Instrukcja obsługi Minolta MAGICOLOR 6100

Streszczenie treści zawartej na stronie nr. 1

®





 


 
  





Streszczenie treści zawartej na stronie nr. 2

   Crown, magicolor, the MINOLTA-QMS logo, and the Crown-II logo are registered trademarks of MINOLTA- QMS, Inc., registered in the United States Patent and Trademark Office.        The digitally encoded software included with your Print System is Copyrighted © 2000 by MINOLTA-QMS, Inc. All Rights Reserved. This software may not be reproduced, modified, displayed, transferred, or copied in any form or in any manner or on any media, in whole or in part, without the expres

Streszczenie treści zawartej na stronie nr. 3

 
  This kit includes all the hardware necessary to convert a magicolor 6100 DeskLaser to a magicolor 6100 Crown Print System. MINOLTA-QMS Crown is a proprietary, multitasking printer operating system, which allows MINOLTA-QMS to adapt advanced printer software to the evolving printing needs of users in many different environments. Crown provides true multitasking capabilities, Emulation Sensing Processor (ESP) technology, simultaneous interface operation (SIO), compil

Streszczenie treści zawartej na stronie nr. 4

     Converting your magicolor 6100 DeskLaser printer to a magicolor 6100 Crown Print System involves two steps: 1 Replacing the controller board. 2 Applying the new product labels. ▲ Caution: It’s very important to protect the printer controller board from electrostatic damage while performing this conversion. If you have an anti-static wrist strap, attach one end of it to your wrist and the other end to any convenient electrical ground. The bare metal

Streszczenie treści zawartej na stronie nr. 5

   2 Remove the controller board from the printer. Loosen two screws, one on each end of the I/O connector panel, and, using the tab on the lower side of the connector panel, pull the controller board from the printer. 3 Position the controller board on a flat surface so the controller board lies flat and the I/O connector panel is facing you. 4 Remove the new controller board from its packaging. 5 Carefully remove the RAM DIMMs from the old controller board. a Using both t

Streszczenie treści zawartej na stronie nr. 6

................................................ ........................ .......... ................................................ ........................ .......... ................................................ ........................ .......... ................................................ ........................ .......... IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIII ................

Streszczenie treści zawartej na stronie nr. 7

   13 Check the startup page. After the printer warms up, a startup page similar to the one shown below prints. The startup page indicates that the printer has successfully been converted from a magicolor 6100 DeskLaser to a magicolor 6100 Crown Print System. Verify that the memory and options that were installed are correctly identified on the startup page.  
          

Streszczenie treści zawartej na stronie nr. 8

     Remove existing labels and apply the magicolor 6100 logo and the dataplate label to the printer as shown in the following diagram:         

 

Streszczenie treści zawartej na stronie nr. 9

 
!  """ 
  If you have any questions or problems during the conversion, refer to appendix A, “Customer Support,” in your new magicolor 6100 Print System documentation to find out how to contact MINOLTA-QMS.       !  " # magicolor If you haven’t already done so, install the 6100 Print System printer driver. Software Utilities The printer driver is located on the magicolor 6100 CD-ROM. See Connecting

Streszczenie treści zawartej na stronie nr. 10