Streszczenie treści zawartej na stronie nr. 1
LED Projector
MODEL
PK20
User Manual
This User Manual is important to you.
Please read it before using your projector.
EN-1
Streszczenie treści zawartej na stronie nr. 2
EN-2
Streszczenie treści zawartej na stronie nr. 3
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION: TO PREVENT ELECTRIC SHOCK, DO NOT USE THIS AC ADAPTER’S PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET. NOTE: WHEN USING THE AC ADAPTER, THE SOCKET-OUTLET SHALL BE INSTALLED NEAR THE EQUIPMENT AND The lightning flash with arrowhead symbol within SHALL BE EASILY ACCESSIBLE. an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within th
Streszczenie treści zawartej na stronie nr. 4
Your MITSUBISHI ELECTRIC product WARNING is designed and manufactured with high Only use the attached specified AC adapter and power quality materials and components which cord. If you use another AC adapter and power cord, it can be recycled and reused. may cause interference with radio and television reception This symbol means that electrical and or damage your projector. electronic equipment, at their end-of- The attached AC adapter and power cord are to be used Note: This symbol life, shoul
Streszczenie treści zawartej na stronie nr. 5
Declaration of Conformity Contents Model Number : PK20 Important safeguards......................................................6 Trade Name : MITSUBISHI ELECTRIC Responsible party : Mitsubishi Digital Electronics Overview..........................................................................10 America, Inc. Power supply...................................................................11 9351 Jeronimo Road, Irvine, CA Remote control...........................................................
Streszczenie treści zawartej na stronie nr. 6
Important safeguards 8. Accessories Do not place this projector on an unstable cart, stand, Please read all these instructions regarding your projector tripod, bracket or table. Use only with a cart, stand, and retain them for future reference. Follow all warnings tripod bracket, or table recommended by the and instructions marked on the projector. manufacturer or sold with the projector. Any mounting of the appliance should follow the manufacturer’s 1. Read instructions instructions and should
Streszczenie treści zawartej na stronie nr. 7
11. Power-cord protection (d)If the projector does not operate normally after Power-supply cord should be routed so that it is not you follow the operating instructions. Adjust only likely to be walked on or pinched by items placed upon those controls that are covered by the operating or against it. Pay particular attention to cord at plug, instructions. An improper adjustment of other convenience receptacles, and points where it exit from controls may result in damage and may often the applianc
Streszczenie treści zawartej na stronie nr. 8
WARNING: Do not place the projector on uneven surface. Unplug the power cord or remove the battery immediately Place the projector on a level and stable surface only. if there is something wrong with your projector. Do not look into the lens when the projector is Do not operate if smoke, strange noise or odor comes out operating. of your projector, adaptor or battery. It may cause fire or It may hurt your eyes. Never let children look into the lens electric shock. In this case, unplug immediatel
Streszczenie treści zawartej na stronie nr. 9
Do not use flammable solvents (benzene, thinner, etc.) and flammable aerosols near the projector. COMPLIANCE NOTICE OF FCC Flammable substances may ignite causing fire or This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of breakdown because the temperature inside the projec- the FCC Rules. These limits are designed to provide tor rises very high while the lamp is illuminating. reasonable protection against harmful interference i
Streszczenie treści zawartej na stronie nr. 10
VIDEO AUTO POSITION COMPUTER Control panel 1 2 3 1 LAMP indicator Overview 2 POWER indicator 3 CHARGE indicator 4 Four directional buttons 2 AUTO POSITION keys have also the 1 4 following function: COMPUTER VIDEO : AUTO POSITION button : VIDEO button 7 6 5 : COMPUTER button or VIEWER button 5 ENTER button 6 POWER button 3 4 5 6 7 MENU button 1 2 3 Terminal board 1 Focus ring 1 S-VIDEO terminal 2 Control panel 2 VIDEO terminal 3 Terminal cover 3 COMPUTER IN terminal 4 Terminal
Streszczenie treści zawartej na stronie nr. 11
Using the optional battery Power supply The projector must be used with specified Lithium-ion Using the provided AC adapter or an optional Lithium-ion rechargeable battery (BT-PK20R). Charge the battery rechargeable battery . before using the projector for the first time use. You may Warning: also use the projector when charging the battery. The projector must be used with the provided AC adapter. Damage caused by the use of an incorrect About the battery wear adapter is not covered under the wa
