Streszczenie treści zawartej na stronie nr. 1
Hurricane 9000
ADSL Modem/Router
User's Manual
Version 1.0
1
Streszczenie treści zawartej na stronie nr. 2
Contents Section One: Introduction ......................................................... 4 1.1 System Requirements.............................................. 4 1.2 Features Summary .................................................. 4 Section Two: Connect the Modem/Router............................... 6 2.1 This Package Contents............................................. 6 2.2 Product View............................................................ 7 2.3 Hardware Installation........
Streszczenie treści zawartej na stronie nr. 3
The information contained in this manual has been verified at the time of this manual's printing. The manufacturer reserves the right to make any changes and improvements in the product described in this manual at any time and without notice. All registered trademarks are the property of their respective owners. Copyright © 2002 All rights reserved. No reproduction of this docu- ment in any form is permitted without prior written authorization from the manufacturer. 3
Streszczenie treści zawartej na stronie nr. 4
Section One: Introduction Section One - Introduction The Hurricane 9000 provides Full rate (ANSI and G.DMT) as well as G.lite ADSL standards line support, and can be connected to PC through Ethernet or USB . This product supports bridge feature set for the integration of ADSL service into corporate or home LAN and WAN. 1.1 System Requirements Before connecting the Hurricane 9000 to your PC, make sure your sysytem is equipped with the Ethernet NIC card or USB port and TCP/IP protocol. 1.2 Fea
Streszczenie treści zawartej na stronie nr. 5
Section One: Introduction Bridge Mode Ethernet to ADSL self-learning Transparent Bridging (IEEE 802.1D) Supports up to 128 MAC learning addresses· Router Mode IP routingñRIPv2 Static routing DHCP (Dynamic Host Configuration Protocol) Server and Client NAPT (Network Address and Port Translation) NAT (Network Address Translation) ICMP (Internet Control Message Protocol) Simultaneous USB and Ethernet operation· Security User authentication for PPP PAP (Password Authentication Protocol) CHAP (Challe
Streszczenie treści zawartej na stronie nr. 6
Section Two: Connect the Modem/Router Section Two - Connect the Modem/Router 2.1 This Package contents 1. One ADSL Router modem 2. One RJ-45 straight cable 3. One RJ-11 telephone cable 4. One USB cable 5. 12V Power Adaptor CD 6. User's Manual & For any missing items, Please contact your dealer immediately. 1. 5 2 3 6 4 6
Streszczenie treści zawartej na stronie nr. 7
Section Two: Connect the Modem/Router 2.2 Product View POWER LED LAN LED TX/RX LED LINK LED Power Switch RJ11 Line Jack Reset Button Power Connector (Set to factory Default) USB Connector RJ45 LAN Jack 7
Streszczenie treści zawartej na stronie nr. 8
Section Two: Connect the Modem/Router 2.3 Hardware Installation The following steps instruct you to install the Hurricane 9000 for one computer. For more than one computer, please refer to 2.4 Network Connection. 1. Plug the end of the Ethernet cable into the LAN Jack of the Hurricane 9000. 2. Plug the other end of the Ethernet cable into your computer’s RJ45 Jack of Ethernet card. 3. Connect the Power adaptor to the Power Connector. 4. Plug the telephone cable into the Line Jack .
Streszczenie treści zawartej na stronie nr. 9
Section Two: Connect the Modem/Router 2.4 Network Connections 2.4.1 for One PC RJ-45 RJ-11 ADSL or USB Cable 2.4.2 for more than one PC ADSL HUB/Switch RJ-11 RJ-45 ...... 2.5 LED Indicators The ADSL Router modem features LED indicators on the front panel that report modem status: POWER Red Power Light / Steady when power is on. LINK Green WAN Link / Steady during ADSL line status is showtime. TX/RX Green WAN Activity / Blinking when transmitting/receiving data. LAN Green LAN Link / Bli
Streszczenie treści zawartej na stronie nr. 10
Section There: Configure the PCs Section Three - Configure the PCs 3.1 Configure your PC. The instructions in this section will help you to configure each computer to communicate with the Router. To do this, you need to configure your PC’s network settings to obtain an IP address automatically from the DHCP of the router. Computers use IP addresses to communicate with each other across a network, such as the Internet. 1. Go to the Network screen by clicking the Start button. Click Setting
Streszczenie treści zawartej na stronie nr. 11
Section There: Configure the PCs 3.2 Verify the link between your PC and Router a) From start > Run b) Enter ping 10.0.0.2 –t and click OK c) If the connection has been established, You will receive reply from the router. d) If you receive “Request timed out”, that means the link has not been established, pls. check the network cable and IP address. (or try to restart your PC) Notes: 1. Under MS-DOS mode, you can type ipconfig to check your IP address. (to renew IP: ipconfig /renew ) 2.
