Audiovox 1181291 user manual

User manual for the device Audiovox 1181291

Device: Audiovox 1181291
Category: Car Video System
Manufacturer: Audiovox
Size: 1.3 MB
Added : 10/24/2013
Number of pages: 12
Print the manual

Download

How to use this site?

Our goal is to provide you with a quick access to the content of the user manual for Audiovox 1181291. Using the online preview, you can quickly view the contents and go to the page where you will find the solution to your problem with Audiovox 1181291.

For your convenience

If looking through the Audiovox 1181291 user manual directly on this website is not convenient for you, there are two possible solutions:

  • Full Screen Viewing - to easily view the user manual (without downloading it to your computer), you can use full-screen viewing mode. To start viewing the user manual Audiovox 1181291 on full screen, use the button Fullscreen.
  • Downloading to your computer - You can also download the user manual Audiovox 1181291 to your computer and keep it in your files. However, if you do not want to take up too much of your disk space, you can always download it in the future from ManualsBase.
Audiovox 1181291 User manual - Online PDF
Advertisement
« Page 1 of 12 »
Advertisement
Print version

Many people prefer to read the documents not on the screen, but in the printed version. The option to print the manual has also been provided, and you can use it by clicking the link above - Print the manual. You do not have to print the entire manual Audiovox 1181291 but the selected pages only. paper.

Summaries

Below you will find previews of the content of the user manuals presented on the following pages to Audiovox 1181291. If you want to quickly view the content of pages found on the following pages of the manual, you can use them.

Abstracts of contents
Summary of the content on the page No. 1




50 - 0210F - 002 SERIES 1181291
50 - 0210F - 003 SERIES 1181292
50 - 0210F - 004 SERIES 1181293





























3. T -
6. 1/4” hex socket bit

9. Aud

FOR USE IN VEHICLES WITH FACTORY INSTALLED
OVERHEAD CONSOLE ONLY.




- 0019E
Printed in the U.S.A
INSTALLATION INSTRUCTION # 44
July

Summary of the content on the page No. 2

Description 4 1 ,TEK,Z1 SCREW, # 8 X 2 1/2" PFH ,ZII 3 2 4 3 1 4 1 5 1 6 REAR LIGHT TRIM 1 7 PLYWOOD, 3/8" X 6" X 14" 1 8 SCREW, # 6 X 1/2" 10 9 - 32 X 3/4" 6 10 4 11

Summary of the content on the page No. 3

1. console together. See Figure 2. See Fig. 2. 3 FIGURE 2 clip on trim ring and separate console from trim ring. Unsnap the wiring connector secured to plastic pins. chisel, carefully remove the head of the (10) ten Using a small through console in some areas. Do not drill deeper than 1/2" or you may drill CAUTION: center of the (10) ten plastic pins which secure he trim ring. Using a 7/64” drill b

Summary of the content on the page No. 4

3. shoulder. 4 FIGURE 4 FIGURE 3 See Figure 4. plastic pins flush with the Using a razor knife, carefully trim the (10) ten Discard trim ring. See Figure 3.

Summary of the content on the page No. 5

Caution: Before Cut only where indicated. 5 FIGURE 6 See Figure 6. onentry above headliner. other comp cutting material, check for wiring or OEM pod retainer arms. light opening and the front openings for 5. Cut the headliner material between dome FIGURE 5 assembly if applicable. See Figure 5. the center dome light screw near safe place. Remove the OEM ground wiring and set control head a

Summary of the content on the page No. 6

the rear pod retainers. Slide bracket to rear of (4) # 8 x 3/4" HWH TEKS screws 6 FIGURE 8 using one of the screws. See Figure 8. 2 ). Secure O.E.M. ground wire (if applicable) ( item 1 pg 7. Secure bracket to sheetmetal frame using four FIGURE 7 recessed area. See Figure 7. vehicle until flange contacts rear edge of previously used to support inner roof openings mounting tabs with th