Streszczenie treści zawartej na stronie nr. 12
AUTO POSITION COMPUTER VIDEO 3. Match the battery carefully until it fits in place. For battery charging 1. Move the battery latch to the open side. Be sure to remove the adjustable rubber foot before attaching the battery pack. Keep the adjustable rubber foot in a safe place. 4 (such as the carrying bag) 6 5 4. Insert the plug from the AC adapter into the DC IN terminal. 5. Insert the appropriate end of the power cord into the AC adapter. 6. Insert the plug on the power cord into a wall outle
Streszczenie treści zawartej na stronie nr. 13
Indicator When you use the battery, please observe the following Condition LAMP (Green) POWER (Red) safety precautions: Stand-by. Off On Warning: When the lamp is on. On Off Dispose of used batteries according to your local When the projector is off, the charger works as regulations. a fast charging mode. It takes approximately 4 Please do not put battery into fire or heat, otherwise it hours to complete charging. may cause heating, fire, rupture or explosion. W
Streszczenie treści zawartej na stronie nr. 14
For the first time use: Remote control Catch Remove the transparent insulation tape by pulling it Battery holder 1 Power button 1 before use. 2 Four directional buttons 2 3 Enter button 3 For battery change: 4 Menu button 14 4 5 Volume buttton 1. Push the catch to the right 5 13 6 Keystone button 6 and remove the battery 12 7 7 Hi-Bright button holder. 11 8 Computer button 8 10 2. Remove the old Lithium 9 Video button 9 coin cell and install new 10 Viewer button one (CR2025). Ensure 11
Streszczenie treści zawartej na stronie nr. 15
Approx. 5m Operating Range Remote Control Precautions The infrared signal operates by line-of-sight up to a Handle the remote control carefully. distance of approximately 16.4 feet (5 m) and within a 30- Do not use the remote control if it got wet. Remove the degree angle of the remote sensor. The projector will not battery immediately. Make sure the remote control function if there are objects between the remote control and battery are dry before use. and the remote sensor on the projector or i
Streszczenie treści zawartej na stronie nr. 16
Screen Projection Installation A (cm) B (cm) C, D (cm) Size Distance H (inch) L (cm) Layout of the projector 12 38 5 13 12 Image size varies depending on the distance between the 15 48 6 17 15 screen and the projector. 25 83 10 28 25 40 134 16 45 41 60 203 25 67 61 Front projection The above figures are approximate and may be slightly different from the actual measurements. W Caution: C D Do not place the projector on a carpet or any flammable materials. It may cause damage or fire. Place the pr
Streszczenie treści zawartej na stronie nr. 17
Using the tripod Mount the projector onto a tripod as shown in the illustration. Important: After attaching the tripod plate onto the projector, be sure that the adjustable rubber foot is properly tighten. Do not place the tripod on inclined or unstable surfaces. This might cause the projector to fall or tilt over, causing injury and damage to the projector. Before you move the projector, detached the projector and tripod. Do not use excessive force when handling the projector. This might caus
Streszczenie treści zawartej na stronie nr. 18
Basic connections Projector + AV device This projector can be connected with various devices such as a VCR, video camera, videodisc player, or personal computer that have analog RGB output VIDEO IN connectors. S-VIDEO IN Important: Make sure that the connected device is turned off AUDIO IN before starting connection. Plug in the AC adapter of the projector and the AUDIO OUT connected devices firmly. When unplugging, hold and pull the plug. Do not pull the cord. to Audio output When the projector
Streszczenie treści zawartej na stronie nr. 19
Projector + DVD player or HDTV Projector + Computer For computer with D-SUB Some DVD players have an output connector for 3-line fitting (Y, CB, CR). When connecting such DVD player with COMPUTER IN this projector, use the COMPUTER IN terminal. AUDIO IN COMPUTER IN AUDIO OUT AUDIO IN to Audio output AUDIO OUT to monitor port Desktop type Laptop type to Audio output Important: When you use a longer RGB cable instead of the common length cable, the image may not be projected DVD Player or HDTV de
Streszczenie treści zawartej na stronie nr. 20
Caution: Preparation Plug in the power cord firmly. When unplugging, hold and pull the power plug, not the power cord. Preparation for projection 1. Attach the provided AC adapter to the projector. Do not plug in or out the power cord with your hand wet. It may cause electric shock. 2. Plug the AC adapter in the wall outlet. The POWER indicator lights red when using the Important: AC adapter. Install the screen on a flat wall at 90 degrees to the floor. Images may not be projected in a shape of
