Streszczenie treści zawartej na stronie nr. 1
Heritage Series ADSL Bridge/ Router
Heritage Series
Multi-Mode
xDSL Router
User’s Manual
Dec. 2003
Streszczenie treści zawartej na stronie nr. 2
Heritage Series ADSL Bridge/ Router Copyright All rights reserved. No part of this document may be reproduced in any form or by any means without written permission from the product manufacturer. Changes are periodically made to the information in this document. They will be incorporated in subsequent editions. The product manufacturer may make improvements and/or changes in the product described in this document at any time.
Streszczenie treści zawartej na stronie nr. 3
Heritage Series ADSL Bridge/ Router Table of Contents Chapter 1 Introduction 1-1 1.1 Overview 1-1 1.2 Features and Compatibility 1-2 1.3 What’s in the package? 1-4 1.4 Important Rules for Safe Operation 1-5 1.5 Front Panel 1-8 1.6 Real Panel 1-9 Chapter 2 Installing and Configuring your xDSL Router 2-1 2.1 Preparation for Hardware and Software Installation 2-2 2.2 Hardware Installation 2-4 2.3 Windows 95/98 setting for Ethernet LAN connection 2-5 2.
Streszczenie treści zawartej na stronie nr. 4
4.2 Enables NAT to RFC1483, Classic IP (RFC1577), PPP over ATM (RFC2364) and PPP over Ethernet (RFC2516) in Routing mode 4-4 4.3 Changing DHCP server configuration 4-6 4.4 Changing DHCP client configuration 4-9 4.5 PPTP Tunneling Configuration 4-11 Chapter 5 Managing The xDSL Router 5-1 5.1 Booting the xDSL Router from Ethernet Network 5-1 5.2 Upgrading on-board flash memory from Ethernet Network 5-2 5.3 SNMP 5-3 Chapter 6 xDSL Link Performance Statistics
Streszczenie treści zawartej na stronie nr. 5
Heritage Series ADSL Bridge/ Router 8.4 Configuration reference guide 8-4 Chapter 9 DHCP Client Configuration 9-1 9.1 Protocol Timing 9-2 9.2 Lease requirements and requests 9-3 9.3 Other declarations 9-4 9.4 DHCP Options 9-5 Appendix A Product Specifications A-1 Appendix B Troubleshooting A-4 Appendix C Glossary A-8 Appendix D Government Compliance Notices A-16
Streszczenie treści zawartej na stronie nr. 6
Heritage Series ADSL Bridge/ Router Introduction 1-1 Chapter 1 Introduction 1.1 Overview This xDSL Router features two broadband technologies such as ADSL and SHDSL. Multi-mode ADSL technology that provides a downstream rate of up to 8Mbps over existing copper wire lines, which is more than 100 times faster than a traditional 56K analog modem. SHDSL technology that provides a symmetric upstream and downstream rate of up to 2.3Mbps over existing copper wire lines.
Streszczenie treści zawartej na stronie nr. 7
Introduction 1-2 1.2 Features and Compatibility This Heritage series Router provides the following features: ! Multi-mode ADSL technology supports ITU-T G.dmt, G.lite, G.hs and ANSI T1.413 issue 2 to provide interoperability with most of DSLAM equipments. ! SHDSL technology supports ITU-T G.shdsl, G.hs and ANSI T1E1.4 to provide interoperability with most of DSLAM equipments. ! ATM (Asynchronous Transfer Mode) protocol allows the QoS(Quality of Service) transmission over a netw
Streszczenie treści zawartej na stronie nr. 8
Heritage Series ADSL Bridge/ Router Introduction 1-3 network ! Flash memory for Software upgrade ! Status LEDs for easy monitoring and troubleshooting Some models of xDSL Router provides more features: ! Including 4-port 10/100 Base-T Ethernet Stackable Switch Hub.
Streszczenie treści zawartej na stronie nr. 9
Introduction 1-4 1.3 What’s in the package? ! One xDSL Router ! One 9VDC or 12VDC Adaptor, depend on different model ! One RJ-11 Telephone Cable ! One 10Base-T Ethernet straight-through Cable ! One 9-pin to 9-pin RS-232 Cable (option) ! One User’s Guide All packages have been checked carefully for their completeness and functionality before shipped. Please contact the place of purchase if any of the above listed items are missing or damaged. If you encountered any difficulty
Streszczenie treści zawartej na stronie nr. 10
Heritage Series ADSL Bridge/ Router Introduction 1-5 1.4 Important Rules for Safe Operation In addition to the careful attention devoted to quality standards on the manufacture of your ADSL Router, safety is a major factor in the design of every product. However, safety is your responsibility, too. This section lists important information that will help assure your enjoyment and proper use of the ADSL Router and accessory equipment. Please read them carefully before operation and us
Streszczenie treści zawartej na stronie nr. 11
Introduction 1-6 heat source (including amplifiers). Do not place this product in a built-in installation, such as a bookcase or equipment rack, unless you provide proper ventilation. ! Do Not Use Accessories – Do not use attachments, unless they are recommended by your vendor, as they may cause electrical or fire hazards. ! Use the Recommended Power Adaptor – You must use the Power Adaptor that comes with your ADSL Router. ! Do Not Use Near Water – Do not use this product near water.
