Streszczenie treści zawartej na stronie nr. 1
Model 27906
2.4 GHz Cordless
Telephone System
User’s Guide
Streszczenie treści zawartej na stronie nr. 2
Important Information NOTICE: This product meets the applicable Industry Canada technical specifications. Operation is subject to the following two conditions: (1) This device may not cause interference, and () This device must accept any interference, including interference that may cause undesired operation of the device. The equipment must be installed using an acceptable method of connection. The customer should be aware that compliance with the above conditions may not prevent degra
Streszczenie treści zawartej na stronie nr. 3
CAUTION: Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection authority, or electrician, as appropriate. NOTES: This equipment may not be used on coin service provided by the telephone company. Interference Information This equipment generates and uses radio frequency energy which may interfere with residential radio and television reception if not properly installed and used in accordance with instructions contained in this
Streszczenie treści zawartej na stronie nr. 4
Telephone Network Information Should your equipment cause trouble on your line which may harm the telephone network, the telephone company, where practicable, may notify you that temporary discontinuance of service may be required. Where prior notice is not practicable and the circumstances warrant such action, the telephone company may temporarily discontinue service immediately. The telephone company may make changes in its communications facilities, equipment, operations or procedures
Streszczenie treści zawartej na stronie nr. 5
To be certain of the number of devices you may connect to your line as determined by the REN, you should contact your local telephone company. REN Number is located on the cabinet bottom. Licensing Licensed under US Patent 6,7,009. Hearing Aid Compatibility (HAC) This telephone system meets FCC/Industry Canada standards for Hearing Aid Compatibility. FCC RF Radiation Exposure Statement This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
Streszczenie treści zawartej na stronie nr. 6
Table of Contents Iantmptor II tnforma on .................................................... 2 Interference ItInforma on ................................................ 3 t elephone n etwork ItInforma on .................................... 4 ren n umber .................................................................. 4 l II cens ng ........................................................................ 5 h earIng a Id c I taomp I b lIty (cha ) .................................... 5 c fc r
Streszczenie treści zawartej na stronie nr. 7
Table of Contents c ordless p hone b asIcs ................................................. 19 m aking a Call ..........................................................................19 r eCeiving a Call ......................................................................19 r eDial ........................................................................................20 i n u se i D n C i orta ......................................................................20 Flash ...................
Streszczenie treści zawartej na stronie nr. 8
Table of Contents i tingnser a Pusea in the Dialing s equenCe oF a s oreD t n umBer ..................................................................................34 Changing a s oreD t n umBer ..................................................34 r evie Wing anD Deleting s D oret n umBers ..........................34 Dialing a s oreD t n umBer ......................................................35 Chain Dialing From m emory .................................................36 c I hang ng th
Streszczenie treści zawartej na stronie nr. 9
Introduction CAUTION: When using telephone equipment, there are basic safety instructions that should always be followed. Refer to the IMPORTANT SAFETY INSTRUCTIONS provided with this product and save them for future reference. IMPORTANT: Because cordless phones operate on electricity, you should have at least one phone in your home that isn’t cordless, in case the power in your home goes out. Before You Begin Parts Checklist Make sure your package includes the items shown here. Handset
Streszczenie treści zawartej na stronie nr. 10
Telephone Jack Requirements To use this phone, you need an RJ11C Wall plate type modular telephone jack, which Modular might look like the one pictured here, telephone installed in your home. If you don’t have line jack a modular jack, call your local phone company to find out how to get one installed. Installation Digital Security System Your cordless phone uses a digital security system to protect against false ringing, unauthorized access, and charges to your phone line. INSTALLATIO
Streszczenie treści zawartej na stronie nr. 11
