Streszczenie treści zawartej na stronie nr. 1
Electric Exmoor & Dartmoor
Installation and User
Instructions
For use in Great Britain and the Republic of Ireland.
This product is suitable for use in the stated countries. To install the
product in other countries it is essential to obtain translated instructions
and in some cases the product may require modification. Contact Yeoman
Stoves to obtain further information.
IMPORTANT
For use with 230v 50Hz electricity supply only.
Please read these instructions carefully before installation an
Streszczenie treści zawartej na stronie nr. 2
CONTENTS Covering the following models: Exmoor - Small YM-E9001FLA Dartmoor - Single Door YM-E5201FLA - Double Door YM-E5202FLA USER INSTRUCTIONS 3 1. Important Information & Health and Safety 3 2. Operating Instructions 4 3. Maintenance 5 4. Removing & Replacing Doors 6 INSTALLATION INSTRUCTIONS 7 Technical Specifications 7 Site Requirements 7 DIMENSIONS FOR FIRE & OPENING Exmoor 6 Dartmoor 6 1. Fitting Stoves 8 2. Fault Finding 8 3. How to Wire a Plug 8 SERVICING 10
Streszczenie treści zawartej na stronie nr. 3
USER INSTRUCTIONS 1.10 This appliance must stand on a clean, level, firm surface. HOw TO USE THESE INSTRUCTIONS Do not stand the fire on a carpet. Ensure that furniture, curtains etc. are positioned no closer than 1m and the fire The contents of Sections 1, 2 and 3 apply to all the stands on a surface that can withstand temperatures of 90°C models in our Electric Range. for prolonged periods. Do not allow rugs to be placed within 500mm of the front of the stove. The content of Secti
Streszczenie treści zawartej na stronie nr. 4
USER INSTRUCTIONS 1 2. OPERATING INSTRUCTIONS wARNING! Do not operate the appliance if it is damaged or has malfunctioned. If you suspect the appliance is damaged or has malfunctioned call a qualified service engineer to inspect the appliance, and replace any part of the electrical system if necessary, before reuse. GENERAL Thermostat 2.1 The appliance can be operated by the infrared handset or Flame effect button Standby the manual controls on the bottom right hand side of the On
Streszczenie treści zawartej na stronie nr. 5
USER INSTRUCTIONS 3. MAINTENANCE 1 2 3 4 Maximum Maximum Medium Minimum plus blue & green 3.1 ALwAYS UNPLUG FROM MAINS SUPPLY BEFORE flame effects CLEANING OR UNDERTAKING ANY MAINTENANCE CLEANING Turning On the Heat: 3.2 Only clean the outer casing when it is cold. Do not use 2.13 when turning on the heater you must always press the abrasive cleaners. 1kw button. Do not start the fire using the 2kw setting. 3.3 For painted castings, wipe with a damp cloth and buff 2.14 It is NOT advi
Streszczenie treści zawartej na stronie nr. 6
USER INSTRUCTIONS Take care not to damage the plastic screen 4. REMOVING & REPLACING DOORS & when replacing the fuel bed. REMOVAL OF FUEL BED 4 wARNING: DOOR CASTINGS ARE EXTREMELY HEAVY - SEEK ASSISTANCE BEFORE REMOVAL. Please note: The fuel bed is secured by 2 x screws on the lower panel on the front of the stove. 3 Fuel bed Screws AR2165 AR2391 Take care not to damage the plastic screen when replacing the fuel bed. 4.1 Turn the right rose on the door facia. 4.2 Open the door. 4.3
Streszczenie treści zawartej na stronie nr. 7
