Streszczenie treści zawartej na stronie nr. 1
STAINLESS STEEL GAS GRILL
`
USE AND CARE GUIDE
MODEL NO.: 720-0230
® ®
RR
FOR OUTDOOR USE ONLY
PLEASE CONTACT 1-800-913-8999 FOR ASSISTANCE
DO NOT RETURN TO PLACE OF PURCHASE.
Streszczenie treści zawartej na stronie nr. 2
TABLE OF CONTENT SECTION ONE SECTION THREE Importance………………………….….. 1 Precautions…………………………. . 2-3 Care and maintenance……………………..20 Placement of the grill……………….…. 3 Care and maintenance of the side burner….21 Trouble shooting…………………………..21 SECTION TWO Screw description………………………4 SECTION FOUR Assembly Instructions……………… 5-11 How to install a gas tank………………12 Exploded View……………………………22 Propane tank assembly……………… ..13 Parts List…………………………………. 23 Installation instruc
Streszczenie treści zawartej na stronie nr. 3
IMPORTANCE * * * WARNING * * * FOR YOUR SAFETY If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flame. 3. Open lid 4. If odor continues, immediately call your gas supplier or your fire department. FOR YOUR SAFETY 1. Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. 2. An LP cylinder not connected for use shall not be stored in the vicinity of this or any other ap
Streszczenie treści zawartej na stronie nr. 4
PRECAUTIONS Read this Care and Use Manual carefully and WARNING completely before using your grill to reduce the risk Do not try lighting this appliance without of fire, burn hazard or other injury. reading the “LIGHTING INSTRUCTIONS” section of this manual. Do not repair or replace any part of the grill unless specifically recommended in this manual. All other TESTED IN ACCORDANCE WITH ANSI service should be referred to a qualified technician. Z21.58b-2002, CGA 1.6B-20
Streszczenie treści zawartej na stronie nr. 5
PRECAUTIONS When using the grill, do not touch the grill rack, burner around the grill. The chemical that produces the spraying grate or immediate surroundings as these areas become action could, in the presence of heat, ignite or cause extremely hot and could cause burns. Use only dry metal parts to corrode. potholders. Moist or damp potholders on hot surfaces may cause burns from steam. Do not use a towel or Do not use the grill for cooking excessively fatty meats bulky cloth in p
Streszczenie treści zawartej na stronie nr. 6
Screw description Description(SCALE 1:1) Specification Quantity Item crossed round head screw 8pcs 1/4× 38mm crossed round head screw 1/4× 15mm 16pcs crossed round head screw 5/32× 10mm 4pcs 3 landfrom screw 1pc 5/32× 6+ φ 5× 5mm 4 retention screw 1pc φ 12× 155mm 5 4
Streszczenie treści zawartej na stronie nr. 7
ASSEMBLY INSTRUCTIONS PLEASE READ THE INSTRUCTIONS CAREFULLY AND FOLLOW STEP BY STEP. Attention: Please lock the caster during the process of installation of the grill. TOOLS REQUIRED: Philips head screwdriver(not provide), Crescent wrench(not provide) Step 1:Assemble two regular casters to the right side panels and caster with brakes on the left side panel as shown figure below. Step 2 : Assemble bottom panel to side panels with four (4) 1/4 x 38 mm screws as shown figure belo
Streszczenie treści zawartej na stronie nr. 8
Step 3: Assemble the back panel to the two sides panel. with four (4) 5/32 x 10mm screws as shown figure below. Step 4: Assemble the door handle to the door with the screw which packaged in the condiment rack 6
Streszczenie treści zawartej na stronie nr. 9
Step 5: Insert both doors’ hinge pins through the holes on the bottom of the bottom panel. Make sure the washers are in place. Then assembly the header frame on top of both doors by inserting the door hinge pins through the pre-drilled holes on the frame’s bottom side. Push the door and frame unit into the cart and fasten the frame on both sides with four (4) 1/4x38mm screws. Step 6: Remove the head unit of grill from carton. Insert the upper portion of the grill onto the cart from t
