Summary of the content on the page No. 1
Contents
1. INSTRUCTIONS FOR PROPER USE ..................................................................................... 4
2. DISPOSAL INSTRUCTIONS – OUR ENVIRONMENT POLICY ............................................. 4
3. SAFETY PRECAUTION .......................................................................................................... 5
4. INTENDED USE OF THE APPLIANCE ................................................................................... 5
5. KNOW YOUR COOKER .....
Summary of the content on the page No. 2
Instructions for proper use 1. INSTRUCTIONS FOR PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE COOKER. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USING THE COOKER. ALSO KEEP THE SERIES OF NOZZLES SUPPLIED. INSTALLATION MUST BE CARRIED OUT BY QUALIFIED PERSONNEL IN ACCORDANCE WITH THE REGULATIONS IN FORCE. THIS APPLIANCE IS INTENDED FOR DOMESTIC USES AND
Summary of the content on the page No. 3
Safety instruction 3. SAFETY PRECAUTION ELECTRICAL CONNECTION: PLEASE REFER TO INSTALLATION INSTRUCTION FOR THE GAS & ELECTRICAL SAFETY REGULATIONS AND THE VENTILATION REQUIREMENTS. IN YOUR OWN INTEREST, AND THAT OF SAFETY, IT IS THE LAW THAT ALL GAS APPLIANCES BE INSTALLED AND SERVICE BY COMPETENT PERSONS, WHO WILL COMPLY WITH THE RELEVANT STANDARDS AND REGULATIONS. CORGI REGISTERED INSTALLERS UNDERTAKE TO WORK TO SATISFCTIORY STANDARDS. DISCONNECTION OF GAS AND ELECTRIC APPLIANCES SHOULD ALWAY
Summary of the content on the page No. 4
Instructions for the user 5. KNOW YOUR COOKER COOKING HOB CONTROL PANEL OVEN STORAGE COMPARTMENT 6. BEFORE FIRST USE Do not leave the packing in the home environment. separate the various waste materials and take them to the nearest special garbage collection centre. The inside of the appliance should be cleaned to remove all manufacturing residues. For further information about cleaning, see section "11. CLEANING AND MAINTENANCE" Using the oven and the grill for the first time, heat them to th
Summary of the content on the page No. 5
Instructions for the user 7. USE OF THE HOB 7.1 Cooking zone The appliance features 4/5 cooking zones of different diameter and power. Their position is clearly indicated by circles and the heat given off is defined by the markings on the glass surface. The 5 cooking zones are of the HIGH-LIGHT type and come on after a few seconds of being activated. Heating intensity can be adjusted by means of the knobs located on the front panel from a minimum to a maximum. The cooking zones marked by two con
Summary of the content on the page No. 6
Instructions for the user 8. FRONT CONTROL PANEL All the cooker controls and commands are on the front panel. OVEN THERMOSTAT KNOB FRONT LEFT-HAND COOKING ZONE OVEN FUNCTION KNOB REAR LEFT-HAND COOKING ZONE VARIABLE GRILL CENTRAL COOKING ZONE REAR RIGHT-HAND COOKING ZONE FRONT RIGHT-HAND COOKING ZONE Before using the oven make sure that the symbol ; appears on the display. See paragraph “10. ELECTRONIC PROGRAMMER”. COOKING HOB CONTROL KNOB Standard heating The circle next to each knob indicate
Summary of the content on the page No. 7
Instructions for the user OVEN CONTROL KNOB Each of the functions listed below can be used (except the oven light and the small grill) only together with the correct temperature thermostat regulation as described on page 10 of this manual. OVEN LIGHT GRILL ELEMENT + VENTILATION UPPER AND LOWER HEATING ELEMENT LOWER HEATING ELEMENT + VENTILATION GRILL ELEMENT VENTILATED HEATING ELEMENT + VENTILATION VARIABLE GRILL KNOB Position the oven function knob on the symbol or . Turn the variable grill
Summary of the content on the page No. 8
Instructions for the user 9. USE OF THE OVEN For the models with electronic programmer, before using the oven make sure that the display shows the symbol . During and after use the accessible parts of the oven may be very hot, and children must always be kept at a distance. 9.1 Warnings and general advice Using the oven and the grill for the first time, heat them to the maximum temperature (260°C) for as long as it takes to burn off any production oil residues which could give a nasty flavour t
Summary of the content on the page No. 9
