Streszczenie treści zawartej na stronie nr. 1
L4310UA_6626LCTA.qx4 06.12.21 19:49 Page 1
26 inch Digital / Analog
LCD TV
Owner’s Manual
6626LCT A
6626LCT
INPUT
POWER SLEEP SELECT
1 2 3
4 5 6
AUDIO
7 8 9
STILL
- 0
SCREEN
SETUP MODE
ENTER
BACK INFO
CH RETURN
VOL. CH
MUTE
STANDBY POWER ON
HIGH-DEFINITION TELEVISION
TO RECEIVE DIGITAL/ANALOG SIGNAL,
YOU MUST CONNECT ANTENNA.
IF YOU NEED ADDITIONAL ASSISTANCE WITH SET-UP OR OPERATING AFTER
READING OWNER’S MANUAL, PLEASE CALL TOLL FREE 1-800-968-3429,OR
VISIT OUR WEB SITE AT http://www.Sylv
Streszczenie treści zawartej na stronie nr. 2
L4310UA_6626LCTA.qx4 06.12.21 19:49 Page 2 WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLI- ANCE TO RAIN OR MOISTURE. THIS SYMBOL INDICATES THAT DANGER- CAUTION OUS VOLTAGE CONSTITUTING A RISK OF RISK OF ELECTRIC SHOCK ELECTRIC SHOCK IS PRESENT WITHIN DO NOT OPEN THIS UNIT. CAUTION: TO REDUCE THE RISK OF ELEC- THIS SYMBOL INDICATES THAT THERE TRIC SHOCK, DO NOT REMOVE COVER (OR BACK). ARE IMPORTANT OPERATING AND MAIN- NO USER SERVICEABLE PARTS INSIDE. REFER TEN
Streszczenie treści zawartej na stronie nr. 3
L4310UA_6626LCTA.qx4 06.12.21 19:49 Page 3 where it can fall into such power lines or circuits. When installing an out- d. If the TV does not operate normally by following the operating instruc- side antenna system, extreme care should be taken to keep from touching tions. Adjust only those controls that are covered by the operating such power lines or circuits as contact with them might be fatal. instructions, as improper adjustment of other controls may result in damage and will often requi
Streszczenie treści zawartej na stronie nr. 4
L4310UA_6626LCTA.qx4 06.12.21 19:49 Page 4 SUPPLIED ACCESSORIES • Owner’s Manual • Remote control unit • Batteries (1EMN21350B) (NF000UD) (“AA” x 2) • If you need to replace these accessories, please refer to the PART NO, with the illustrations and call our help line mentioned on the front page. • Depending on your antenna system, you may need different types of Combiners (Mixer) or Separator (Splitter). Contact your local electronics store for these items. FEATURES • DTV/TV/CATV This TV lets
Streszczenie treści zawartej na stronie nr. 5
L4310UA_6626LCTA.qx4 06.12.21 19:49 Page 5 ONTENTS C IMPORTANT SAFEGUARDS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 SUPPLIED ACCESSORIES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 FE
Streszczenie treści zawartej na stronie nr. 6
L4310UA_6626LCTA.qx4 06.12.21 19:49 Page 6 UNCTIONS F REMOTE CONTROL, TOP AND REAR PANEL FUNCTION SLEEP button (p23) INPUT SELECT button (p20) To turn the power off automatically at To select TV or external input mode (to INPUT preset time access DVD, VCR, etc.) POWER SLEEP SELECT POWER button (p12) AUDIO button (p19) To turn TV on/off • Analog mode (TV) 1 2 3 To select audio mode Channel number buttons (p15) • Digital mode (DTV) To select channels 4 5 6 To select audio language AUDIO SETUP b
Streszczenie treści zawartej na stronie nr. 7
L4310UA_6626LCTA.qx4 06.12.21 19:49 Page 7 ANT. IN jack AUDIO OUT jacks Connect your antenna or cable Audio cable connection for external box here. audio equipment. Use AUDIO IN jacks of external equipment. DIGITAL AUDIO OUT ANT. IN (COAXIAL) jack L L HDMI IN jacks AUDIO OUT AUDIO Connect an optional coaxial digi- Connect HDMI cable and audio DIGITAL HDMI IN AUDIO OUT R R tal audio cable here through the (COAXIAL) cable coming from the HDMI and HDMI coaxial digital audio in jack of a audio o
Streszczenie treści zawartej na stronie nr. 8