Streszczenie treści zawartej na stronie nr. 10
Step 7 : 1.Place flame tamers (3) on to the fire box as show figure below. 2.Place the cooking grids(2) on. 3. Place the warming rack on. Step 8: Use four (4)1/4 x 15mm screws to install the rear panel as show below. 8
Streszczenie treści zawartej na stronie nr. 11
Step9: Assemble side burner with (8) 1/4 x 15mm screws as figure show below. Connect the condiment tray and side shelf with two screws. The two screws have been fitted in side shelf. 9
Streszczenie treści zawartej na stronie nr. 12
ASSEMBLY INSTRUCTIONS Side burner valve assembly: Step 1: Insert valve assembly through side Step 2: Remove 4(four) screws & washers panel from the “U” brackets on the side burner #37 (Side panel, right #18B) Valve Step 3: Insert valve stem assembly in
Streszczenie treści zawartej na stronie nr. 13
Step 10:Assemble the condiment rack inside of the left door. Step11: Screw in the tank retention screw as the picture shown below. 11
Streszczenie treści zawartej na stronie nr. 14
How to install a gas tank Opening the front door and place gas tank into the gas tank holes. Secure the gas tank by turning the retention screw at the back of the grill clockwise until it is tight. Complete. 12
Streszczenie treści zawartej na stronie nr. 15
CLOSE PROPANE TANK ASSEMBLY ● With hand attach propane gas tank to regulator inlet fitting by turning the regulator clockwise until tight as shown in figure below. g CAUTION! DO NOT USE TOOLS TO ATTACH REGULATOR / HOSE ASSEMBLY TO PREOPANE TANK 13 OPEN
Streszczenie treści zawartej na stronie nr. 16
INSTALLATION INSTRUCTION MODEL 720-0230 GAS HOSE RETENTION KIT Package should include (4 pcs): Mounting bolt with ring slot Regulator ring clamp with wing bolt 1 wrench 1 Hex Nut and washer Hose Clamp Installation 1a. Insert “threaded end” 1b. Tighten nut with washer from mounting bolt through top middle the out side of panel with the vent included wrench 14
Streszczenie treści zawartej na stronie nr. 17
2a. Put regulator hose through 2b. Use wing bolt to fasten regulator ring clamp hose to ring clamp securely Your gas grill is ready to use 15
Streszczenie treści zawartej na stronie nr. 18
GAS HOOK-UP Only the pressure regulator and hose assembly supplied L.P. GAS HOOK-UP: with the grill should be used. Any replacement pressure Ensure that the black plastic grommets on the LP regulator and hose assembly must be specified by the cylinder valve are in place and that the hose does not grill manufacturer. come into contact with the grease tray or the grill head. This is a propane configured grill. Do not attempt to use a natural gas supply unless the grill has been CONNE
Streszczenie treści zawartej na stronie nr. 19
BEFORE TESTING Each grill burner is tested and adjusted at the factory Make sure that all packing material is removed from the prior to shipment; however, variations in the local gas grill including the burner tie-down straps. supply may make it necessary to adjust the burners. The flames of the burners should be visually checked. DO NOT SMOKE WHILE LEAK TESTING. Flames should be blue and stable with no yellow tips, NEVER PERFORM LEAK TEST WITH AN OPEN excessive noise or lifting. If
Streszczenie treści zawartej na stronie nr. 20
OPERATING INSTRUCTION General use of the grill and rotisserie Each main burner is rated at 12,000 Btu/hr. The main 4. Turn the control knob(s) to “HI” and preheat the grill burners encompass the entire cooking area and are grill for 15 minutes. The grill lid is to be closed side ported to minimize blockage from falling grease and during the appliance preheat period. debris. Above the burners are stainless steel radiants 5. Place the food on the grill and cook to the desired (flame cove
