Streszczenie treści zawartej na stronie nr. 1
Glide Master 340
®
Glide Master 360
Glide Master 380
Original Instructions
IMPORTANT INFORMATION
Read before use
& retain for future reference
Streszczenie treści zawartej na stronie nr. 2
Carton Contents Easi Reel cable winder electric cable with moulded plug start/stop levers switchbox instruction cutting height spac- manual ers (1 fitted to lawn- mower & 2 inside product under grassbox) spanner/scraper tool (inside product under grassbox) IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product. IF ANY PARTS ARE MISSING CONTACT:- Husqvarna UK Ltd. Customer Service Department direct Telephone : 0844 844 4558 UK 1800 882 35
Streszczenie treści zawartej na stronie nr. 3
Electrical feasible. 3. Take care in wet grass, you may lose your footing. 1. The British Standards Institute recommend the use of a Residual Current Device (R.C.D.) with a tripping current of 4. On slopes, be extra careful of your footing and wear not more than 30mA. Even with a R.C.D. installed 100% non-slip footwear. safety cannot be guaranteed and safe working practice 5. Mow across the face of slopes, never up and down. must be followed at all times. Check your R.C.D. every 6. Exercise
Streszczenie treści zawartej na stronie nr. 4
Assembly Instructions A B Preparing your lawnmower for use • Make sure that the cable does not become trapped •Your lawnmower is supplied with the upper handle between the handles folded over the machine for packing and transporta- tion. Attach the Easi-Reel cable winder as illustrated in figure Handle in Operating Position B 1. Lift handle as illustrated in figure A. This is used to store the power cable after using the •Do not drop the handle. product - see ‘Easi-Reel Cable Winder’ section. St
Streszczenie treści zawartej na stronie nr. 5
Grassbox Instructions Grassbox Full (J) J grassbox 1. As the grassbox fills up, grass will be clearly visible grassbox is full through the window in the lid (J). is empty 2. When the window is full it is time to empty the grass- box. Emptying the Grass •Stop the lawnmower, and wait until the blade has stopped rotating BEFORE lifting the grassbox lid. 1. Lift grassbox lid. (K) 2. Lift out grassbox and empty. (L) 3. Replace grassbox and close lid carefully. • Failure to fit the grassbox and grass
Streszczenie treści zawartej na stronie nr. 6
Spanner & Spacers N There is a spanner and additional spacers, for height ad- justment, stored inside the lawnmower underneath the grassbox.(N) These can be stored inside the lawnmower even whilst it is use. Adjusting the Cutting Height Always handle the blade with care - sharp edges could P cause injury. USE GLOVES. Never use more than 3 Cut- ting Height Spacers. Spacers must only be fitted be- tween the blade and the fan and NEVER between the blade and the bolt. 1. Remove the blade bolt, a
Streszczenie treści zawartej na stronie nr. 7
Caring for your Lawnmower R1 R2 Cleaning IMPORTANT: It is very important that you keep your lawn- mower clean. Grass clippings left in any of the air intakes or under the hood could become a potential fire hazard. USE GLOVES. Switch off and remove the plug from the mains before cleaning. It is recommended that you clean your lawnmower straight after mowing while the grass is still wet. 1. Remove grass from under the hood with the span- ner/scraper tool provided. (R1) R3 R4 2. Remove the blade,
Streszczenie treści zawartej na stronie nr. 8
Fault Finding Hints Fails to Operate Poor Collection 1. Is the correct Starting procedure being followed? See 1. Is the grassbox lid firmly closed? ‘To Start your Lawnmower’ 2. Is the grassbox fitted correctly? 2. Is the Power Turned On? 3. Are you mowing correctly? 3. Check the fuse in the plug, if blown replace. 4. Check all air vents and openings are not obstructed. 4. Fuse continues to blow? 5. Raise to a higher height of cut. See ‘Adjusting the Cut- Immediately disconnect from the mains e
Streszczenie treści zawartej na stronie nr. 9
Environmental Information Husqvarna UK Ltd. are manufactured under an Environmental Management System (ISO 14001) using, where practi- cal, components manufactured in the most environmentally responsible manner, according to company procedures, and with the potential for recycling at the end of the products’ life. • Packaging is recyclable and plastic components have been labelled (where practical) for categorised recycling. • Awareness of the environment must be considered when disposing of ‘en
