Streszczenie treści zawartej na stronie nr. 1
STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT
User and installer Manual
Sinewave Inverter, Battery charger
COMPA COMPA COMPA COMPAC C C CT C T C T C T C1312 1312 1312 1312
COMPA COMPAC CT C T C2324 2324
COMPA COMPAC CT C T C2324 2324
COMPA COMPA COMPA COMPAC C C CT C T C T C T C3548 3548 3548 3548
Temperature sensor CT-35
Remote control RC-01
Solar charge regulator Cxxxx-S
Remote power sharing RPS-01
Streszczenie treści zawartej na stronie nr. 2
STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT Index table 1 GENERAL INFORMATION.................................................................................................................................... 4 1.1 OPERATING INSTRUCTIONS .................................................................................................................................... 4 1.2 QUALITY AND WARRANTY ..................................
Streszczenie treści zawartej na stronie nr. 3
STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT 4.7.3 Delayed mode of the Transfer System......................................................................................................... 17 4.8 THE SOLAR CHARGE REGULATOR (OPTION) ......................................................................................................... 17 4.9 THE MULTIFUNCTIONAL CONTACT............................................................
Streszczenie treści zawartej na stronie nr. 4
STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT 1 General Information 1.1 Operating instructions This manual is a part of the delivery package of every COMPACT inverter-charger. It serves as guidelines for safe and efficient operation of COMPACT. The instructions are only valid for use with the following devices and options: • COMPACT C1312 • COMPACT C2324 • COMPACT C3548 • Temperature sensor CT-35 • Remote Control RCC 01
Streszczenie treści zawartej na stronie nr. 5
STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT During operation of COMPACT, high tensions are generated at the connections and inside of the appliance which could be deadly fatal. Work on the appliance and on the installation should only be carried out by qualified and trained personnel. The whole installation connected with the COMPACT must comply with the respective valid codes and ordinances. Persons without the written author
Streszczenie treści zawartej na stronie nr. 6
STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT 2 Introduction The COMPACT is a sine wave inverter with integrated battery charger and solar charger regulator with many additional functions, it has been developed to be used as stand-alone (independent of a grid-system) AC provider, or as continuous / break-free current supply provider. 2.1 Principe schematic AC IN AC OUT 10nF 1uF L L 100nF Input PE Output PE 230Vac 230Vac N N 10nF
Streszczenie treści zawartej na stronie nr. 7
STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT 2.2.4 The solar charge regulator (optional) With the built-in solar charge regulator, the COMPACT is a complete solar-power-center. In a solar installation this regulator ensures that the batteries are charged correctly. With the COMPACT, batteries can be charged with a generator and with the solar modules at the same time. The charging of batteries with both energy sources is carried
Streszczenie treści zawartej na stronie nr. 8
STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT 2.3.3 Parallel- Series Connection: 12V 12V 12V 12V 24V 3 Assembly 3.1 Place of assembly The location of the COMPACT must be chosen by the following criteria: Protection from unauthorized handling. Dry dust free room, no condensation. Never install directly over the battery and never in a cabinet together with the batteries. Keep ventilation holes free. The ventilation of COMPACT is
Streszczenie treści zawartej na stronie nr. 9
STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT 3.3.2 Protection cover for the terminals connections The protection is available in option (Order ref. CFC-01) and avoid to do wrong hazardous connection on the terminals 230Vac. It mounted with strain relief clamps for the cable. 3.4 Connecting Plan / Front side M AL N O Don't open before Caution: Check battery disconnect line polarity (+/-) before connecting! Remot
Streszczenie treści zawartej na stronie nr. 10
STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT K AC Output Connecting terminal for AC-output L Caution… Caution: Check Polarity(+/-) before connecting the battery! Polarity reversal can damage the COMPACT. M Don‘t … Do not open without disconnecting all terminals N 15A Protection 15A Protection switch for the Transfer system O Remote Power Input current repartition Sharing 3.5 Cabling/wiring Connecting of the COMPACT is a