L4310UA_6626LCTA.qx4 06.12.21 19:49 Page 8 REPARATION FOR USE P CONNECTION This section describes how to connect this TV to reception and other sources. MAKE SURE YOU HAVE AN ANTENNA As DTV is only available over the air, you need an antenna to receive digital signal. NOTE: Be sure that antenna or cable is connected properly before plugging the power cord. [ANTENNA CABLE CONNECTION] 1) When connecting TV to antenna Connect the RF cable or antenna cable on your home outlet to the ANT. IN jack
Streszczenie treści zawartej na stronie nr. 9
L4310UA_6626LCTA.qx4 06.12.21 19:49 Page 9 EXTERNAL CONNECTION [HDMI CONNECTION] 1) This is the best method to connect this TV to video devices with the HDMI output jack, such as DVD play- er with HDMI output jack, etc. It can minimize the deterioration of image quality. Use the HDMI cable (commercially available) for connection. To HDMI INPUT jack HDMI OUT ANT. IN L L AUDIO OUT AUDIO DIGITAL To HDMI output jack HDMI IN AUDIO OUT R R (COAXIAL) DVD Player with the HDMI output jack HDMI Cables
Streszczenie treści zawartej na stronie nr. 10
L4310UA_6626LCTA.qx4 06.12.21 19:49 Page 10 [COMPONENT CONNECTION] 1) This is a better method to connect this TV to video devices with the Component output jack, such as DVD player, etc. Use the Component cable (commercially available) for connection. If you connect component output jack to COMPONENT1 input jack, connect an audio cable to AUDIO L/R jacks of COMPONENT1. If you connect component output jack to COMPONENT2 input jack, connect an audio cable to AUDIO L/R jacks of COMPONENT2. To co
Streszczenie treści zawartej na stronie nr. 11
L4310UA_6626LCTA.qx4 06.12.21 19:49 Page 11 [ANALOG AUDIO/VIDEO CONNECTION] 1) This is the general method to connect this TV to video devices with the video and audio output jacks, such as VCR, Camcorder, Video Game, etc.. When the audio jack of video devices is monaural, connect this TV to the Audio L jack. To VIDEO1 INPUT jack To video output Y Y VIDEO VIDEO jack AUDIO VIDEO Pb Pb OUT OUT L L L L Camcorder Video Game S-VIDEO1 AUDIO Pr AUDIO Pr AUDIO AUDIO R R R R To audio output S-VIDEO2 ja
Streszczenie treści zawartej na stronie nr. 12
L4310UA_6626LCTA.qx4 06.12.21 19:49 Page 12 NITIAL SETTINGS I Hint: Before starting initial setup you must connect antenna. INITIAL SETTINGS K L 3 Select your language using [ / ], press [ENTER]. This section describes the initial settings when you When you first turn on the power, the following first turn on the power after purchase. The initial screen is displayed. setting items are shown below. Initial Setup Initial Setup • LANGUAGE SELECTION Select the language used for setup. English You
Streszczenie treści zawartej na stronie nr. 13
L4310UA_6626LCTA.qx4 06.12.21 19:49 Page 13 HANNEL SETTINGS C AUTOSCAN K L 3 For TV channels, using [ / ], select “Air”. If you switch wires (e.g. between antenna and For CATV channels, select “Cable”. CATV) or if you move the TV to a different area A Autoscan utoscan after the initial setting, you need to perform Back Autoscan will rescan all channels. This may take a while to complete. Autoscan again. This function lets you easily select Air Select the destination of "ANT.IN" jack. Cable K
Streszczenie treści zawartej na stronie nr. 14
