Streszczenie treści zawartej na stronie nr. 1
02764
LT2220 CMA2
Operator's Manual
Streszczenie treści zawartej na stronie nr. 2
SAFETY RULES Safe Operation Practices for Ride-On Mowers DANGER: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROW ING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. • Do not operate the machine while under the influence WARNING: In order to prevent ac ci den tal of alcohol or drugs. starting when setting up, trans port ing, • Watch for traffic when operating near or crossing ad just ing or making repairs, al wa
Streszczenie treści zawartej na stronie nr. 3
SAFETY RULES Safe Operation Practices for Ride-On Mowers GENERAL SERVICE III. CHILDREN • Never operate machine in a closed area. Tragic accidents can occur if the operator is not alert to • Keep all nuts and bolts tight to be sure the equipment the presence of children. Children are often attracted to is in safe working condition. the ma chine and the mowing activity. Never assume that • Never tamper with safety devices. Check their proper children will remain where you last saw them. ope
Streszczenie treści zawartej na stronie nr. 4
CONGRATULATIONS on your purchase of a new tractor. PRODUCT SPECIFICATIONS It has been designed, engineered and manu fac tured to give you the best possible dependability and per for mance. Gasoline Capacity 2.0 Gallons and type: Unleaded Regular Should you experience any problem you cannot easily remedy, please contact your nearest authorized service Oil Type (API-SG-SL): SAE 30 (above 32°F) SAE 5W-30 (below 32°F) center. We have competent, well-trained tech ni cians and the proper
Streszczenie treści zawartej na stronie nr. 5
UNASSEMBLED PARTS Steering Steering Wheel Insert (1) Steering Wheel (1) Flat Washer Steering Wheel Steering Adapter Boot (1) Locknut Seat (1) Washer (1) Knob (1) Seat Keys Slope Sheet (1) Oil Drain Tube For Future Use (2) Keys 5
Streszczenie treści zawartej na stronie nr. 6
ASSEMBLY Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to ensure proper tightness. ATTACH STEERING WHEEL (See Fig. 2) TOOLS REQUIRED FOR ASSEMBLY • Remove locknut and large flat wash er from steering A socket wrench set will make assembly easier. Stan dard shaft. wre
Streszczenie treści zawartej na stronie nr. 7
02330 02277 02590 ASSEMBLY TO INSTALL BAGGER COM PO NENTS TO INSTALL SEAT (See Fig. 3) TRAC TOR (See Figs. 4A-4D) Adjust seat before tightening adjustment knob. • Remove discharge chute from rear of tractor. Unhook • Remove adjustment knob and flat washer securing the two (2) straps and pull chute out and away from seat to cardboard packing and set aside for assembly tractor. of seat to tractor. • Remove the two (2) 3/8 nuts and flat washers from the • Pivot seat upward and remove from
Streszczenie treści zawartej na stronie nr. 8
02306 ASSEMBLY NOTE: The strap hook must go through the discharge chute DUMP HANDLE only. Do not allow the hook to enter the slot in the tractor TUBE back plate. This will allow the dis charge chute to float with the mower deck when moving on uneven terrain. CLEVIS PIN 10 X 44MM RETAINER SPRING DIS CHARGE CHUTE HOOK CAP BACKPLATE Fig. 5C SLOT BAGGER ADJUSTMENT (See Fig. 6 & 7) Fig. 4D For proper bag function and appearance, it may be nec- TO ASSEMBLE BAGGER (See Figs. 5A-5C) es sary to adj
Streszczenie treści zawartej na stronie nr. 9
02983 A A 02214 ASSEMBLY • After proper fit is attained, remove bagger from trac- CHECK FOR PROPER POSITION OF ALL BEL TS tor and install bagger latch (4) to tractor back plate as See the figures that are shown for replacing motion and shown. Tighten securely. mower blade drive belts in the Service and Adjustments sec- • Install and carefully lower bagger to actuate latch. tion of this manual. Verify that the belts are routed correctly. • Measure distance between bagger and latch as shown.
