Streszczenie treści zawartej na stronie nr. 1
Introduction
Congratulations upon your selection of the QV-700 LCD Digital Cam-
LCD Digital Camera
era. The QV-700 comes with its own built-in liquid crystal color moni-
tor that let’s you instantly view the pictures you take.
QV-700
To get the most out of the QV-700, be sure to carefully read this
Owner’s Manual
manual and follow the instructions contained in it.
Contents
Precautions ................................................................... 5
Unpacking ................................
Streszczenie treści zawartej na stronie nr. 2
Precautions Precautions LCD Digital Camera • Never use the unit inside of an air craft or in any other areas where General Precautions its use is prohibited. Doing so can result in an accident. Be sure to observe the following important precautions whenever us- • Physical damage and malfunction of this unit can cause the image ing the QV-700. data stored in its memory to be deleted. Be sure to always keep All references in this manual to “this camera” and “the camera” refer backup copies of data
Streszczenie treści zawartej na stronie nr. 3
Precautions LCD Digital Camera GUIDELINES LAID DOWN BY FCC RULES FOR USE OF Declaration of Conformity THIS UNIT IN THE U.S.A. (not applicable to other areas). This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause Model Number: QV-700 harmful interference, and (2) this device must accept any interference Trade Name: CASIO COMPUTER CO.,LTD. received, including interference that may cause undesired operation. Respons
Streszczenie treści zawartej na stronie nr. 4
General Guide Getting Acquainted Tripod hole Bottom Monitor Screen Recording Mode Battery compartment Recording Mode lock (Not normally displayed Battery compartment cover during image recording.) BRIGHT (brightness) control • BRIGHT control adjusts the brightness of the image on the LCD. Manual recording Remaining number The brightness is set at the factory to the optimum setting, and nor- indicator of pages mally does not need adjustment. Macro indicator Mode (appears when the (FINE) Dial sw
Streszczenie treści zawartej na stronie nr. 5
Memory Cards Getting Acquainted To remove a memory card from the camera Formatting a Memory Card You can format a memory card to delete all of the data stored on it. 1. Open the memory card slot cover. 2. Unfold the eject button. Important! 3. Press the eject button straight down. Data deleted by a memory card format operation cannot be recov- ered! Be sure to carefully check and confirm that you no longer need 4. Remove the memory card. the data stored in a memory card before formatting it. 5.
Streszczenie treści zawartej na stronie nr. 6
Power Supply Memory Cards Getting Acquainted Renaming After Move The camera features a two-way power supply that lets you use either batteries (AA-size Alkaline or Lithium) or household AC current. CAMERA BUSINESS CAMER001.CAM BUSIN001.CAM To load batteries CAMER002.CAM BUSIN002.CAM CAMER003.CAM Move BUSIN003.CAM Be sure that camera power is turned off whenever loading or replac- CAMER004.CAM Renamed Appended to end ing batteries. Renamed CAMER005.CAM 1. Slide the battery compartment lock on the
Streszczenie treści zawartej na stronie nr. 7
Power Supply Getting Acquainted Low Battery Indicator Using AC Power The low battery indicator ( ) appears in the center of the LCD To power the camera from standard AC power, use the optional AC whenever batteries are about to go dead. It tells you that power will adaptor (AD-C620). soon turn off automatically if you continue using the camera without replacing batteries. Be sure to replace all four batteries with a fresh AC power terminal set of new ones. AC adaptor Auto Power Off Power automat
Streszczenie treści zawartej na stronie nr. 8
Setting the Current Date and Time Getting Acquainted 4. Use [+] and [–] to select ADJUST, and then press the shut- 3. Use [+] and [–] to select ADJUST, and then press the shut- ter button. ter button. 5. Set the current date and time. 4. Use [+] and [–] to select STYLE, and then press the shutter • Use [+] and [–] to select the setting that is highlighted on the button. monitor screen, and then press the shutter button to advance to the next setting. Repeat this for all of the settings on the mo
Streszczenie treści zawartej na stronie nr. 9
Recording Images Operation Caution Shooting Images Outdoors Never open the battery compartment cover, disconnect the AC Note that strong direct or reflected light can cause vertical lines in an adaptor from the camera or unplug it from the wall socket while the image. This is due to the characteristics of the camera’s charge-cou- “WAIT” message is on the LCD. Doing so will not only make storage pled device (CCD), and it does not indicate malfunction of the cam- of the current image impossible, i
Streszczenie treści zawartej na stronie nr. 10
Recording Images Operation Notes Exposure Adjustment • Exposure adjustment is generally expressed in terms of an expo- This camera features an program AE function that automatically sure adjustment value. The exposure adjustment value is always changes shutter speed and aperture in accordance with available set to zero whenever you turn on the camera. light. In addition, you can also manually adjust the exposure to com- pensate for backlighting, indirect indoor lighting, dark backgrounds, • The
Streszczenie treści zawartej na stronie nr. 11
