Streszczenie treści zawartej na stronie nr. 1
25893
5.8 GHz Cordless Call
Waiting Caller ID Telephone/
Answering System
User’s Guide
We bring good things to life.
Streszczenie treści zawartej na stronie nr. 2
EQUIPMENT APPROVAL INFORMATION Your telephone equipment is approved for connection to the Public Switched Telephone Network and is in compliance with parts 15 and 68, FCC Rules and Regulations and the Technical Requirements for Telephone Terminal Equipment published by ACTA. 1 Notification to the Local Telephone Company On the bottom of this equipment is a label indicating, among other information, the US number and Ringer Equivalence Number (REN) for the equipment. You must, upon request, provi
Streszczenie treści zawartej na stronie nr. 3
INTERFERENCE INFORMATION This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference; and (2) This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection again
Streszczenie treści zawartej na stronie nr. 4
TABLE OF CONTENTS EQUIPMENT APPROVAL INFORMATION ................. 2 TONE/PULSE........................................... 16 INTERFERENCE INFORMATION ............................ 3 FACTORY DEFAULT ................................... 16 FCC RF EXPOSURE REQUIREMENTS ................. 3 TELEPHONE OPERATION ................................ 17 HEARING AID COMPATIBILITY............................ 3 MAKING A CALL ...................................... 17 INTRODUCTION .................................
Streszczenie treści zawartej na stronie nr. 5
REVIEWING AND DELETING STORED HANDSET SOUND SIGNALS ........................... 29 NUMBERS .................................. 24 DISPLAY ID MESSAGES ................................ 29 ADVANCED FEATURES ................................... 24 ANSWERING SYSTEM DISPLAY MESSAGES ....... 30 TEMPORARY TONE .................................... 24 TROUBLESHOOTING GUIDE ............................ 31 REMOTE ACCESS ......................................... 25 CORDLESS PHONE SOLUTIONS ...................
Streszczenie treści zawartej na stronie nr. 6
INTRODUCTION CAUTION: When using telephone equipment, there are basic safety instructions that should always be followed. Refer to the IMPORTANT SAFETY INSTRUCTIONS provided with this product and save them for future reference. This telephone/answering system is designed to be simple to use, however, you can reach its full potential more quickly by taking a few minutes to read this user’s guide. This telephone /answering system is a multifunction product for use with Call Waiting Caller ID servi
Streszczenie treści zawartej na stronie nr. 7
r e v rev i e c h a w r g e BEFORE YOU BEGIN PARTS CHECKLIST Make sure your package includes the items shown here. page Handset battery play/stop erase memo volume erase play/ stop answerer Base Handset Mounting Belt clip Long telephone AC power bracket line cord supply TELEPHONE JACK REQUIREMENTS Wall plate To use this phone, you need an RJ11C type modular telephone jack, which might look like the one pictured here, installed in your home. If you don’t Modular telephone have a modular jack, cal
Streszczenie treści zawartej na stronie nr. 8
r e v rev i e c h a w r g e HANDSET AND BASE LAYOUT handset indicator antenna display TALK/call back cid/vol up button mute/format button memory button cid/vol down button play/stop button redial button skip button play/stop review button erase exit button pause button answerer delete/answerer button flash button program button erase button antenna page button page answerer on/off button charge/in use indicator announce button display day/check button erase button hour button erase volume memo m
Streszczenie treści zawartej na stronie nr. 9
INSTALLATION • Never install telephone wiring during a lightning storm. • Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations. • Never touch non-insulated telephone wires or terminals, unless the telephone line has been disconnected at the network interface. • Use caution when installing or modifying telephone lines. •Temporarily disconnect any equipment connected to the phone such as faxes, other phones, or modems. IMPORTANT INSTALLATION GUI
Streszczenie treści zawartej na stronie nr. 10
INSTALLING THE PHONE 1. Choose an area near an electrical outlet and telephone wall jack (RJ11C). 2. Plug the AC power supply into the electrical outlet and the DC connector into the power jack on the back of the base. CAUTION: Use only ATLINKS, Inc. power supply 5-2605 that came with this unit. Using other power supplies may damage the unit. 3. Install the handset battery. NOTE: You must connect the handset battery before use. NOTE: Battery and battery door are packaged together inside a plasti
Streszczenie treści zawartej na stronie nr. 11
WALL MOUNTING NOTE: For best results, charge the telephone/answering system on a flat surface before hanging it on the wall. 1. Turn the base over. 2. Attach the wall mounting pedestal by first inserting the tabs on the open edge of the pedestal into the slots on the lower portion of the bottom of the base. Then push down and snap the pedestal into place. 3. Slip the mounting holes (on the back of the base and pedestal) over the wall plate posts and slide the unit down into place. (Wall plate no