Instructions for the user 9.3.2 Using the rotisserie Fit the supporting frame onto the second runner up from the bottom so that the seat to take the rod projects outside the oven. Place the rod as shown in the diagram (1) and push the frame into the oven until the end of the rod reaches the hole in the rotisserie motor. Now push the rotisserie rod to the left until it reaches the position shown in the diagram (2). To activate this function, turn the knob to ( / ). These operations must be carrie
Summary of the content on the page No. 10
Instructions for the user 10.ELECTRONIC PROGRAMMER LIST OF FUNCTIONS MINUTE-COUNTER KEY COOKING TIME KEY END OF COOKING KEY DECREASE TIME KEY INCREASE TIME KEY 10.1 Clock adjustment When using the oven for the first time, or after a power failure, the display flashes regularly and indicates . Press the keys and and at the same time the keys or : each single press changes the time by 1 minute either up or down. Before setting the programmer activate the desired function and temperature. 10.2
Summary of the content on the page No. 11
Instructions for the user 10.5 Minute Counter The programmer can also be used as a simple minute counter. By pressing key the display shows ; keep the key pressed and at the same time press keys or . On releasing the key programmed counting will begin and the display will show the current time and the symbol. After set-up, to see the remaining time, press the key . Use as a minute counter does not interrupt functioning of the oven at the end of the programmed time. 10.6 Adjusting alarm volum
Summary of the content on the page No. 12
Instructions for the user 11.CLEANING AND MAINTENANCE Never use a steam jet to clean the appliance. 11.1 Cleaning stainless steel To maintain stainless steel in good condition clean it regularly after each use, once it has cooled down. 11.2 Ordinary daily cleaning To clean and preserve the stainless steel surfaces, always use only specific products that do not contain abrasives or chlorine-based acids. How to use: pour the product on a damp cloth and wipe the surface, rinse thoroughly and dry wi
Summary of the content on the page No. 13
Instructions for the user 11.5 Cleaning of oven For best oven upkeep clean regularly after having allowed to cool. Take out all removable parts. Clean the oven grill with hot water and non-abrasive detergent. Rinse and dry. Clean the internal walls of the oven with a soft ammoniac-soaked cloth. Rinse and dry. If there are still stains or drops, place a damp ammoniac-soaked cloth on the bottom of the oven, close the door and after a few hours wash the oven with hot water and liquid detergent.
Summary of the content on the page No. 14
Instructions for the user 12.EXTRAORDINARY MAINTENANCE The oven may require extraordinary maintenance or replacement of parts subject to wear such as seals, bulbs, and so on. The following instructions describe how to carry out these minor maintenance operations. Before any intervention, disconnect the power supply of the device. 12.1 Replacement of light bulb Remove cover A by twisting anticlockwise, replace bulb B with another similar bulb (25 W). Refit the cover A. Only use oven bulbs (T 300°
Summary of the content on the page No. 15
Instructions for the installer 13.INSTALLATION OF THE APPLIANCE It is the law that all gas appliances are installed by competent persons. Corgi gas installers are approved to work to safe and satisfactory standards. All gas installation, servicing and repair work must be in accordance with the gas safety regulations 1984 (installation and use) as amended 1990. This appliance may be installed next to a wall which is higher than the appliance, as shown in the diagram showing the correct installati
Summary of the content on the page No. 16
Instructions for the installer Complete wiring up to power supply with an appropriately rated five-core plug (see data plate) or, in case of operation from a 220-240V power supply, with a three-core plug. Make sure that plug and wall socket are of the same type and are in conformity with regulations in force. Make sure that the appliance is properly earthed. Before powering, check that the power line is properly earthed. Avoid using adapters or shunters. The manufacturer declines all responsibil