Recording Images Operation Using the Flash Repeat Recording You can use the camera’s built in flash when recording images. You can use any of the three following methods to record a consecu- tive series of images. To change the flash mode • Shutter Button (CONT.S) Press button to cycle through flash modes in the following Images are continuously recorded (at intervals of about one sec- sequence: Auto Flash Flash On Flash Off. ond) as long as you keep the shutter button pressed. None Auto Flas
Streszczenie treści zawartej na stronie nr. 12
Recording Images Operation To record using timer recording 4. Use [+] and [–] to select the type of self-timer recording you want to perform, and then press the shutter button. 1. Mount the camera onto a tripod. 5. Point the camera at the subject and press the shutter but- 2. Slide the function switch to the REC position. ton. 3. Align the dial with to select timer recording. Note • Pressing the shutter button here, performs timer recording During self-timer recording, you may find it helpful t
Streszczenie treści zawartej na stronie nr. 13
Recording Images Operation Manual Recording 4. Use [+] and [–] to select the APT (Aperture Priority) setting With manual recording, you can set the aperture and white balance you want, and then press the shutter button. manually to produce exactly the effect you want. 5. Use [+] and [–] to select the WB (White Balance) setting you want, and press the shutter button. To record an image manually • The setting you make here remains in effect until you turn off 1. Slide the function switch to the RE
Streszczenie treści zawartej na stronie nr. 14
Playing Back Images Operation Producing a Multi-Page Display 5. Scroll through the images. Four or nine memory pages can be displayed at the same time. This • Use the [+] and [–] buttons to scroll images forward and feature can be used to display multiple memory pages on the cam- back. Each press shows a new screen of four or nine new era's built-in LCD, or on the screen of a connected TV. images. Multi-Page Display 1. Slide the function switch to the PLAY position. 2. Press the MENU butto
Streszczenie treści zawartej na stronie nr. 15
Playing Back Images Operation Notes 5. Press the shutter button. • If the page number is displayed in the upper right corner of the • The title is recorded at the brightness level you specified in screen when you perform a zoom operation, the number is replaced step 4. by a zoom area indicator ( ). This indicator shows you what part of the image is currently enlarged on the display. You can turn the Important! zoom area indicator on and off by pressing the DISP button. Recording a title causes a
Streszczenie treści zawartej na stronie nr. 16
Playing Back Images Operation Rotating an Image 7. Use the MENU button to select the background color. Use the following procedure to rotate an image in 90° increments. • Each press of [+] cycles forward through the background colors, To rotate an image while [–] cycles back. 1. Slide the function switch to the PLAY position. • There are 10 background colors. 2. Use the [+] and [–] buttons to scroll through the images in memory until the one you want to rotate is on the monitor screen. 8. Press
Streszczenie treści zawartej na stronie nr. 17
Playing Back Images Operation 6. Use [+] and [–] to select the locations you want to use, and 2. Start the auto play operation. then press the shutter button. • Hold down the [+] and [–] buttons until the message “AUTO • You can move the image vertically and horizontally. PLAY START” appears. 7. Use [+] and [–] to select the background you want to use, and then press the shutter button. • If you select the vertical ellipse and small circle, you also need to perform step 8, below. 1 second 1 sec
Streszczenie treści zawartej na stronie nr. 18
Playing Back Images Operation 3. Use [+] and [–] to select FOLDER, and then press the shut- 3. Use [+] and [–] to select FOLDER, and then press the shut- ter button. ter button. • FOLDER is located in MENU 3. 4. Use [+] and [–] to select SELECT, and then press the shutter 4. Use [+] and [–] to select MOVE, and then press the shutter button. button. 5. Use [+] and [–] to select the folder you want, and then press 5. Use [+] and [–] to select the folder to which you want to the shutter button. mov
Streszczenie treści zawartej na stronie nr. 19
Playing Back Images Operation 4. Use [+] and [–] to select ALL, and then press the shutter To unprotect all images in a folder or all images button. on the memory card • Now when the playback mode displays are turned on, the 1. Press button. indicator is shown in the upper left of all images that are pro- tected. 2. Use [+] and [–] to select FOLDER (to unprotect all images in a particular folder) or ALL (to unprotect all images on the memory card), and then press the shutter button. Unprotecti
Streszczenie treści zawartej na stronie nr. 20
Deleting Memory Pages Operation Note 3. Use [+] and [–] to select FOLDER, and then press the shutter button. Deleting a page causes the remaining pages to be renumbered. Blank pages are not left inserted between non-blank pages. 4. Use [+] and [–] to select the folder whose images you want to delete, and then press the shutter button. 5. To abort the delete operation without deleting anything, se- lect EXIT. Deleting All the Images in a Folder Use the following procedure to delete all the images
