Instrukcja obsługi Milwaukee Instruments MW102

Streszczenie treści zawartej na stronie nr. 1

• The HOLD function is activated
OPERATION:
by pressing the HOLD key. The
Milwaukee • The meter is supplied complete with a 9V
measured value is frozen on the
battery. Slide off the battery compartment
display and the “HOLD” tag lights
USER MANUAL
cover on the back of the meter and install
up. Release “HOLD” by pressing HOLD
the battery into battery clip connector
key again.
PORTABLE uP-BASED
while observing polarity.
• After completing measurements,
pH METER
• Always remove the electrode protec

Streszczenie treści zawartej na stronie nr. 2

• Wait till the hourglass symbol on the BATTERY REPLACEMENT: SPECIFICATIONS: display turns off and the “pH” tag stops When the battery becomes weak a reliable blinking, then press measurement can not be guaranteed. The MW102 the CFM key to meter will display “Eb” for a while and then confirm the offset turn off. RANGE -2.00 to 16.00 pH calibration. Prompt battery replacement is required. -5 to 70°C Note: Pressing the CAL key again will Battery replacement must only take place RESOLUTION 0.01 pH