Instrukcja obsługi Revolabs Inc.9004

Streszczenie treści zawartej na stronie nr. 1

Revolabs Single Channel System - Polycom HDX 9004 Setup Guide
NOTES AND CAUTIONS:

This setup guide will guide you through the steps needed to properly connect a
Revolabs Single Channel System to a Polycom HDX 9004 video codec.

1. Connecting the Cables
2. Configuring the HDX 9004 Video Codec

Note: It is important to carefully follow these instructions in order and completely.
Otherwise your Single Channel System and/or the video codec may not function
properly. Please read through

Streszczenie treści zawartej na stronie nr. 2

Streszczenie treści zawartej na stronie nr. 3

Connecting the Cables CONNECTING A REVOLABS SINGLE CHANNEL SYSTEM TO POLYCOM HDX 9004 VIDEO CODEC 1. Connect a Revolabs 2.5mm to RCA audio cable between the 2.5mm analog output on the Single Channel System and the red “Audio Input 1” port on the HDX 9004.

Streszczenie treści zawartej na stronie nr. 4

Configuring the HDX 9004 Video Codec CONFIGURING THE AUDIO MENUS OF THE HDX 9004 VIDEO CODEC 1. Select SYSTEM 2. Select ADMIN SETTINGS and enter the Administrator password (if needed) 3. Select AUDIO 4. Select AUDIO SETTINGS 5. Disable POLYCOM MICROPHONES by removing the check mark. Having Revolabs and Polycom microphones will increase ambient noise, add to echo cancellation problems, and reduce articulation* 6. Verify LIVE MUSIC MODE is disabled by removing the check mark. Polycom