Streszczenie treści zawartej na stronie nr. 1
Copyright © 2001 by BOXLIGHt
Poulsbo, Washington. All rights reserved.
Streszczenie treści zawartej na stronie nr. 2
FCC Warning This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communi- cation
Streszczenie treści zawartej na stronie nr. 3
Declaration of Conformity Manufacturer: BOXLIGHT 19332 Powder Hill Place, Poulsbo, Washington, USA We declare under our sole responsibility that the XD-10m projector conforms to the following directives and norms: Directive 89/336/EEC, Amended by 93/68/EEC EMC: EN 55022 EN 55024 EN 61000-3-2 EN 61000-3-3 Directive 73/23/EEC, Amended by 93/68/EEC Safety: EN 60950: 1992 + A1 + A2 + A3 + A4: 1997 March, 2001 Trademarks Apple, Macintosh, and PowerBook are trademarks or registered tra
Streszczenie treści zawartej na stronie nr. 4
Streszczenie treści zawartej na stronie nr. 5
TABLE OF CONTENTS Safety Instructions iii Introduction 1 Image Resolution 1 Compatibility 1 Unpacking the Projector 1 Usage Guidelines 3 If You Need Assistance 4 Warranty 4 Setting up the Projector 5 Connecting a Computer 7 Connecting a Video Player 8 Powering up the Projector and Adjusting the Image 9 Turning Off the Projector 9 Using the Projector 11 Basic Image Adjustment 11 Adjusting the Projector 11 Using the Remote Control 13 Using the Keypad and Remote Buttons 14 Using the On-Screen Menus
Streszczenie treści zawartej na stronie nr. 6
Ta b l e o f C o n t e n t s Appendix 35 Specifications 35 Accessories 36 Portable and Laptop Activation Chart 38 Using Video Mirroring with a PowerBook Computer 43 Projected Image Size 44 Index 45 ii
Streszczenie treści zawartej na stronie nr. 7
SAFETY INSTRUCTIONS Please read and follow all safety instructions provided BEFORE using your new projector. Failure to comply with safety instruc- tions may result in fire, electrical shock, or personal injury and may damage or impair protection provided by equipment. Please save all safety instructions. Safety Definitions: Warning: Statements identify conditions or practices that could result in personal injury. Caution: Statements identify conditions or practices that could result in
Streszczenie treści zawartej na stronie nr. 8
S a f e ty In st ru ct ion s Caution: Don’t set liquids on the projector. Spilled liquids may damage your projector. Caution: Don’t place the projector on a hot surface or in direct sunlight. Caution: Do not drop the projector. Transport the projector in a BOXLIGHT-approved case; see page 37 for a list of cases. Important Operating Considerations Do not place the projector on a tablecloth or other soft covering that may block the vents. In the unlikely event of the bulb ruptur- ing, th
Streszczenie treści zawartej na stronie nr. 9
INTRODUCTION ® The BOXLIGHT XD-10m™ digital projector is specifically designed for the mobile presenter. It generates crisp, clear images using Digital Light Processing™ (DLP) technology, and features an M1-DA type DVI connector for easy, built-in digital/analog and USB connectivity. It is easy to connect, easy to use, easy to transport, and easy to maintain. Image Resolution The XGA resolution of the XD-10m’s projected image is 1024x768. The projector is compatible with screen resolution
Streszczenie treści zawartej na stronie nr. 10
In tr o d uc ti on 2 1 3 4 5 6 7 8 FIGURE 1 Shipping box contents 1. XD-10m digital projector + 5. Remote control lens cap 2. Soft carry case 6. Analog computer cable 3. User’s Guide and Quick Start 7. Composite video cable card 4. Power cord 8. S-video cable 2 menu/select forward backward data keystone video
Streszczenie treści zawartej na stronie nr. 11
focus ring zoom ring computer and video connectors keypad power switch power security lock cord connector FIGURE 2 Side view of projector Usage Guidelines Do not look directly into the projection lens when the projector is turned on. The bright light may harm your eyes. Do not block the grills on the projector. Restricting the air flow can cause it to overheat and turn off. If this happens, you must wait a minute before attempting to turn it back on. Handle the projector as you would an
Streszczenie treści zawartej na stronie nr. 12