Certain other communications devices may also use the 2.4 GHz frequency for communication, and, if not properly set, these devices may interfere with each other and/or your new telephone. If you are concerned with interference, please refer to the owner’s manual for these devices on how to properly set channels to avoid interference. Typical devices that may use the 2.4 GHz frequency for communication include wireless audio/video senders, wireless computer networks, multi-handset cor
Streszczenie treści zawartej na stronie nr. 12
Important Installation Guidelines • Avoid sources of noise and heat, such as motors, fluorescent lighting, microwave ovens, heating appliances and direct sunlight. • Avoid areas of excessive dust, moisture and low temperature. • Avoid other cordless telephones or personal computers. • Never install telephone wiring during a lightning storm. • Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations. • Never touch non-insulated telephone wi
Streszczenie treści zawartej na stronie nr. 13
Handset Layout Vol Boost (volume boost display button) talk/call back (button) CID/vol 5 or 6 mem (caller ID/volume (memory button) 5 or 6 button) redial (button) format (button) TONE*/exit (button) # (pause button) delete/channel (button) flash/program (button) ringer (button) 1
Streszczenie treści zawartej na stronie nr. 14
Installing the Phone Installing the Handset Battery NOTE: You must connect the handset battery before use. CAUTION: To reduce the risk of fire or personal injury, use only the Thomson Inc. approved Nickel-Cadmium (Ni-Cd) battery model 5-2459 or Nickel Metal Hydride battery model 5-2522 that is compatible with this unit. 1. Locate battery and battery door which are packaged together inside a plastic bag and are separate from the handset. . Locate the battery compartment on the back of th
Streszczenie treści zawartej na stronie nr. 15
NOTE: To ensure proper battery installation, the connector is keyed and can be inserted only one way. . Insert the battery pack. 5. Close the battery compartment by pushing the door up until it snaps into place. Base Station 1. Choose an area near an electrical outlet and a telephone wall jack (RJ11C), and place your cordless telephone on a level surface, such as a desktop or tabletop, or you may mount it on the wall. . Plug one end of the telephone line cord into the TEL LINE jack on
Streszczenie treści zawartej na stronie nr. 16
. Set the ringer switch (on the handset) to ON, and place the handset in the cradle on the base. 5. The charge/in use indicator turns on, verifying the battery is charging. The unit will take 0 seconds to register and verify its security code. 6. Allow the phone to charge for 16 hours prior to first use. If you don’t properly charge the phone, battery performance is compromised. CAUTION: To reduce risk of personal injury, fire, or damage use only the 5-2617 or 5-2748 power adaptor lis
Streszczenie treści zawartej na stronie nr. 17
Handset Setup There are five programmable menus available: Language, Local Area Code, Ringer Tone, Tone/Pulse and Factory Default. When you program these settings, make sure the phone is OFF (not in talk mode). Pressing the TONE*/exit button will remove you from the menu selection process without changing the feature you are in. Display Language 1. Press the flash/program button until 1ENG 2FRA 3ESP shows in the display. . Use the CID/vol ( 5 or 6) button or the handset number pad to sel
Streszczenie treści zawartej na stronie nr. 18
. Use the handset number pad to enter your -digit area code. NOTE: If you make a mistake, press the delete/channel button to erase the incorrect area code and repeat step 2. . Press the flash/program button to confirm and to advance to the next menu feature. Ringer Tone 1. Press the flash/program button until RINGER TONE shows in the display. . Use the CID/vol ( 5 or 6) button or the handset number pad (1-) to enter y our selection from Ringer Tone 1, , or . The default setting
Streszczenie treści zawartej na stronie nr. 19
Factory Default This feature allows you to restore the unit’s original features. 1. Press the flash/program button until DEFAULT shows in the display. . Use the CID/vol ( 5 or 6) button to scroll to YES o NO. The default setting is NO. . Press flash/program to confirm. You will hear a confirmation tone. Cordless Phone Basics Making a Call 1. Press the talk/call back button and dial the desired number. -OR- To perform preview dial, dial the number first then press the talk/call back
Streszczenie treści zawartej na stronie nr. 20
Redial Press the redial button to quickly dial the last number you called (up to digits). If you get a busy signal, and want to keep dialing the number, press redial to dial the number again. In Use Indicator When the charge/in use indicator on the base is lit, the handset is either in use or charging. The charge/in use indicator on the base and the incoming-call-alarm at the base front cradle flash when you receive a call. Flash If you subscribe to the combined Call Waiting Caller ID s
