Clam Corp Fish Trap X4 8235 user manual

Summary of the content on the page No. 1

Mo de l No.
- 8 2 3 5 -

( p/ n 1 0 83 2 7 )

Specifications
Height – 75” (24” packed)
▪
Width - 75 inches
▪
▪ Length – 144” (45” packed)
Weight - 175 lbs
▪
Instruction p/n 102484
▪


















- Clam Customer Servi ce Information
-

NOTICE!! Once used, this shelter cannot be returned to the store. If you have a
warranty claim, have your sales receipt ready and contact Clam Corporation
Customer Service by email inquiry or direct by calling:
Customer

Summary of the content on the page No. 2

- Parts List – Item Qty p/n Description 1 16 101048 Slide Block 2 36 101081 1/4" Flat Washer 3 46 101082 1/4" Thin Locknut 4 10 101088 1/4" Dia. X 3/4" Long Phillips Screw 5 8 101146 1-1/2" X 1-3/4" Aluminum Angle X 9" Long 6 16 101147 #10 X 1" Long Phillips Screw 7 1 101249 Tow Rope 8 4 101399 Seat Swivel Assembly 9 8 101429 1-1/8" Dia. Tube Cap 10 32 101470 1/4" Dia. X 1/2" Long Hex Head Screw 11 8 101486 1/4" Dia. X 1-3/4" Long Phillips Sc

Summary of the content on the page No. 3

- Parts Diagram (Seating) - 3

Summary of the content on the page No. 4

- Parts Diagram (Shelter) - 4

Summary of the content on the page No. 5

- Step 0ne - 5

Summary of the content on the page No. 6

- Step Two - 6

Summary of the content on the page No. 7

- Step Three - 7

Summary of the content on the page No. 8

- Step Four - 8

Summary of the content on the page No. 9

- Step Five - 9

Summary of the content on the page No. 10

- Step Si x - 10

Summary of the content on the page No. 11

- Step Seven - 11

Summary of the content on the page No. 12

- Step Ei ght - X4 T ent (p /n 10 2438) 12

Summary of the content on the page No. 13

- Step Nine - 13

Summary of the content on the page No. 14

- Seating Installation - Angle the seat assembly slightly while placing the bottom lip of the front seat bracket under the outside edge of the base lip. Carefully rotate the complete seat assembly down onto the opposite base ledge, capturing the ledge with the rear seat bracket. 14

Summary of the content on the page No. 15

- Rope Installation - Included is a tow rope for those not planning to install the optional tow hitch assembly (available for purchase at www.clamcorp.com.). Two install the tow rope, drill two 1/2" holes about midway in the sloped front of the base. Knot the ends of the tow rope after routing through the drilled holes. - Safety Instructions - Please fully understand and follow all safety instructions as outlined. Failure to do so could result in severe injury or death. ▪ Do no