Streszczenie treści zawartej na stronie nr. 12
3. Press and hold the hour button to set the hour (a.m. or p.m.). Example: 12AM, 1AM, or 12PM, 1PM. 4. Press and hold the min button to set the minute. The time advances in 5-minute intervals. 5. Press and release the day/check button to review the day and time settings. SPEAKER VOLUME Use the volume up/down buttons to adjust speaker volume on the base to a comfortable level. L1 is the minimum speaker volume and L8 is the maximum. VOICE INSTRUCTIONS Using the Base: 1. Press and hold the announce
Streszczenie treści zawartej na stronie nr. 13
RECORDING THE OUTGOING ANNOUNCEMENT For best results when recording, you should be about nine inches from the microphone, and eliminate as much background noise as possible. 1. Make sure the answering system is ON. 2. Press and hold the announce button. 3. Begin speaking after you hear the beep. 4. Release the button when you finish your announcement. NOTE: If you choose not to record an outgoing announcement, a default announcement plays instead. To return to the default announcement after you
Streszczenie treści zawartej na stronie nr. 14
SCREENING CALLS FROM THE BASE You may screen incoming calls by waiting for the caller to begin leaving a message (to hear who is calling), then pick up the handset, and press TALK/ callback to speak to the caller. The answering system automatically stops recording when you activate the handset or pick up an extension phone. TIP: Make sure the volume on the base is set loud enough to hear your incoming calls. MESSAGE PLAYBACK The messages indicator lets you know when you have messages. To play me
Streszczenie treści zawartej na stronie nr. 15
3. To erase a message from the handset: •Press answerer/delete button to enter into the handset remote access operation. •Press play/stop on the handset (the 2 button). The message plays. •Press erase (the 0 button) to erase the message during message playback. NOTE: Erased messages cannot be restored. LEAVING A MEMO Use the memo feature to leave a message. 1. Press and hold the memo button. You need to hold the button until you finish the message. 2. Begin speaking after you hear the beep. 3. R
Streszczenie treści zawartej na stronie nr. 16
3. Press program to confirm. NOTE: Press the EXIT button once to keep the previous setting and return to the standby screen. NOTE: To restore the default setting to - - - , press delete/answerer when SET AREA CODE shows in the display. TONE/PULSE Most telephone systems use tone dialing, however, some may still use pulse dialing. This system is pre-set to tone dialing. Depending on your service type, set the dialing mode as follows: 1. Press the program button until SET TONE/PULSE shows in the
Streszczenie treści zawartej na stronie nr. 17
TELEPHONE OPERATION MAKING A CALL 1. Press the TALK/callback button. 2. When you hear a dial tone, dial a telephone number. 3. When finished, press the TALK/callback button again to hang up. OR 1. Dial the phone number first, then press the TALK/callback button. 2. When finished, press the TALK/callback button again to hang up. ANSWERING A CALL 1. Pick up the handset and press the TALK/callback button. NOTE: The TALK/callback button is disabled when the handset is in the cradle. 2. To disconnect
Streszczenie treści zawartej na stronie nr. 18
TIP: Don't use the TALK/callback button to activate custom calling services such as call waiting, or you’ll hang up the phone. VOLUME When the phone is ON, press the CID/VOL left (-) or right (+) arrow button to adjust the volume of the handset's earpiece to a comfortable level. There are four settings to choose from. VOL 1 is the minimum volume level and VOL 4 is the maximum. EXIT Press the EXIT button to exit a menu function and return to the standby screen. MUTE Use the mute button during a p
Streszczenie treści zawartej na stronie nr. 19
This unit receives and displays information transmitted by your local phone company. This information can include the phone number, date, and time; or the name, phone number, date, and time. The unit can store up to 40 calls for later review. Time Number of calls Date Caller ID phone number Caller ID name CALL WAITING CALLER ID To receive Caller ID (CID) information from a Call Waiting call, you must subscribe to the combined Call Waiting Caller ID service from your local telephone company. Call
Streszczenie treści zawartej na stronie nr. 20
2. Press the CID/VOL left (-) arrow button to scroll through the call records from the most recent to the oldest. OR 3. Press the CID/VOL right (+) arrow button to scroll through the call records from the oldest to the newest. DELETING A CID RECORD 1. Make sure the phone is OFF (not in talk mode). 2. When reviewing the current record, press the answerer/delete button. DELETE CALL ID? The display shows 3. Press answerer/delete button again to confirm. The display shows DELETED. DELETING ALL CID
