Streszczenie treści zawartej na stronie nr. 1
2.4 GHz Digital Spread
Spectrum Cordless
Telephone
with Call Waiting/Caller ID
Owner’s Manual
Please read before using this equipment.
Streszczenie treści zawartej na stronie nr. 2
Read This Before Installation This phone has been tested and found to • party-line systems comply with all applicable ETL and FCC • most electronic key telephone systems standards. We have designed your phone to conform to WARNING: To reduce the risk of fire or federal regulations, and you can connect it to shock hazard, do not expose this product to rain most telephone lines. However, each phone or moisture. (and each device, such as a telephone or an- swering machine) that you connect to the
Streszczenie treści zawartej na stronie nr. 3
only telephone. To be safe, you should also Lightning have a phone that does not require AC pow- Your telephone has built-in protection circuits er to operate (not a cordless phone) so you to reduce the risk of damage from surges in can still make and receive calls if there is an telephone line and power line current. These AC power failure. protection circuits meet or exceed the FCC Some cordless phones operate at frequen- requirements. However, lightning striking the cies that might cause inte
Streszczenie treści zawartej na stronie nr. 4
8. To reduce the risk of electric shock, do local codes for possible special disposal not disassemble this product. If servic- instructions. ing is required, take it to a qualified ser- 2. Use only a replacement battery pack of viceman. the required size and type. Use only a 9. Disconnect this product from the tele- 3.6V 600mAh Nickel Metal Hydride (Ni- phone line and refer to qualified service MH) battery pack. personnel under the following condi- 3. Do not open or mutilate the battery tions. p
Streszczenie treści zawartej na stronie nr. 5
with this product, in high temperature Batteries should be stabilized at room areas. temperature prior to use after cold stor- age. 11. Batteries that are stored in a freezer or refrigerator for the purpose of extending SAVE THESE INSTRUCTIONS shelf life should be protected from con- densation during storage and defrosting. Contents Features .................................................................................................................................. 6 Installation ........
Streszczenie treści zawartej na stronie nr. 6
Features Headset Jack Your RadioShack 2.4 GHz Digital Spread — lets you connect an option- Spectrum Cordless Telephone uses ad- al headset (available from your local vanced technology to give you superior au- RadioShack store) for handsfree conve- dio quality and extended range. The phone’s nience. Caller ID unit records each caller’s telephone Hearing-Aid Compatibility — lets you use number (and name, if available in your area) the phone with hearing aids that have a T and the date and time
Streszczenie treści zawartej na stronie nr. 7
Installation date the wiring for you. You must use com- MOUNTING THE PHONE patible modular jacks that are compliant with Select a flat surface that is: Part 68 of FCC Rules. • near an AC outlet Note: The USOC number of the jack to be installed is RJ11C (or RJ11W for a wall plate • near a telephone line jack jack). • out of the way of normal activities Follow these steps to set up your phone. • away from electrical machinery, electri- 1. Plug one end of the supplied modular cal appliances, me
Streszczenie treści zawartej na stronie nr. 8
nector fits only one way), replace the The supplied battery pack should last about battery pack, and replace the cover. a year. If the battery pack does not hold a charge for more than 2 hours after an over- To charge the battery pack, place the hand- night charge, replace it with a new 3.6-volt, set on the base. The CHARGE indicator on 600 mAh battery pack with a connector that the base lights and Je Je Je JejjjjW W W Wbbbb0000& & & && & & & appears. fits the socket in the battery compartment.
