SWR Sound PB-200 user manual

Summary of the content on the page No. 1

PB-200

Please Note: The PB-200 is no longer in production (it was discontinued in 1987). The text below is provided for the
convenience of SWR users who purchased this model on the used market.

GENERAL INFORMATION AND DESCRIPTION

The PB-200 was designed from the ground up specifically for amplifying all bass instruments. Its features, sound,
packaging and performance specifications are the result of a four year accumulation of input from bass musicians, sound
engineers, and studio en

Summary of the content on the page No. 2

Level Control The Level Control cuts or boosts the frequency set by the Frequency Control directly beneath it. It is used in the same manner as you would a graphic equalizer. Starting at mid-position, moving the slider towards +15 boosts and moving the slider towards -15 cuts that particular frequency. Frequency Control The Frequency Control selects the center frequency that will be cut or boosted by the Level Control directly above it. If the- Level Control is at 'O' or mid-position,

Summary of the content on the page No. 3

The Line position can be used for recording directly into a tape machine as well as going directly to the studio board. An external power amplifier with a balanced input can be driven in the Line mode. Pin out for the XLR connector are as follows: Pin 1= ground, Pin 2= Pin 3= ACTIVE ELECTRONIC CROSSOVER HIGH AND LOW OUT JACKS The Crossover High and Low out jacks have been provided for bi-amping capabilities. Present at the Low jack are all frequencies below the point set by the Fre

Summary of the content on the page No. 4