Smeg PGF75U3 user manual

Summary of the content on the page No. 1

Important Safety Instruction
IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS – Your Safety And the Safety of Others Are Very Important.
We have provided many important safety messages throughout this manual and on your appliance.
Read all instructions before using your appliance and always obey all safety messages.
RECOGNIZE SAFETY INFORMATION
This is a safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and
others.
UNDERSTAND SIGNAL WORDS
A

Summary of the content on the page No. 2

Conversion Kit Check that the main gas supply line to the range is shut off and that the power supply cord is disconnected. 1) Remove access cap “A” by using a screwdriver or a quarter, turning the access cap anti-clockwise. The gas pressure regulator has two settings which are indicated on two sides of the cap. Turn the cap and reinstall it in the regulator with "LP" visible from the outside of the regulator. The regulator must be checked at a minimum water column of 1 inch (2.5 cm) above the

Summary of the content on the page No. 3

Conversion Kit 1 Remove the grids and all the caps and flame-spreader crowns; 2 Unscrew the burner nozzles with a 7 mm socket wrench; 3) 3 Replace the nozzles according tothe type of gas to be used (see point “4”). 4 Replace the burners in the correct position. 5

Summary of the content on the page No. 4

Conversion Kit To adjust the cooktop for LP gas or to return to Natural Gas use, refer to the tables here below. 4) Natural gas LP Qt Injector Qr Qt Injector Qr by-pass BTU Ø mm BTU BTU Ø mm BTU mm Front Right 3400 0.90 1200 Front Right 3400 0.54 1200 0.32 Front Left 3400 0.90 1200 Front Left 3400 0.54 1200 0.32 Central 13000 1.75 4000 Central 13000 1.02 4000 0.63 Rear Right 6200 1.20 1500 Rear Right 6200 0.72 1500 0.38 Rear Left 6200 1.20 1500 Front Left 6200 0.72 1500 0.38 NOTE: Save the

Summary of the content on the page No. 5

Conversion Kit Leak testing of the appliance must be conducted according to the following instructions: Use a brush and liquid detergent to test all gas connections for leaks. Bubbles around connections indicate a leak. If a leak appears, shut off gas valve controls and adjust connections. Then check the connections again. NEVER TEST FOR GAS LEAKS WITH A MATCH OR OTHER FLAMES. 6) Remove all of the detergent solution from the cooktop. Electronic Ignition System - initial lighting Cooktop burners