Streszczenie treści zawartej na stronie nr. 9
STORING YOUR AREA USING THE BELT CLIP CODE To attach the belt clip, align the clip with the slots on the sides of the handset, then snap it You can store your local area code in the into place. phone’s Caller ID record so it does not show the area code if the received call is from your To remove the belt clip, use a flat object such local area. as a table knife to pry the belt clip off the phone. Note: If your calling area requires 10-digit di- aling including area code, do not enter the area co
Streszczenie treści zawartej na stronie nr. 10
Operation A QUICK LOOK AT YOUR PHONE MUTE/PGM — Press to talk to someone in the room while using the phone without the person on the other end of the phone line hearing your conversation. C CK C CKJ; KJ; KJ; J; appears on the display. Press again to resume your TALK — To make a call, lift the hand- phone conversation. set and press TALK. J7BA J7BA J7BA J7BA appears, and the IN USE/PAGE indicator on the base lights. Enter the number. The number appears as you dial, then (after a few s
Streszczenie treści zawartej na stronie nr. 11
Follow these steps to store a number and ADJUSTING THE name in memory. HANDSET’S VOLUME 1. Lift the handset. To adjust the handset’s volume during a call, press 8 8 8 8 or 9 9 9 9 on the handset until you 2. Press MEM. C;CEHO C;CEHO C;CEHO C;CEHO appears. reach the desired volume level. The number and a bar graph of the volume level appear. 3. Press a number (0–9) to choose a two- digit memory location. ;c ;c ;c ;cfjo fjo fjo fjo (or the cur- The volume level setting is maintained even rent mem
Streszczenie treści zawartej na stronie nr. 12
To enter a special character, use 0. Each Reviewing Memory Numbers time you press 0, the following charac- To review your memory numbers, press ters appear in this order: MEM. C;C C;C C;C C;CEEEEHO HO HO HO appears. Choose a memory * ç ç ç ç ¶ ¶¶ ¶ ) ) ) ) âýá âýá âýá âýá (space) U U U U &ý &ý &ý &ý location (0–9) by pressing a number or by re- peatedly pressing 8 8 8 8 or 9 9 9 9. The selected If you make a mistake, use 6 6 6 6/**** /TONE memory location number appears with the to move the curs
Streszczenie treści zawartej na stronie nr. 13
When you finish using the headset, discon- MOVING OUT OF RANGE nect it from the handset. If you have the handset out of the base's Notes: range while a call is in progress, the handset beeps and EK EK EK EKJý Jý Jý JýE<ý E<ý E<ý E<ýHHHH7D 7D 7D 7D=; =; =; =; appears. Return to • Connecting a headset disconnects the the base’s range within 30 seconds, then you handset’s earpiece and microphone. can resume your phone conversation. • 8 8 8 8/9 9 9 9 and MUTE/PGM on the handset USING A HEADSET also
Streszczenie treści zawartej na stronie nr. 14
you scroll past the last record, ;dZý ;dZý ;dZý ;dZýe\ý e\ý e\ý e\ýBBBB_i _i _i _ijjjj ap- different, the record shows the area code. pears, then the first record. When you scroll However, you can add or delete the area past the first record, ;dZý ;dZý ;dZý ;dZýe\ý e\ý e\ý e\ýBBBB_ij _ij _ij _ij appears, then code on the display. When the record is on the last record. the display, press 3 to add or delete the area code. Pressing 3 again deletes or adds the The top line of each record shows the t
Streszczenie treści zawartej na stronie nr. 15
again. The phone beeps once indicating that DELETING CALLER ID the record was deleted. RECORDS To delete all Caller ID records, while a Caller To delete a single Caller ID record, press 8 8 8 8 ID’s data is on the display, hold down DE- or 9 9 9 9 to recall the record you want to delete. LETE for three seconds. ;hWi[ý ;hWi[ý ;hWi[ý ;hWi[ý7bb 7bb 7bb 7bb5555 appears. Press DELETE. ;hWi[5 ;hWi[5 ;hWi[5 ;hWi[5 appears, prompting Press DELETE again. The phone beeps once you to confirm the deletion.
Streszczenie treści zawartej na stronie nr. 16
Problem Suggestion You have an incoming call, but do not receive Let the phone ring twice before you answer so the any Caller ID information. phone has time to record the Caller ID information. Check that the phone is correctly and securely con- nected. Check with your phone company to verify that your Caller ID service is active. If you still have problems, disconnect the phone. If other phones on the same line work proper- ly, the fault is in this phone or its installation. If you cannot fin
