Summary of the content on the page No. 1
INSTALLATION INSTRUCTIONS
AND USE AND CARE GUIDE
Architect™ Series Outdoor Built-In Side Burner
Model KSBN220SSS
Quick Reference
Table of Contents:
Pages
2 Outdoor Built-In Side Burner Safety
4 Installation Requirements
4 Tools and Parts
4 Location Requirements
4 Product Dimensions
5 Enclosure Cutout Dimensions
IMPORTANT:
5 Gas Supply Requirements
Read and save these instructions.
6 Architect™ Series Built-In Outdoor Side
Burners
6 L.P. Gas Conversion
IMPORTANT:
Installer: Leave In
Summary of the content on the page No. 2
OUTDOOR BUILT-IN SIDE BURNER SAFETY FOR YOUR SAFETY FOR YOUR SAFETY If you smell gas: • Do not store or use gasoline or other flammable vapors and liquids in the • Shut off gas to the appliance. vicinity of this or any other appliances. • Extinguish any open flame. • An LP cylinder not connected for use • Open lid. shall not be stored in the vicinity of this • If odor continues, immediately call your or any other appliance. gas supplier or your fire department. WARNING: For your safety, the
Summary of the content on the page No. 3
IMPORTANT SAFETY INSTRUCTIONS 1. Do not install portable or built-in grills in or on a recreational 11. The L.P. gas supply cylinder to be used must be: vehicle, portable trailer, boat or in any other moving installa- • constructed and marked in accordance with the tion. Specifi cation for L.P. Gas Cylinders of the U.S. Department 2. Always maintain minimum clearances from combustible of Transportation (DOT) or the National Standard of Canada, construction, see “Location Req
Summary of the content on the page No. 4
INSTALLATION REQUIREMENTS WARNING T ools and Parts Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools needed Fire Hazard • Level Do not use side burner near combustible materials. • Small flat-blade screwdriver Do not store combustible materials near side burner. • Flat-blade screwdriver Doing so can result in death or fire. • Phillips screwdriver • Tape measure or ruler Select a location that provi
Summary of the content on the page No. 5
Enclosure Cutout Dimensions Gas Supply Requirements WARNING WARNING Fire Hazard Explosion Hazard Do not install this side burner on or near combustible Use a new CSA International approved “outdoor” materials. gas supply line. Doing so can result in death or fire. Securely tighten all gas connections. If connected to LP, have a qualified person make sure gas pressure does not exceed 11” (28 cm) water Enclosure and clearance dimensions that are shown must be column. used. Given dimensions p
Summary of the content on the page No. 6
Line pressure testing: Testing above 1/2 psi (3.5 kPa) or 14 inches (35.5 cm) W.C. (gauge): • The side burner and its individual shutoff valve must be INSTALLATION INSTRUCTIONS disconnected from the gas supply piping system during any pressure testing of that system at test pressures greater than Outdoor Side Burner Installation 1/2 psig (3.5 kPa). Natural Gas: Testing below 1/2 psi (3.5 kPa) or 14 inches (35.5 cm) W.C. (gauge) or lower: • The side burner must be isolated from the ga
Summary of the content on the page No. 7
• If local codes permit, use a flexible stainless steel tubing 2. Gently move Side Burner completely into enclosure. gas connector, design-certified and marked “outdoor” by 3. Go to “Check and Adjust the Burners” section. CSA International, to connect the side burner to the rigid gas supply line. 5/8” diameter line is recommended. Using a wrench to tighten, connect the gas supply to the side burner. Use pipe joint compound on all non-flared male threads. Do Check and Adjust the Burn
Summary of the content on the page No. 8
Lighting the Side Burner OUTDOOR SIDE BURNER USE Using the Outdoor Side Burner WARNING front rear burner burner 1. Do not lean over the side burner. 2. Select the burner you want to lite and push in the outdoor side burner control knob. Turn the knob to “LITE/HI” while continuing to hold it in. Burn Hazard 3. You will hear the “snapping” sound of the spark. When burner Do not let the burner flame extend beyond the edge of is lit, release the knob. Turn knob to desired setting. the pa
Summary of the content on the page No. 9
Cleaning Interior • Cleaning should always be followed by rinsing with clean, General Tips warm water. • Use a mild liquid detergent or all-purpose cleaner, following IMPORTANT: Before cleaning, make sure all controls are off label instructions. Rinse with clean water and dry completely and the burners are cool. Always follow label instructions on with a soft, lint-free cloth. cleaning products. • A heavy-duty scrub sponge can be used with mild cleaning For routine cleaning, wash wit
Summary of the content on the page No. 10
® KITCHENAID GAS GRILL WARRANTY ONE YEAR LIMITED WARRANTY For one year from the date of purchase, when this grill is operated and maintained according to instructions attached to or furnished with the product, KitchenAid will pay for factory specified parts and repair labor to correct defects in materials or workmanship. Service must be provided by a KitchenAid designated service company. SECOND THROUGH FIFTH YEAR LIMITED WARRANTY ON PARTS In the second through fifth years from the date of pu
Summary of the content on the page No. 11
Requesting Assistance or Service To avoid unnecessary service calls, please check the “Using Your Outdoor Side Burner” and “Cleaning” sections. It may save you the cost of a service call. If you still need help, follow the instructions below. If you need assistance or service in U.S.A. Call the KitchenAid Customer Experience Center toll-free at 1-800-235-0665. Our consultants are available to assist you. When calling, please know the purchase date, and the complete model and serial number of
Summary of the content on the page No. 12
® Part No. 9763758 © 2006 KitchenAid. ® Registered Trademark/Trademark of KitchenAid U.S.A. Printed in U.S.A. 01/2006 Prepared by KitchenAid, Benton Harbor, Michigan 49022
