Clam Corp Fish Trap Scout 8244 user manual

Summary of the content on the page No. 1

Mo de l No.
- 8244 -
p/ n 1 0 83 2 1

Specifications
Height: 58” (20” packed)
▪
Width: 36”
▪
▪ Depth: 80” (48” packed)
Weight: 47 lbs.
▪
Instruction p/n 102475
▪
















- Clam Customer Servi ce Information -

NOTICE!! Once used, this shelter cannot be returned to the store. If you have a
warranty claim, have your sales receipt ready and contact Clam Corporation
Customer Service by email inquiry or direct by calling:
Customer Service Hrs: - 9am to 4p

Summary of the content on the page No. 2

- Parts Li st - ITEM NO. PART NUMBER DESCRIPTION QTY. 1 101080 SCREW, 1/4-20 X 1.25 8 2 101081 WASHER, 1/4 FLAT 16 3 101082 NUT, 1/4-20 THIN NYLOCK 26 4 101083 TUBE SPACER CAP 8 5 101088 SCREW, 1/4-20 X 0.75 14 6 101140 SCOUT PORCH HOOP 1 7 101043 LH CANOPY BRACKET 1 8 101609 SEAT RAIL SUPPORT BRACKET 2 9 101042 RH CANOPY BRACKET 1 10 101141 SCOUT CANOPY HOOP 3 11 102494 BASE, SCOUT 08-09 1 12 101095 TOW ROPE, 3/8 DIA X 9 FT 1 13 101096 U-CHANNEL MOLDING, SCOUT 1 14 101148 SC

Summary of the content on the page No. 3

- Parts Di agram - 3

Summary of the content on the page No. 4

- Step One - 4

Summary of the content on the page No. 5

- Step Two - 5

Summary of the content on the page No. 6

- Step Three - Scout Base (p/n 102494) 6

Summary of the content on the page No. 7

- Step Four - 7

Summary of the content on the page No. 8

- St ep Five - 8

Summary of the content on the page No. 9

- Step Si x - 9

Summary of the content on the page No. 10

- Step Seven - 10

Summary of the content on the page No. 11

- Step Ei ght - Scout Tent (p/n 102432) 11

Summary of the content on the page No. 12

- Step Nine - 12

Summary of the content on the page No. 13

- Step Ten - If everything still looks good, secure the Molding with the #6 Phillips Screws. Evenly space them about every ten to twelve inches, and also put a screw in the center of both corners. Since there aren’ t any predrilled holes, it's advisable to use a powered driver for this operation. 13

Summary of the content on the page No. 14

- Set -up & Take Down - Set-Up - Rotate the hoop poles forward, then position and expand the adjustable spreader pole in the rear of the unit to take the slack out of the tent. Tighten the tension knob on the rear adjustable spreader pole to hold its position. Take-Down - Go around the shelter and tuck the tent material in between the rested hoops to keep the tent from spilling out of the base and contacting the ground. Also make sure that the tent is clear of the canopy brackets edges