Instrukcja obsługi Revolabs Inc.VSX7000e

Streszczenie treści zawartej na stronie nr. 1

Revolabs Fusion™ Microphone System- Polycom VSX7000e Setup Guide
NOTES AND CAUTIONS:


This setup guide will guide you through the steps needed to properly connect a
Revolabs Fusion System to a Polycom VSX7000e video codec.

1. Connecting the Cables
2. Configuring the VSX7000e Video Codec

Note: It is important to carefully follow these instructions in order and completely.
Otherwise your Fusion System and/or the video codec may not function properly.
Please read through these inst

Streszczenie treści zawartej na stronie nr. 2

Connecting the Cables CONNECTING A REVOLABS FUSION SYSTEM TO POLYCOM VSX7000e VIDEO CODEC 1. Connect a male RCA-RCA audio cable between the “CONF IN” port on the Fusion and the red “AUDIO OUT” port on the VSX7000e. 2. Connect a male RCA-RCA audio cable between the “CONF OUT” port on the Fusion and the red “LINE INPUT” port on the VSX7000e. 3. Connect a Male RCA audio cable between the “Room Out” port on the Fusion and the Speakers. Note: The speak

Streszczenie treści zawartej na stronie nr. 3

Configuring the VSX7000e Video Codec CONFIGURING THE AUDIO MENUS OF THE VSX7000e VIDEO CODEC 1. Select SYSTEM 2. Select ADMIN SETTINGS 3. Select AUDIO 4. Set Red LINE INPUT to AUDIO MIXER 5. DISABLE Echo Canceller 6. DISABLE Polycom microphones by removing checkmark on ENABLE POLYCOM MICROPHONES 7. Set the output volume on the VSX7000e to 100% or “50” in the audio configuration menu. NOTE: You must use your Fusion remote control to control the room volume for both the audio and v