Motorola MVME5100 Series user manual

Summary of the content on the page No. 1

MVME5100 Series
TM
VME Processor Modules
™
♦ PowerPC 7400 or PowerPC 750
microprocessor with 32KB/32KB L1 cache
♦ Up to 2MB of secondary backside cache
♦ 100 MHz front-side bus
♦ 64MB, 128MB, or 512MB of on-board
ECC SDRAM—expandable up to 1GB
with optional RAM500 memory expansion
modules
♦ Up to 17MB Flash memory
♦ Dual IEEE P1386.1 compatible 32/64-bit
PMC expansion slots
♦ 64-bit PCI expansion mezzanine
connector allowing up to four more PMCs
♦ Dual 16550 compatible async serial ports
♦

Summary of the content on the page No. 2

Rows A & C 64-pins Rows D & Z 46-pins SDRAM Expansion L2 Cache 256MB PMC P11 & P12 1MB or 2MB Flash PCI SDRAM Expansion Serial Serial 64 or 256MB 1MB 16550 60x MPC7400 Arbiter MPC750 ECC SDRAM Flash Serial PIB RJ-45 64, 128 or 512MB 16MB 16550 WB-554 Vcore REG ISA Hawk ASIC BUF X-Bus 100 MHz Memory Bus +3.3V RTC SCSI Super I/O ESCC CIO REG NVRAM LSI National 85230 8536 64-bit/33 MHz Local PCI Bus Ethernet 82559ER FP I/O FP I/O P2 MUX PCI PMC2 PMC1 VME Ethernet RJ-45 PAL Expansion Universe2B 8255

Summary of the content on the page No. 3

face signals to the MVME712M transition module. The 3-row Flash Memory Type: EEPROM, on-board programmable P2 adapter can be used for 8-bit SCSI. Capacity: 1MB via two 32-pin PLCC/CLCC sockets; To gain access to the additional user definable I/O pins pro- 16MB surface mount vided via the 5-row VME64 extension connector, a special P2 Read Access (16MB 70 clocks (32-byte burst) adapter board is available. This adapter panel replaces the port): traditional 3-row P2 adapter and extends its capabi

Summary of the content on the page No. 4

PCI Expansion Connector Parallel Port Address/Data: Controller: A32/D32/D64 PC97307 PCI Bus Clock: Configuration: 33 MHz 8-bit bi-directional, full IEEE 1284 sup- port; Centronics compatible (minus EPP Signaling: 5V and ECP on MVME712M) Connector: 114-pin connector located on the planar Modes: Master only of the MVME5100 Power Requirements Power Requirements (additional power load placed on MVME5100 with IPMC installed) (not including power required by PMC or IMPC modules) IPMC761 IPMC712 +5V

Summary of the content on the page No. 5

Demonstrated MTBF MVME761 Compatible I/O (based on a sample of eight boards in accelerated stress environ- IPMC761-001 Multifunction rear I/O PMC module; Ultra ment; results pending for IPMC712) Wide SCSI, one parallel port, two async and Mean: 190,509 hours two sync/async serial ports 95% Confidence: MVME761-001 107,681 hours Transition module: Two DB-9 async serial port connectors, two HD-26 sync/async serial port Safety connectors, one HD-36 parallel port connec- All printed wiring boards