Summary of the content on the page No. 7

ure 9. 9. Remove and retain the two ( 2 ) door 7 FIGURE 10 scuff plates on driver’s side. See Fig. 10. FIGURE 9 See Fig and relocate toward center of vehicle. compass, unsnap the wire harness clip 8. If vehicle is equipped with an electronic

Summary of the content on the page No. 8

10. 11. 12. 13. rotate 90 °. 8 FIGURE 12 (item 8 pg 2 ) through opening and Insert the 6” x 14” piece of plywood vehicle. See Figure 12. that the 4” width is centered in the that is 4” wide x 8” long. Make sure a razor knife, carefully cut an opening toward rear of vehicle. Using opening Measure 7” from rear A/C control FIGURE 11 headliner and lay aside. See Figure 11. from side of vehicl

Summary of the content on the page No. 9

• - • Down the B - • st source. Ground the black negative lead to the chassis. • 15. Re - - - torque 9 lower seat belt. to manufacturer’s recommended setting. Replace trim pieces previously removed from upper and upper handle, and door trim. Reattach the seat belt bolt and re pillar cover, install the B FIGURE 13 instructions inc

Summary of the content on the page No. 10

1. 2. Secure the O.E.M. console recess using (10) ten # 6 X 1/2" screws Caution: Do not overtighten 10 FIGURE 15 screws. alternately on each side. See figure 15. beginning with the front center, rear center, then ( item 9 pg 2 ). Start all screws before tightening compartment assembly into the FIGURE 14 area. See figure 14. hinge arms through the slots in the recess pocket th

Summary of the content on the page No. 11

1. Cons the O.E. orange wires. Do not use O.E. - 32 X 3/4" 4. Secure front of console using two (2 ) # 8 X 1 Caution: Do not two ( 2 ) # 8 x 1 1/4" PWH screws (item 3 pg Caution: Do - 11 Figure 18 installed in step 3. 32 X 3/4" screws previously 6. Tighten 6 roof may occur. not overtighten screws or damage to vehicle le area. See Figure. 17. 2) in dimp 5. Open sunglass holder on O.E. console. Install may occur. overtighten

Summary of the content on the page No. 12

with video system. your area. Note: Make sure that wires do not get pinched between bosses on video system and (4) 6 - 32 X 3/4" screws (item 10 pg 2) and four Caution: Do not overtighten screws. 12 . rear ed Caution: 13. 14. Attach O.E. wiring to rear A/C control head. Insert 12 transmitter, refer to the


Alternative user manuals
# User manual Category Download
1 Audiovox 50-0244x-019 SERIES User manual Car Video System 1
2 Audiovox D1620 User manual Car Video System 1
3 Audiovox FLO TV 128-8714A User manual Car Video System 1
4 Audiovox Mobile Video 128-8565A User manual Car Video System 1
5 Audiovox MOVIES 2 GO MMD850 User manual Car Video System 4
6 Audiovox VOD10 User manual Car Video System 5
7 Audiovox VOH684 User manual Car Video System 0
8 Audiovox VOH681P User manual Car Video System 1
9 Audiovox 50-0244x-001 SERIES User manual Car Video System 2
10 Audiovox 1181292 User manual Car Video System 1
11 Audiovox Drop Down TV / Video Monitor VOH703 User manual Car Video System 1
12 Audiovox 128-5495E User manual Car Video System 2
13 Audiovox 27PL User manual Car Video System 1
14 Audiovox FLO TV AVXMMF1 User manual Car Video System 1
15 Audiovox MMD7HRG User manual Car Video System 1
16 Dynabrade 13400, 13410, 13411 User manual Car Video System 1
17 Sony LMD-1950MD User manual Car Video System 36
18 Sony DVX-11B User manual Car Video System 28
19 Sony NSR-1100 User manual Car Video System 5
20 Sony CDX91 User manual Car Video System 5