Streszczenie treści zawartej na stronie nr. 10
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their meaning. REVERSE HIGH LOW FAST SLOW NEUTRAL CHOKE IGNITION SWITCH P ENGINE START ENGINE OFF REVERSE ENGINE ON PARKING BRAKE PARKING BRAKE PARKING BRAKE OPERATION LOCKED UNLOCKED SYSTEM (ROS) OIL PRESSURE BATTERY REVERSE OVER TEMP FUEL FORWARD MOWER HEIGHT MOWER LIFT LIGHT 15 15 ATTACHMENT ATTACHMENT BRAKE/CLUTCH SLOPE HAZARDS CLUTCH ENGAGED KEEP AREA CLEAR CLUTCH DISENGAG
Streszczenie treści zawartej na stronie nr. 11
OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. ROS "ON" SERVICE POSITION REMINDER/ IGNITION HOURMETER ATTACHMENT SWITCH CLUTCH SWITCH LIFT LEVER PLUNGER LIGHT SWITCH CLUTCH/BRAKE PEDAL ATTACHMENT LIFT LEVER THROTTLE/CHOCK CONTROL PARKING BRAKE MOTION HEIGHT CONTROL ADJUS
Streszczenie treści zawartej na stronie nr. 12
OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while op- erating your tractor or per form ing any adjustments or repairs. We rec om mend a wide vision safety mask over spectacles or stan dard safety glasses. IMPORTANT: LEAVING THE IGNITION SWITCH IN ANY HOW TO USE YOUR TRACTOR POSITION OTHER THAN "STOP" WILL CAUSE THE BATTERY TO BE DIS CHARGED, (DEAD). TO SET PAR
Streszczenie treści zawartej na stronie nr. 13
OPERATION TO ADJUST GAUGE WHEELS (See Fig. 11) TO STOP MOWER BLADES (See Fig. 13) • Disengage at tach ment clutch con trol. Gauge wheels are properly adjusted when they are slightly off the ground when mower is at the desired cutting height in operating position. Gauge wheels then keep the deck in prop- CAUTION: Do not operate the mower er position to help prevent scalping in most terrain conditions. without the en tire grass catcher in place. NOTE:Adjust gauge wheels with tractor on a fla
Streszczenie treści zawartej na stronie nr. 14
OPERATION TO TRANSPORT (See Fig. 14) BEFORE STARTING THE ENGINE When push ing or tow ing your trac tor, be sure to disengage CHECK ENGINE OIL LEVEL transmission by placing freewheel control in free wheel ing po si tion. Free wheel control is located under the seat. The engine in your tractor has been shipped, from the factory, already filled with sum mer weight oil. • Raise attachment lift to highest position with at tach ment lift control. • Check engine oil with tractor on level grou
Streszczenie treści zawartej na stronie nr. 15
OPERATION TO START ENGINE (See Fig. 9) PURGE TRANSMISSION When starting the engine for the first time or if the engine CAUTION: Never engage or disengage has run out of fuel, it will take extra cranking time to move freewheel lever while the engine is run ning. fuel from the tank to the engine. • Be sure freewheel control is in the transmission en gaged position. To ensure proper operation and performance, it is rec om- • Sit on seat in operating position, depress clutch/brake mend ed that
Streszczenie treści zawartej na stronie nr. 16
02306 OPERATION TO DUMP BAGGER (See Fig. 15) MULCHER PLUG Your tractor is equipped with a Dump Bag Alarm. To turn off the alarm disengage the attachment clutch switch. • Position tractor in location you wish to dump bag ger. • Place motion control lever in Neu tral po si tion and set parking brake. • Raise dump handle to its highest position. Pull handle forward to raise bagger and dump clippings. • To continue mowing, be sure bag ger is down and in proper operating po si tion which will
Streszczenie treści zawartej na stronie nr. 17
OPERATION MOWING TIPS • Mower should be properly leveled for best mowing per- formance. See “TO LEVEL MOWER HOUSING” in the Service and Adjustments section of this manual. • The left hand side of mower should be used for trim- ming. • If grass is extremely tall, it should be mowed twice to reduce load and possible fire hazard from dried clip- pings. Make first cut relatively high; the second to the desired height. • Do not mow grass when it is wet. Wet grass will plug mower and leave u
Streszczenie treści zawartej na stronie nr. 18
maint_sch-tractore.ROS.e MAINTENANCE BEFORE EVERY EVERY EVERY EVERY EVERY BEFORE MAINTENANCE EACH 8 25 50 100 SEASON STORAGE SCHEDULE USE HOURS HOURS HOURS HOURS Check Brake Operation Check Tire Pressure T Check Operator Presence & ROS Systems R Check for Loose Fasteners A Check/Replace Mower Blades 3 C T Lubrication Chart 0 Check Battery Level 4 R Clean Battery and Terminals Check Transaxle Cooling Check Mower Levelness Check V-Belts Check Engine Oil Level Change Engine Oil (with oil filter) 1
Streszczenie treści zawartej na stronie nr. 19
MAINTENANCE TRACTOR BLADE CARE(See Figs.20-22) Always observe safety rules when per form ing any main- For best results mower blades must be kept sharp. Replace te nance. bent or damaged blades. IMPORTANT: THE BLADES ON YOUR MOW ER ARE NOT THE BRAKE OPERATION SAME AND MUST BE INSTALLED ON THE CORRECT SIDE. IT If tractor requires more than five (5) feet to stop at highest IS SUG GEST ED THAT YOU WORK ON ONE BLADE AT A TIME speed in high est gear on a level, dry concrete or paved TO ENSURE
Streszczenie treści zawartej na stronie nr. 20
MAINTENANCE V-BELTS 6 STAR PATTERN BLADE Check V-belts for deterioration and wear after 100 hours The center of this blade has a 6 star pattern. The bolt at- of operation and replace if necessary. The belts are not tach ing this blade has Left Hand threads that loosens by ad just able. Re place belts if they begin to slip from wear. turning ( ) clockwise and tight en by turning ( ) coun ter- clock wise. TRANSAXLE COOLING The transmission fan and cooling fins should be kept clean MANDREL