In tr o d uc ti on If You Need Assistance The first place to look for help is in this manual. Be sure to check the guidelines in “Troubleshooting” on page 32. If this manual doesn’t answer your question, call BOXLIGHT at 1-800-762-5757 or 360-779-7901. Warranty This product is backed by a limited two-year warranty. The details of the warranty are printed at the back of this manual. 4
Streszczenie treści zawartej na stronie nr. 13
11.8 ft/3.6m. 7.1 ft. 2.2m / 3.0 ft/.9m. SETTING UP THE PROJECTOR 1 Place the projector on a flat surface. The projector must be within 10 feet (3 m) of your power source and within 6 feet (1.8 m) of your computer. If you want to project from behind a translucent screen, set up the projector behind your screen. See “Rear Projection” on page 23 to reverse the image. 2 Position the projector the desired distance from the screen. If the image is too big or too small, use the zoom ring to
Streszczenie treści zawartej na stronie nr. 14
S e tti ng up t h e Pr oj ec to r NOTE: Before you continue, video computer make sure the projector and all other equipment is turned off. If you’re connecting a computer, make sure the distance between it and the projector is 6 feet or less. power switch power cord FIGURE 4 Connector panel to computer video to USB mouse to projector to computer FIGURE 5 Computer cable NOTE: If you are connecting an older Macintosh computer that does not have a 15-pin connector, you must use a Mac adaptor betwe
Streszczenie treści zawartej na stronie nr. 15
Connecting a Computer The projector ships with an analog computer cable. If your com- puter has a digital output, you can order the optional digital com- puter cable. Using a digital source generates the highest quality and brightest image possible. See “Optional Accessories” on page 37. 1 Plug the end of the computer cable with one cable into the connector on the projector. Plug the blue end of the computer cable into the video connec- 2 tor on your computer. NOTE: Many laptop computers 3 I
Streszczenie treści zawartej na stronie nr. 16
S e tti ng up t h e Pr oj ec to r Connecting a Video Player If your video player uses a round, one-prong composite video connector, use the composite video cable. If your video player uses a round, four-prong S-video connector, use the S-video cable. S-video generates a higher quality image. Plug the composite video cable’s round yellow connector into 1 the “video-out” connector on your video player (Figure 7). NOTE: HDTV sources must be This connector may be labeled “To Monitor.” connected
Streszczenie treści zawartej na stronie nr. 17
Powering up the Projector and Adjusting the Image 1 Remove the lens cap. NOTE: Always use the power cord Plug the power cord into the back of the projector, then plug it 2 into your electrical outlet. A surge-protected power strip is that shipped with the projector. recommended. Press the Power switch on the back of the projector. 3 The fans start to run, the LED on the top of the projector (Figure 11 on page 14) lights green, and the startup screen NOTE: The first time you connect appear
Streszczenie treści zawartej na stronie nr. 18
S e tti ng up t h e Pr oj ec to r 10
Streszczenie treści zawartej na stronie nr. 19
USING THE PROJECTOR This section describes how to use and make adjustments to the projector. It also provides a reference to the keypad and remote buttons and the options available from the on-screen menus. Basic Image Adjustment 1 Make sure you have powered up your equipment in the right order (page 9). 2 If the image doesn’t display completely, zoom the image (page 11), adjust the height of the projector (page 12) or center the image by adjusting its horizontal or vertical position (page
Streszczenie treści zawartej na stronie nr. 20
Us in g th e P r o j ect o r The projector is equipped with a self-locking, quick-release eleva- tor foot and button. To raise the projector: 1 Press and hold the elevator button (Figure 9). 2 Raise the projector to the height you want, then release the button to lock the elevator foot into position. elevator button (under finger) elevator foot FIGURE 9 Adjusting the height of the projector 12
