x1" self drilling screws (not supplied) Video unit (4) #8 Flat washers (supplied) (4) #8x3/4" self tapping screws ( supplied) 5
Summary of the content on the page No. 6
CHOKE MMD85 Red/Black (Lamp On) Dome Light Violet/Brown (Lamp Auto) Power Source Black/Red (Lamp Common) Line In-V (Yellow) Line In-R (Red) Line In-L (White) Audio Video Input Line Out-V (Yellow) Line Out-R (Red) Audio Video Output Line Out-L (White) To Secondary AV Monitor Power Harness RCA-Female Line Out INPUT Item # 3 12 VDC Power and Ground Right and Left VIDEO TO OPTIONAL LINE ADDITIONAL OUT Auxillary MONITOR Patch Cord VIDEO RCA Male to Male video display (Yellow) Line Video Ou
Summary of the content on the page No. 7
Installation Guide CONNECTING THE DOME LIGHTS The dome lights in the video monitor require three connections to the vehicle's wiring. There are two common types of dome light circuits used, positive or negative switched. Positive systems supply volt- age to the interior lights to turn them on, negative switched systems apply ground to illuminate the bulbs. To determine which system you have you must locate the wires at the dome light. On a positive switched system, with all the doors closed a
Summary of the content on the page No. 8
Negative Switched Dome lighting Red / black - Lamp on To 3 pin Black / red - Lamp common connector Violet / brown - Lamp Auto To constant Factory Dome light circuit To constant Factory Door ajar switch or Body Troubleshooting: SYMPTOM: REMEDY: No power at Video Monitor -Verify +12 VDC on Red wire at 2 pin Power Harness behind video monitor. Verify ground connection with continuity test from known good ground to black wire at 2 pin Power Harness Power but no video or -Verify that the correct s
Summary of the content on the page No. 9
Installation Guide 128-7251 © Copyright 2004 AEC 150 Marcus Blvd. Hauppauge, NY 11788 9