Streszczenie treści zawartej na stronie nr. 12
Section Four: Web-Based Management Section Four Web-Based Management 4.1. Login 1) Open Internet Explorer /Netscape , type http://10.0.0.2 2) The system will ask for administrator’s username and password when restarting or configuring. It is illustrated in the following figure. Default username: admin password: password 12
Streszczenie treści zawartej na stronie nr. 13
Section Four: Web-Based Management 4.2 Quick Setup Quick Setup page allows user to set the configuration for the WAN/ ADSL ports. VPI/VCI: ATM VC of local ADSL Internet Service Provider. (e.g. Singapore: VPI/VCI=0/100; Malaysia: VPI/VCI=0/35; Indonesia: VPI/ VCI=1/33; SriLanKa: VPI/VCI=8/35) Username and Password: the user name and password will be provided by your ISP when applying for PPP ADSL service. Encapsulation: PPPoA, PPPoE, 1483 router, IPoA and 1483 Bridge. Please selct one acc
Streszczenie treści zawartej na stronie nr. 14
Section Four: Web-Based Management Static WAN IP Configuration (Optional) If you are using 1483 Routed IP or Classical IP over ATM, please enter the IP address, Subnet Mask and Gateway (Provided by your local ISP) Disconnect Timeout: The Disconnect Timeout allows users to set the specific period of time to disconnect from the ISP. The default is 0, which means never disconnect from the ISP. Q: If the PPP is disconnected after the Disconnect Timeout and how can I reconnect it. A: You have t
Streszczenie treści zawartej na stronie nr. 15
Section Four: Web-Based Management 4.3 ADSL Line Status. The ADSL Line Status page shows the ADSL physical layer status. 4.4 WAN/LAN Status. The WAN/LAN Status page shows the WAN , LAN interface status. 15
Streszczenie treści zawartej na stronie nr. 16
Section Four: Web-Based Management 4.5 PPP Status. The PPP Status page shows the status of PPP for each PVC Connect and Disconnect allows users to manually connect/disconnect the PPP connection for one PVC. 4.6 System Log. The System Log page shows the events triggered by the system. 16
Streszczenie treści zawartej na stronie nr. 17
Section Four: Web-Based Management 4.7 Advanced Setup. 4.7.1 LAN/DHCP. The LAN/DHCP page allows user to set the configuration for the LAN port. IP Address/Subnet: LAN address and subnet mask of the router. It can be specified if you need. (e.g. 192.168.0.1/255.255.255.0) DHCP Server System Allocated: The DHCP address pool is based on LAN port IP address plus 12 IP addresses. For example, the LAN IP address is 10.0.0.2; the DHCP address pool is at the range of 10.0.0.3 to 10.0.0.14 User Def
Streszczenie treści zawartej na stronie nr. 18
Section Four: Web-Based Management 4.7.2 Port Forwarding The Port Forwarding page allows users to set the configuration of Virtual Server. If any specific local PCs need to be mapped to the UDP/ TCP port on WAN side, please input the mappings here. For Example, If you want to forward FTP to your 10.0.0.20 server (set to static IP): Public Port :21 Private Port:21 Port Type: TCP Host IP Address: 10.0.0.20 Customized Port TCP UDP Application Web server 80 Yes Yes FTP server 21
Streszczenie treści zawartej na stronie nr. 19
Section Four: Web-Based Management 4.7.3 NAT Configuration The NAT Configuration page allows users to set the configuration for the Network Address Translation. NAT Configuration The NAT option only maps single WAN IP address to the local PC IP address. It is peer-to-peer mapping. (1x1) For each PVC, only one local PC IP address can be associated with each WAN PVC. Click the link Session Name Configuration to add the session name for each PVC. Q: Since only one PVC is mapped to one local P
Streszczenie treści zawartej na stronie nr. 20
Section Four: Web-Based Management 4.7.4 Bridge Filtering The Bridge Filtering page allows users to set the configuration of IP filtering. Source MAC: When the bridge filtering is enabled, enter the Source MAC address, select Block and click Add. Then all incoming WAN and LAN Ethernet packets matched with this source MAC address will be filtered out. If the Forward is selected, then the packets will be forwarded to the destination PC. Destination MAC: When the bridge filtering is enabled,