L4310UA_6626LCTA.qx4 06.12.21 19:49 Page 14 CHANNEL LIST 3 Select the channel you want to skip. K L The Channel List function lets you skip the unnec- • Using [ / ], select the channel. essary channels from the Channel registration list. Channel List Channel List STILL Highlight channels for DTV DTV 6 6 - 0 Ch Up/Down key selection. DTV DTV 8 8 SCREEN 9 SETUP SETUP MODE 9 27 DTV DTV 48 48 58 58 DTV 67 ENTER ENTER BACK ENTER Ch Select Watch/Skip Back INFO BACK CH RETURN • Press [ENTER], and th
Streszczenie treści zawartej na stronie nr. 15
L4310UA_6626LCTA.qx4 06.12.21 19:49 Page 15 MANUAL REGISTER 3 Select the channel you want to add. • Using Channel number buttons, select your You can register shortage of channels that were not desired channel. scanned by the Autoscan function due to the bad reception status at the initial setting. 11 INPUT Manual Register Manual Register POWER SLEEP SELECT For Analog channels, Register select a channel to register using number keys. For Digital channels, 1 1 2 2 3 3 you must perform Autosca
Streszczenie treści zawartej na stronie nr. 16
L4310UA_6626LCTA.qx4 06.12.21 19:49 Page 16 • If the channel is set to external input, you can- ANTENNA CONFIRMATION not confirm the antenna situation. You can verify the signal strength of each channel Video1 to get a clearer picture. Antenna Antenna Back INPUT POWER SLEEP SELECT Indicator is available for antenna signal only. 1 1 2 2 3 3 4 4 5 5 6 6 CH Ch Change AUDIO 7 7 8 8 9 9 STILL 3 To exit the setup, press [SETUP]. - - 0 0 SCREEN SETUP SETUP MODE ENTER ENTER INFO BACK CH RETURN VOL.
Streszczenie treści zawartej na stronie nr. 17
L4310UA_6626LCTA.qx4 06.12.21 19:49 Page 17 LANGUAGE SELECTION You can choose your on screen language from one of the following English, Spanish or French. STILL - 0 SCREEN SETUP SETUP MODE ENTER ENTER INFO BACK CH RETURN VOL. CH MUTE 1 Display the setup screen. • Press [SETUP]. The following setup screen is displayed. 2 Select “LANGUAGE” and press [ENTER] to con- firm. K L • Using [ / ], select “English/Español/Français”. Language Language Select the language for setup display. English Elija
Streszczenie treści zawartej na stronie nr. 18
L4310UA_6626LCTA.qx4 06.12.21 19:49 Page 18 ATCHING TV W NTSC ATSC 18:00 CHANNEL SELECTION CH4-1 No signal No signal K L You can select the channel by using either [CH / ] 18:30 or Channel number buttons. How to select the CH4-1 CH4-2 CH4-3 channel in each way is shown below. CH4 19:00 INPUT POWER SLEEP SELECT CH4-1 No signal CH4-3 19:30 1 1 2 2 3 3 CH4-1 CH4-2 No signal 4 4 5 5 6 6 20:00 AUDIO : changes automatically 7 7 8 8 9 9 STILL : change manually by pressing [CH / ] - - 0 0 on
Streszczenie treści zawartej na stronie nr. 19
L4310UA_6626LCTA.qx4 06.12.21 19:49 Page 19 Press [AUDIO] to cycle through available audio STILL MODE channels. You can freeze the image shown on the screen. When the broadcasting has all audio... 1 2 3 SAP / STEREO SAP / MONO 4 5 6 AUDIO SAP / STEREO 7 8 9 STILL STILL When the broadcasting has stereo audio and - 0 SCREEN SETUP monaural audio... MODE MONO / STEREO MONO / STEREO When the broadcasting has SAP and monaural 1 Pause the image. audio... • When you press [STILL], the image shown on
Streszczenie treści zawartej na stronie nr. 20
L4310UA_6626LCTA.qx4 06.12.21 19:49 Page 20 SWITCHING EXTERNAL INPUT • When you press [INFO], the current external input mode, the type of resolutions for video When you connect external devices including a signal, TV aspect ratio CC and TV rating will be video cassette recorder and home audio system, displayed at the top-right of the screen. you can easily switch the input mode with the remote control. 1) When using VIDEO1 or S-VIDEO1 INPUT jack INPUT INPUT POWER SLEEP SELECT SELECT Video1 4