Streszczenie treści zawartej na stronie nr. 11
STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT 3.5.5 Connect the Solarmodules: SOLAR +/- (Only for solar option) Solar modules are connected on these terminals. Under no circumstances should any other energy source i.e. wind generator be connected to these terminals! Only solar modules must be connected with two cables +/-. Depending on the power of the modules, the cable cross section should be 2 2.5 up to 6mm . Before connectin
Streszczenie treści zawartej na stronie nr. 12
STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT 4 Operating 4.1 Display and operating control elements POWER Inverter output MONITOR power Charge [%] Charger - Inverter current 200 160 [A] 130 INPUT LIMIT CHARGER TRANSFER STANDBY 70 100 60 80 50 60 40 40 30 20 16A 70A 230V 20W 20 10 23 10 5 25 0 26 0 22 150V OFF 24 AC IN 8 AC OUT 1 7 CHARGER INVERTER 2 9 SOLAR CHARGE 20 RESET ALARM 3 Lock (select) 10 EQUALIZE 14 Over Temp Overload
Streszczenie treści zawartej na stronie nr. 13
STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT 4.2 Light Emitting Diodes: LED Marking LED lit LED blinks 1 AC IN Voltage corresponding to self- Voltage, outside of the self- adjusted values is at the AC IN adjusted values is at the AC IN input. input. 2 CHARGER Battery Charger is working The input voltage is out value (voltage or frequency) 3 SOLAR Connected Solarmodules are CHARGE delivering energy 4 Program Program mode fo
Streszczenie treści zawartej na stronie nr. 14
STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT 4.5 The Inverter An Inverter is built in the COMPACT, which generates a sinusoidal alternating voltage of a very high quality. With this Inverter any alternating voltage consuming device 230Vac up to the nominal power of your COMPACT can be operated. Thanks to the generous dimensioning of the COMPACT, you can operate appliances requiring higher power than the nominal power of the COM
Streszczenie treści zawartej na stronie nr. 15
STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT 4.6 The Battery charger 4.6.1 Cycle of charge The full automatic COMPACT Battery Charger is adjusted at the factory so that most lead-acid and lead-gel batteries can be charged to the maximum. As soon as the minimum alternating voltage for the AC IN set on the Turning Knob 23 is available at the input (LED 1 AC IN is lit), the Battery Charger is switched on automatically (LED 2 CHARGE
Streszczenie treści zawartej na stronie nr. 16
STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT the OUTPUT less it’s give to the charger. Priority for the OUTPUT. When the power sharing is used the LED 200% (red) is lit to point out that’s the charge is limited. Caution: If the power use on the OUTPUT is higher than the value of the INPUT LIMIT (26) the COMPACT limit the current, then the generator means to stop or the circuit breaker before means to break. In option, a remo
Streszczenie treści zawartej na stronie nr. 17
STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT Note: In the Inverter operation, The COMPACT generates a true sinusoidal and quartz stabilized output voltage. When, however the COMPACT is supplied from a grid or a generator and the transfer contact is active, then you have at the output AC OUT the same voltage as that at the input. This voltage can not be modified by the COMPACT! 4.7.1 Set the transfer voltage threshold The voltag
Streszczenie treści zawartej na stronie nr. 18
STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT Maximum Contact load: -230Vac /16Amp-30Vdc/1A! With the Push Button 21 „AUXILARY CONTACT“ the contact can be manually switched on or off independent of programming and the operating situation. The LED 5 “Contact active” show the state of the contact. The drawing up the screw terminal “AUX CONTACT” is the inactive position mode, LED 5 “Contact active” off. The switching on and off of
Streszczenie treści zawartej na stronie nr. 19
STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT 4.11 The Temperature sensor Operating voltage of lead-acid batteries change depending on the temperature. To correct the operating voltages according to the actual temperatures, a temperature sensor can be connected to the COMPACT. The compensation through the sensor is –3mV/°C/Cell. Order Number: CT-35 Dimensions: H x B x T / 58 x 51.5 x 22mm 5 Programming: 5.1 Standard settin
Streszczenie treści zawartej na stronie nr. 20
STUDER INNOTEC COMPACT COMPACT COMPACT COMPACT 5.3.2 Set the voltage and timing threshold 3 RESET ALARM 20 lock The programming is done in accordance with the following steps: 14 10 Over Temp Push and hold down, the Push Button 21 11 Overload 15 4 (Program) and the Push Button 19 12 Batt Low/High (Change status) for minimum 2 seconds 5 16 simultaneously. 6 13 OFF With the Push Button 20 (select) select 17 with of the battery