Streszczenie treści zawartej na stronie nr. 12
Heritage Series ADSL Bridge/ Router Introduction 1-7 ! Refer Servicing to Qualified Service Personnel Under the Conditions Listed Below. # When the power supply cord or plug is damaged. # If liquid has been spilled or objects have fallen into the product. # If the product has been exposed to rain or water. # If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions. # If the product has
Streszczenie treści zawartej na stronie nr. 13
Introduction 1-8 1.5 Front Panel The xDSL Router has five status LEDs for diagnostics. You can monitor the LEDs during operation. Following table shows the xDSL Router status LEDs and identifies what each LED light means. Function Behavior Definition POWER Dark Power off Light Power on xDSL Flashing slowly xDSL training in progress Light xDSL link is establish and ready to transfer data PC Dark Ethernet link absent or power off Light Ethernet link present RX Flashing Receivi
Streszczenie treści zawartej na stronie nr. 14
Heritage Series ADSL Bridge/ Router Introduction 1-9 1.6 Rear Panel The rear panel of the xDSL Router consist of power jack, Console Port connector, Ethernet connect and xDSL link jack which they means as below: Function Definition xDSL xDSL jack connect to DSL line from TelCo. 10Base-T or Ethernet interface connect to PC or HUB for 10/100Base-T LAN. Console This is RS232C interface and use to management xDSL Router. DC 9V or The power jack connects to Adaptor from wall DC12
Streszczenie treści zawartej na stronie nr. 15
Introduction 1-10
Streszczenie treści zawartej na stronie nr. 16
Heritage Series ADSL Bridge/ Router Installing and Configuring your xDSL Router 2-1 Chapter 2 Installing and Configuring your xDSL Router The major functions of the xDSL Router are performed by using Ethernet 10Base-T or 10/100Base-T network interface. Your computer has to install an Ethernet NIC card and set up the TCP/IP protocol before start to using the xDSL Router. The xDSL Router also provides a serial console port for monitoring and configuring the Router via t
Streszczenie treści zawartej na stronie nr. 17
Installing and Configuring your xDSL Router 2-2 2.1 Preparation for Hardware and software installation Before start the hardware installation. Please prepare all the materials listed below regarding to your application. 1. Connect to a computer directly ! xDSL service provider or ISP/NSP service contract. Please sign an appropriate Internet connection contract with a reliable ISP/NSP and get necessary connection information that will help you configuring your Router. ! Personal c
Streszczenie treści zawartej na stronie nr. 18
Heritage Series ADSL Bridge/ Router Installing and Configuring your xDSL Router 2-3 2. Connect to more than one computer Excepts the items listed on step 1 above, you still need following items: ! Additional PC with OS that support Ethernet interface. ! Additional Ethernet card for each PC you want to connect ! Additional Ethernet Straight-through cable for each PC you want to connect. ! One Ethernet Hub is required for more than one computer connection. ! If your up-link hub wit
Streszczenie treści zawartej na stronie nr. 19
Installing and Configuring your xDSL Router 2-4 2.2 Hardware Installation Before start to configure your Router, you have to complete all the hardware installation. The following steps provide instructions for installing your Router. 1. Be sure the power switch on the right side of the Router is at the OFF status. 2. Connect the power adaptor to the power jack that marked Power at the rear panel of the Router, then plug in the DC power adaptor to the wall electrical outlet. 3. Co
Streszczenie treści zawartej na stronie nr. 20
Heritage Series ADSL Bridge/ Router Installing and Configuring your xDSL Router 2-5 2.3 Windows 95/98 setting for Ethernet LAN connection Either connect to Internet or configure the Router via Ethernet, the TCP/IP protocol is really necessary. And your computer must be on the same subnet with the Router. When you directly connect the Router to your computer through the Ethernet network, you will first configure your computer to obtain an IP address automatically from your Router
