Instrukcja obsługi Lightolier IS:CCLPS602P

Streszczenie treści zawartej na stronie nr. 1

Architectural Decorative IS:CCLPS602P
Page 1 of 4 Instruction Sheet for Assembly and Installation
Read and understand these instructions before installing luminaire
This luminaire is intended for installation in accordance with the National Electrical Code and local regulations. To assure full compliance with local codes and
regulations, check with your local electrical inspector before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these i

Streszczenie treści zawartej na stronie nr. 2

Architectural Decorative IS:CCLPS602P Page 2 of 4 Instruction Sheet for Assembly and Installation Connecting Power: Wiring: • Connect the IEC power cable to the back of unit. Plug the IEC power cable After mounting the power/data supply, you are ready to connect power, lumi- into a standard 100-240VAC outlet. Tighten the screw to secure the clamp. naires, and data to CCLPS602P. (See Fig. 5.) Connecting Luminaires to CCLPS602P Note: If power supply does not power up (front display is blank) ma

Streszczenie treści zawartej na stronie nr. 3

Architectural Decorative IS:CCLPS602P Page 3 of 4 Instruction Sheet for Assembly and Installation Grouping Luminaire Addresses Addressing the Luminaires CCLPS602P allows you to conserve the total number of luminaire addresses in an When using the DMX control input, you are required to set the base address for installation by grouping luminaires together. When you group luminaire address- the unit and configure the luminaires connected to it. es, you can assign multiple luminaires to the same a

Streszczenie treści zawartej na stronie nr. 4

Architectural Decorative IS:CCLPS602P Page 4 of 4 Instruction Sheet for Assembly and Installation 5. To exit Configuration mode, press both buttons simultaneously. The base Group How Luminaires Are Addressed address for CCLPS602P will appear on the display. Address CCLPS602P Specifications -1 All luminaires are addressed sequentially, starting with the Base Address. If you have 20 luminaires with a Base Address of 1, they are Power Input 100-240VAC, 50Hz–60Hz, 1.1-0.4A addressed as follows: