Streszczenie treści zawartej na stronie nr. 1
USER’S GUIDE
BOXLIGHT CP-15t
BOXLIGHT
®
Streszczenie treści zawartej na stronie nr. 2
INFORMATION TO THE USER NOTE : This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio comm
Streszczenie treści zawartej na stronie nr. 3
IMPORTANT SAFETY INSTRUCTIONS All the safety and operating instructions should be read before d. If the projector does not operate normally by following the the product is operated. operating instructions. Adjust only those controls that are covered by the operating instructions as improper Read all of the instructions given here and retain them for adjustment of other controls may result in damage and will later use. Unplug this projector from AC power supply before often require extensive wo
Streszczenie treści zawartej na stronie nr. 4
TABLE OF CONTENTS FEATURES AND DESIGN 5 COMPUTER MODE 25 SELECTING COMPUTER MODE 25 SELECTING COMPUTER SYSTEM 25 PC ADJUSTMENT 26 PREPARATION 6 COMPATIBLE COMPUTER SPECIFICATIONS 27 PICTURE IMAGE ADJUSTMENT 28 NAME OF EACH PART OF THE PROJECTOR 6 PICTURE POSITION ADJUSTMENT 30 SETTING UP THE PROJECTOR 7 PICTURE SCREEN ADJUSTMENT 30 CONNECTING THE AC POWER CORD 8 VENTILATION 8 MOVING THE PROJECTOR 9 VIDEO MODE 31 SELECTING VIDEO MODE 31 SELECTING COLOR SYSTEM 31 CONNECTING THE PROJECTOR 10 PICTUR
Streszczenie treści zawartej na stronie nr. 5
FEATURES AND DESIGN This Multimedia Projector is designed with the most u PC CARD SLOT advanced technology for portability, durability, and This projector has a PC CARD SLOT for easier ease of use. The projector utilizes built-in multimedia presentation. Pictures can be projected just by features, a palette of 16.77 million colors, and matrix inserting a memory card including image data. The liquid crystal display (LCD) technology. presentation data can be edited by the software "Media Card
Streszczenie treści zawartej na stronie nr. 6
PREPARATION NAME OF EACH PART OF THE PROJECTOR FRONT OF THE CABINET PROJECTION LENS INFRARED REMOTE RECEIVER SPEAKER (Monaural) LENS COVER BACK OF THE CABINET EXHAUST VENT HOT AIR EXHAUSTED ! Air blown from the exhaust vent is hot. When using or installing the projector, following attention should be taken. l Do not put a flammable object near this part. Keep heat-sensitive objects away from the exhaust vent. l Do not touch this part especially the screws and metallic parts. This part PC CAR
Streszczenie treści zawartej na stronie nr. 7
PREPARATION SETTING-UP THE PROJECTOR Positioning the Projector l This projector is basically designed to project on a flat projection surface. l The projector can be focused from 4.6'(1.4m) ~ 35.4'(10.8m). l Refer to the figure below to adjust the screen size. 35.4' (10.8m) 300" 24.0' (7.3m) (762cm) 18.0' (5.5m) 200" (508cm) 11.8' (3.6m) 150" 230" (381cm) (584.2cm) 100" 4.6' (1.4m) H1 (254cm) 154" 40" (391.2cm) 115" (101.6cm) (292.1cm) 77" (195.6cm) H2 30" (76.2cm) 30” 60” 100” 150” 200” 300” Sc
Streszczenie treści zawartej na stronie nr. 8
PREPARATION CONNECTING THE AC POWER CORD This projector uses nominal input voltages of 100-120 V AC 200-240 V AC. The projector automatically selects the correct input voltage. It is designed to work with single-phase power systems having a grounded neutral conductor. To reduce the risk of electrical shock, do not plug into any other type of power system. Consult your authorized dealer or service station if your are not sure of the type of power supply being in use. Connect the projector with
Streszczenie treści zawartej na stronie nr. 9
PREPARATION Moving the Projector Use the Carry Handle when moving the Projector. l Replace the lens cover and rotate the feet fully clockwise (to shorten the feet) when moving the projector to prevent damage to the cabinet. NOTE The carrying bag (supplied) is intended for protection from dust and scratches on the surface of the cabinet, and it is not designed to protect the LCD projector from external shock. Do not drop the projector, subject it to strong forces, or put other things on the cabin
Streszczenie treści zawartej na stronie nr. 10
CONNECTING THE PROJECTOR TERMINALS OF THE PROJECTOR COMPUTER INPUT TERMINAL MONITOR OUTPUT TERMINAL Connect the computer output Connect the monitor to this to this terminal. terminal to view the image on (Refer to P12 ~15.) the monitor. (Refer to P12 ~15.) CONTROL PORT CONNECTOR MCI SERIAL TERMINAL MONITOR OUT When controlling the computer COMPUTER IN This terminal is used to with the Remote Control of this connect a computer to edit projector, connect the mouse (write and read) the data of PC
Streszczenie treści zawartej na stronie nr. 11
CONNECTING THE PROJECTOR CONNECTING TO THE VIDEO EQUIPMENT Satellite Video Cassette Recorder Video Disc Player TV Tuner Video / Audio Output S-VIDEO Output Use Cables and Adapter indicated below. Use either the VIDEO jack or · VIDEO CABLE (not supplied) S-VIDEO jack. When both · S-VIDEO CABLE (not supplied) jacks are connected, the S- · AUDIO CABLE (not supplied) VIDEO jack has priority over the VIDEO jack. Video Audio Cable S-VIDEO Cable (Not supplied) (Not supplied) Terminals of the Projecto
Streszczenie treści zawartej na stronie nr. 12
CONNECTING THE PROJECTOR CONNECTING TO THE IBM-COMPATIBLE COMPUTER To connect with the IBM-compatible computer, refer to the figure below. Use Cables and Adapter indicated below. · VGA CABLE (supplied) · MOUSE CABLE FOR PS/2 PORT or SERIAL PORT (supplied) · MCI SERIAL CABLE (supplied) · MONITOR CABLE (not supplied) · AUDIO CABLE (stereo /not supplied) u Be sure to connect the MOUSE CABLE corresponding with the mouse terminal on your computer. NOTE : When connecting the cable, the power cords of
Streszczenie treści zawartej na stronie nr. 13
CONNECTING THE PROJECTOR MONITOR OUT COMPUTER IN CONTROL PORT MCI SERIAL AUDIO IN AUDIO OUT S-VIDEO R-AUDIO-L VIDEO (MONO) MONITOR OUT AUDIO IN AUDIO OUT CONTROL PORT A MCI SERIAL B COMPUTER IN To disconnect MOUSE CABLE, 1. Hold the portion (B) of the connector with one hand. 2. Pull the portion (A) to the arrow direction and remove connector. Use either of these Mouse Cables corresponding with your terminal of your computer. 13
Streszczenie treści zawartej na stronie nr. 14
CONNECTING THE PROJECTOR CONNECTION TO THE MACINTOSH COMPUTER To connect with the Macintosh computer, refer to the figure below. Use Cables and Adapter indicated below. · VGA CABLE (supplied) · VGA/MAC ADAPTER (supplied) · MOUSE CABLE FOR ADB PORT (supplied) · MONITOR CABLE (not supplied) · PC AUDIO CABLE (stereo / not supplied) NOTE : When connecting the cable, the power cords of both the projector and the external equipment should be disconnected from the AC outlet. Turn the projector and per
Streszczenie treści zawartej na stronie nr. 15
CONNECTING THE PROJECTOR u MAC/VGA ADAPTER Set the switches as shown in the table below depending on the RESOLUTION MODE that you want to use before your turn on the projector and computer. ON 12 3 4 5 6 ON DIP 2 4 6 1 3 5 13" MODE (640 x 480) ON ON OFF OFF OFF OFF 16" MODE (832 x 624) OFF ON OFF ON OFF OFF OFF 19" MODE (1024 x 768) OFF ON ON OFF OFF OFF 21" MODE (1152 x 870) ON ON ON ON OFF OFF MONITOR OUT COMPUTER IN CONTROL PORT MCI SERIAL AUDIO IN AUDIO OUT S-VIDEO R-AUDIO-L VIDEO (MONO) MON
Streszczenie treści zawartej na stronie nr. 16
FREEZE/ NO SHOW ON-OFF NORMAL LASER PAGE FOCUS MENU BEFORE OPERATION OPERATION OF THE REMOTE CONTROL This remote control unit is not only able to operate the projector but also usable as a wireless mouse for a PC. The POINT button and two CLICK buttons are used for wireless mouse operation. (Refer to page 41.) The Wireless mouse is usable when PC mouse pointer is displayed on the screen. The wireless mouse cannot be used when the On-Screen Menu is displayed. VIDEO BUTTON ZOOM BUTTON Used to sel
Streszczenie treści zawartej na stronie nr. 17
BEFORE OPERATION Remote Control Batteries Installation Remove the battery Slide the batteries into Replace the compartment 1 2 3 compartment lid. the compartment. lid. Press the lid downward and slide it. Slide the lid upward. For correct polarity (+ and –), be sure the battery terminals are in contact with the pins in the compartment. To insure safe operation, please observe the following precautions : l Use (2) AA type alkaline batteries. l Replace two batteries at the same time. l Do not use
Streszczenie treści zawartej na stronie nr. 18
BEFORE OPERATION TOP CONTROLS AND INDICATORS LAMP REPLACE INDICATOR WARNING TEMP. INDICATOR This indicator turns to yellow This indicator flashes red READY INDICATOR LAMP INDICATOR when the life of the projection when internal projector This indicator lights in green lamp draws to an end. temperature is too high. This indicator is lit in dimly lit when the projector is ready to (Refer to P43.) (Refer to P42.) when the projector is turned be turned on. on. And the light is brightly lit when the
Streszczenie treści zawartej na stronie nr. 19
BEFORE OPERATION OPERATING ON-SCREEN MENU HOW TO OPERATE ON-SCREEN MENU You can control and adjust this projector through ON- WIRELESS REMOTE CONTROL SCREEN MENU. Refer to the following pages to operate the each adjustment on the ON-SCREEN MENU. POINT BUTTON Used to move the Pointer to UP/ DOWN/ 1 MOVING THE POINTER RIGHT/ LEFT. Move the pointer (see the NOTE below) by pressing POINT button(S) on the TOP CONTROL or the REMOTE CONTROL. SELECT BUTTON Used to select the item. 2 SELECT THE ITEM T
Streszczenie treści zawartej na stronie nr. 20
BEFORE OPERATION MENU BAR MENU BAR IN COMPUTER MODE Press MENU BUTTON while being in Computer mode. MODE MENU AUTO IMAGE MENU PC ADJUST MENU SETTING MENU LANGUAGE MENU Used to set the Display Used to select Used to adjust Fine Used to adjust the Used to select Menu and to reset sync., Total dots, parameters to the language the Computer Lamp Replacement and Picture Position match with the input used in the Menu. input mode. Monitor Timer. automatically. signal format. (Refer to P40) (Refer to P2