INSTALLATION INSTRUCTIONS TECHNICAL SPECIFICATIONS These instructions cover the following models: Exmoor - Small YM-E9001FLA Dartmoor - Single Door YM-E5201FLA - Double Door YM-E5202FLA These appliances have 3 modes of operation: A 230v 13amp 50Hz supply is required —Flame effect only - with brightness and flame colour Maximum power consumption is 2064 watts adjustment THIS APPLIANCE MUST BE EARTHED —Flame effect + 1kW heating A 1.8 metre lead with plug containing a 1
Streszczenie treści zawartej na stronie nr. 8
INSTALLATION INSTRUCTIONS 3. HOw TO wIRE A PLUG 1. FITTING STOVES Most stoves are heavy and do not require anchoring to the If you need to change the plug supplied with this fire, hearth or floor, but in certain circumstances the appliance follow the instructions below. The instructions assume that can become unstable e.g. when leaning on the stove. If this is the wire has been cut. likely, secure the appliance to the hearth or floor with suitably strong fixings. wARNING – FAILURE TO CON
Streszczenie treści zawartej na stronie nr. 9
INSTALLATION INSTRUCTIONS EUROPEAN PLUG - Suitable for use in Austria, Belgium, Bulgaria, Czech Republic, Denmark, Estonia, Finland, France, Greece, Hungary, Germany, Italy, Latvia, Lithu- ania, Luxembourg, Netherlands, Poland, Portugal, Romania, Slovakia, Slovenia, Spain & Sweden 4 Typical European Plug Type 15/16/17 Live wire Neutral wire Earth wire Cable grip Outer Insulation 3.1 Dispose of the old plug safely. 3.2 Ensure the new plug is not cracked or chipped. 3.3 Expose 4cm of the colo
Streszczenie treści zawartej na stronie nr. 10
SERVICING 6 Push fasteners SERVICING REQUIREMENTS Front LED THIS APPLIANCE MUST ONLY BE SERVICED BY A board SUITABLY QUALIFIED PERSON. BEFORE UNDERTAKING ANY wORK ON THE APPLIANCE: 1.1 Switch off the appliance and isolate it from the mains by unplugging the unit. 1.2 Wait for at least 10 minutes until the appliance has Plugs cooled down. AR2393 1.3 Following the appropriate instructions from User 1.8 Dispose of the board at an appropriate Instructions, Section 4, remove the
Streszczenie treści zawartej na stronie nr. 11
SERVICING REPLACING THE MOTOR & EFFECTS UNIT REPLACING THE MIDDLE LED BOARD The middle LED board is attached to the motor unit but 8 can be replaced individually (see Diagram 9). Motor unit Rear LED board 9 Plug AR2394 Middle LED board 1.14 The motor & effects unit is attached by 4 x screws located AR2395 at the rear of the appliance. It may be necessary to move the appliance from its location to gain access to the rear of the stove. Remove the 4 screws on the lower rear casing. 1.21 Dis
Streszczenie treści zawartej na stronie nr. 12
SERVICING REPLACING THE HEATER ASSEMBLY 1.31 Tilt the heater casing forward and carefully remove the heater assembly (see Diagram 12). 1.28 To access the heater assembly remove any loose top plates or panels before moving the stove and carefully lay the stove 12 on its back. 1.29 Remove the 5 x screws securing the heater casing to the bottom of the firebox (see Diagram 10). 10 Screws AR2398 1.32 Disconnect the 4 x coloured wires running from the firebox to the heater assembly (see Di
Streszczenie treści zawartej na stronie nr. 13
SPARE PARTS LIST Parts Description Part No. EXMOOR DARTMOOR Fuel Effect PL0116 PL0118 Handset EL0491 Battery EL0492 PCB Unit EL0493 Front LED Board EL0494 Middle LED Board EL0496 Rear LED Board EL0498 Motor & Effect Assembly EL0495 Heater Assembly EL0497 13
Streszczenie treści zawartej na stronie nr. 14
A division of Stovax Ltd Falcon Road, Sowton Industrial Estate, Exeter, Devon, England EX2 7LF Tel: (01392) 474500 Fax: (01392) 219932 E-mail: yeoman@stovax.com www.yeoman-stoves.co.uk
